Manual Sartorius 2250
Manual Sartorius 2250
2250
Installation 3
Checking 9
Taring 12
Weighing, regular 15
2
Installation
3
Make Sure that balance is set for correct operating
voltage. lf necessary, change setting before connecting
balance to line.
Remove stopper.
4
Loosen screw of transport arrestment
with attached screw-driver .
5
Focus scale image on screen.
Turn tare knob to stop, then go back approx. 1/2 scale division.
6
Adjust zero point.
7
Model 2255: Put down draft shield.
8
Checking
9
Model 2256 can be checked with 1 kg weight only
(available on request).
10
Models 2251/53/56: Loosen screws (fig. a) and clamps on
the rear panel. Pull off knobs and take off the casing.
11
Taring
For taring, any value within the scale range can be tared to
zero.
12
Model 2256: An additional approx.2 kg tare weight can be
removed from below the pan.
13
Weighing to pre-set value
14
Weighing, regular
15
Weighing below the balance
16
Digital Precision balances 2250 2251 2253 2254 2255
17
Sartorius AG
B 37070 Gttingen
P Weender Landstrae 94108, 37075 Gttingen
T (0551) 308-0, F (0551) 308-3289
Internet: http://www.sartorius.com
Copyright by Sartorius AG, Gttingen, Deutschland.