H12 211
H12 211
H12 211
√ ×
Correct answer:
√
2.True or False
A Trunk port always sends tagged frames to the peer equipment.
√ ×
Correct answer:
×
3.True or False
Root bridges provide root ports and designated ports.
√ ×
Correct answer:
×
√ ×
Correct answer:
×
5.True or False
The ICMP protocol (RFC792) is not applied to Application Layer but Network
Layer.
√ ×
Correct answer:
√
6.True or False
In broadcast network of OSPF protocol, any two DR Others will neither exchange
routing information nor send Hello packet to each other due to the existence of DR.
√ ×
Correct answer:
×
7.True or False
Each router forwards only the packets received by the local station through the
optimal path. The packet is forwarded by different routers on the path in a relay
mode.
√ ×
Correct answer:
√
8.True or False
RTA connects with RTB through interface Serial0. The configuration on RTA is as
follow:
[RTA]aaa
[RTA-aaa]local-user huawei password cipher hello
[RTA-aaa]local-user huawei service-type ppp
[RTA]interface Serial 0
[RTA-Serial0]link-protocol ppp
[RTA-Serial0]ppp authentication-mode chap
[RTA-Serial0]ip address 10.1.1.1 30
The configuration on RTB is as follow:
[RTB]interface Serial 0
[RTB-Serial0]link-protocol ppp
[RTB-Serial0]ppp chap user huawei
[RTB-Serial0]ppp chap password cipher hello
[RTB-Serial0]ip address 10.1.1.2 30
With the configuration above, RTA and RTB are able to communicate with each
other.
√ ×
Correct answer:
√
9.True or False
If the optimal path to the destination IP address is unavailable after a change occurs
in a network topology, the dynamic routing protocol can make adaptation to this
change and determine another optimal path to the destination IP address.
√ ×
Correct answer:
√
10.True or False
The operation deleting the configuration files saved in the storage devices will
become effective after rebooting the router.
√ ×
Correct answer:
√
11.True or False
After receiving a data frame from any port, a hub forwards it to any other port.
√ ×
Correct answer:
√
12.True or False
When you configure Frame Relay on Quidway routers, you can configure Inverse
ARP instead of static address mapping because the function of Inverse ARP is to
provide dynamic address mapping.
√ ×
13.True or False
Routing Information Protocol (RIP) is available in the RIPv1, RIPv2, and RIPv3
versions.
√ ×
Correct answer:
×
14.True or False
On a port running frame relay, an MAP table corresponds to a logical port. Different
logical ports have different MAP tables.
√ ×
Correct answer:
√
15.True or False
Frame relay point-to-multipoint sub-port can connect “multiple” remote nodes
together through a PVC.
√ ×
Correct answer:
×
QuestionScore:(1.0) Current Score: 1.0
16.True or False
A static route can be either configured manually by a network administrator or
generated automatically.
√ ×
Correct answer:
×
17.True or False
The PPP protocol provides a standard method of transmitting datagrams of different
protocols on a point-to-point link. It is a point-to-point communication protocol
widely used at the present time.
√ ×
Correct answer:
√
18.True or False
The 10.1.1.2 IP address in the returned result of the frame relay command represents
the IP address of the local device.
[RTA]dis fr map-info
Map Statistics for interface Serial0 (DTE)
DLCI = 100, IP INARP 10.1.1.2, Serial0
create time = 2007/06/04 17:34:59, status = ACTIVE
encapsulation = ietf, vlink = 20, broadcast
√ ×
19.True or False
In OSPF protocol, most of the packets are sent by using reserved multicast address
and this can reduce the impact on non-OSPF speaking devices.
√ ×
Correct answer:
√
20.True or False
RTA connects with RTB through interface Serial0. The configuration on RTA is as
follow:
[RTA]aaa
[RTA-aaa]local-user huawei password simple quidway
[RTA-aaa]local-user huawei service-type ppp
[RTA]interface Serial 0
[RTA-Serial0]link-protocol ppp
[RTA-Serial0]ppp authentication-mode pap
[RTA-Serial0]ip address 10.1.1.1 30
The configuration on RTB is as follow:
[RTB]interface Serial 0
[RTB-Serial0]link-protocol ppp
[RTB-Serial0]ppp pap local-user huawei password simple hello
[RTB-Serial0]ip address 10.1.1.2 30
With the configuration above, RTA and RTB are able to communicate with each
other.
√ ×
Correct answer:
×
a.Configuring ABR
b.Configuring ASBR
c.Configuring Virtual-link
Correct answer:
c
22.Single
Which of the following descriptions about PAP and CHAP is correct?
Correct answer:
c
23.Single
Which of the following cost values indicates that the route learned from RIP is
unreachable?
a.8
b.10
c.15
d.16
Correct answer:
d
24.Single
After a change occurs in a network topology, which of the following routes does not
change automatically but changes only after the network administrator updates the
change?
a.RIP route
b.OSPF route
c.BGP route
d.Static route
Correct answer:
d
25.Single
For a class B network, if 5 bits are used for sub-netting, how many hosts are available
in a “single” subnet?
a.510
b.512
c.1022
d.2046
Correct answer:
d
26.Single
Routers are a type of computer equipment for network interconnections. Which layer
of the OSI reference model does a router work at?
a.Session Layer
c.Network Layer
d.Application Layer
Correct answer:
c
27.Single
Which of the following is the feature of IP protocol?
