Plate 21
Plate 21
Plate 21
PLATE No. 2
SEQUENTIAL CIRCUITS
Submitted to
ENGR. RODRIGO S. PANGANTIHON, JR., MIT
Professor in EE 538/L
Submitted by
Charles Edrian B. Perez
Student
I – INTRODUCTION
This plate is about the queuing system by the use of Jk flip flops. It will display
numbers in ascending order. Just like the cashier in UM when we were paying our e
xamination fees it will display the window serving from 1 to 3 and the counter from 0 t
o 99. Its pretty hard because its an trial and error plate we make this overtime cause
its pretty hard but the help of you sir it makes it clear.
II – OBJECTIVES
IV – EXPERIMENTAL PROCEDURES
V – PROBLEM ANALYSIS
The problem was how to make a Sequential Circuit; Queuing system using sw
itching circuits and flip flops. By the power of brainstorming and searching we found
out how to make the plate. This plate is an up counter that counts 0 to 99 with reset
and a window number display. This plate uses jk flip flops with binary outputs. The o
utputs are tied to a decoder IC then the outputs of the decoder IC tied to the inputs of
the 7 segment display.
VI– LOGIC CIRCUIT / DIAGRAM
VII – PHOTOS OF ACTUAL IMPLEMENTATION
VI – CONCLUSION
In light of this laboratory activity, the following conclusions were drawn about
Sequential Circuit; Queuing system:
VII – RECOMMENDATION
1. Make the circuit using other kind of flip-flops and de-bouncing circuit function.
2. Construct the circuit in even spacing so that errors can be detected easily.
3. Construct the circuit by jumping wires from previous equations and not directly
to the Tact Switch.
4. Make the same queuing system with 4 window counters.
5. Make use of other gates like NAND gates or XOR gates.