Correct answer:
b
28.Single
The Ethernet standard that is widely used by LAN is defined by ( ).
a.IEEE 802.5
b.IEEE 802.2
c.IEEE 802.3
d.IEEE 802.1
Correct answer:
c
29.Single
Which of the following protocols is transport layer protocol of TFTP?
a.SIP
b.UDP
c.TCP
d.RTP
Correct answer:
b
30.Single
The TTL field in an IP header specifies the number of routers that a datagram is
allowed to traverse. After the datagram traverses a router, the TTL value is deducted
by 1. When the TTL reaches a certain value, the datagram is discarded. Which of the
following represents this value?
a.0
b.1
c.-1
d.2
Correct answer:
a
31.Single
How many bits are used to identify the VLAN id of the data frame?
a.4
b.32
c.12
d.8
Correct answer:
c
32.Single
For a traditional class C network without sub-netting, how many hosts are available
at most?
a.1024
b.65025
c.254
d.48
Correct answer:
c
33.Single
How many bytes does a VLAN tag consist of?
a.2
b.3
c.4
d.5
Answers of examinees:c Correct answer
Correct answer:
c
34.Single
Which of the following values is the update interval for RIP?
a.5s
b.30s
c.60s
d.180s
Correct answer:
b
35.Single
A switch receives entire data frame and then perform CRC checking,the frame is
forwarded unless CRC checking fails. The switch mode for this switch is ?
a.Cut-Through
b.Store-and-Forward
c.Fragment-free
d.Store-free
36.Single
A MAC address consists of 48 bits and is generally expressed in 12-bit dotted
decimal notation. What kind of address does a MAC address consisting of all 1s
stand for?
a.Multicast address
b.Broadcast address
c.Unicast address
d.Virtual address
Correct answer:
b
37.Single
What do we call the routes in the routing table that have the same cost to the same
destination?
a.Equivalent routes
b.Sub-optimal routes
c.Multipath routes
d.Default routes
38.Single
When a node transmits data over a network medium, the data is transmitted to all the
nodes on the network. Which topology does this network use?
a.Star
b.Bus
c.Tree
d.Ring
Correct answer:
b
39.Single
The main idea of STP is to generate a loop-free tree by exchanging a special kind of
message between bridges. This message is called ( ).
a.Configuration BPDU
b.TCN BPDU
c.Hello BPDU
d.Update BPDU
Correct answer:
a
QuestionScore:(2.0) Current Score: 0.0
40.Single
What does the value 1 of cost in the RIP route information mean?
c.Only one hop exists between the router and the destination network segment.
Correct answer:
c
41.Single
Suppose a gateway is configured in a host running Windows system, which of the
following is similar to the configuration on a router?
a.Direct route
b.Default route
c.Dynamic route
d.Host route
Correct answer:
b
QuestionScore:(2.0) Current Score: 2.0
42.Single
In OSI reference model, Transport Layer is located at layer ( ).
a.3
b.4
c.6
d.7
Correct answer:
b
43.Single
The shortest path tree calculated by a router in an OSPF area provides ( ) on the path
from this router to other nodes in the network.
b.Routing table
d.ARP table
Correct answer:
b
44.Single
A VLAN can be considered as a ( ).
a.Collision domain
b.Broadcast domain
c.Management domain
d.Blocking domain
Correct answer:
b
45.Single
Which of the following protocols authenticates a user remotely, authorizes the user
access, and performs charging?
a.SMTP
b.RADIUS
c.DNS
d.HTTP
Correct answer:
b
46.Multiple Choice,
OSPF routers are classified into four types. Which of the following statements about
interior routers (IRs) are true?
a.The ports on an IR belong to a same area.
d.If all the ports on an IR belong to area 0, this IR functions as a backbone router.
Correct answer:
ad
47.Multiple Choice,
Which of the following devices have functions of all seven layers of OSI reference
model?
a.Router
b.Email Server
Correct answer:
bd
48.Multiple Choice,
Which of the following are routed protocols?
a.IP
b.OSPF
c.BGP
d.IPX
Correct answer:
ad
49.Multiple Choice,
Which of the following statements regarding the backbone area in OSPF protocol are
correct?
d.ABR connects to different areas and at least one of the connected area is
backbone area.
Correct answer:
bcd
50.Multiple Choice,
What functions does a router mainly provide?
Correct answer:
acd
51.Multiple Choice,
Which of the following descriptions are correct about VLAN interface?
a.A virtual interface is required to be created for the VLAN if we want to assign
an IP address for that VLAN
b.Two VLAN interfaces on the same switch can be assigned with the same IP
address
Correct answer:
ac
52.Multiple Choice,
Two static routes to the 10.1.1.1/32 network are configured on a router. One of the
static routes is not assigned with a value for the preference_value parameter; the
other static route is assigned with 100 for the preference_value parameter. In this
case, which of the following statements are true?
a.The route not signed with a value for the preference_value parameter functions
as the working route.
b.The route signed with 100 for the preference_value parameter functions as the
working route.
Correct answer:
ac
53.Multiple Choice,
Which of the following are the interface states of STP?
a.Disabled
b.Blocking
c.Shut down
d.Learning
e.Forwarding
Correct answer:
abde
54.Multiple Choice,
Which of the following methods can realize communication between VLANs at
network layer?
a.STP
b.GVRP
c.L2 Switch+Router
d.L3 Switch
Correct answer:
cd
55.Multiple Choice,
What describe the working principles of Ethernet Switches?
b.Generate MAC address table according to the source MAC address of the
received frame
Correct answer:
abd