Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
233 views

EC1

This lab document provides instructions for identifying resistor values using color codes. Students will use color codes to calculate the resistance of various resistors, then measure the actual resistance using a multimeter. They will record their calculated and measured values to check for comparability. The goal is to practice determining resistances from color bands and verifying the values experimentally.

Uploaded by

Umair Fayyaz
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
233 views

EC1

This lab document provides instructions for identifying resistor values using color codes. Students will use color codes to calculate the resistance of various resistors, then measure the actual resistance using a multimeter. They will record their calculated and measured values to check for comparability. The goal is to practice determining resistances from color bands and verifying the values experimentally.

Uploaded by

Umair Fayyaz
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

EEE121- Electrical Circuit Analysis I

Lab # 01
To identify values of resistances using color codes

Name M.Umair , Usama

RegistrationNumber 99,93

Class BCE A

Instructor’s Name Sarmad Hassan

INTRODUCTION:

Breadboard:

It is used to construct circuits using components and jumper wires. All the components are
mounted on to the breadboard with jumper wires used to connect them to each other. The breadboard
also has a DC power supply ranging from 0-15 VDC. Also a constant 5 VDC output is available. The
circuit ground connection is also available.

Jumper wires:

These wires are used to connect circuit components to each other and to the supply available on
the breadboard or the function generator. These can be simple wires as well as “Alligator Clip end”
wires.
.

Function Generator:

This is a device which produces different types of supply voltages and currents, some of which
are DC, sinusoidal, square and saw-tooth waveforms

Multimeter:

It is used for measurement of circuit variables (like voltage and current), circuit continuity,
resistance, diode terminal identification .

Resistors:

Resistor is a passive two-terminal electrical component that implements electrical resistance as a


circuit element. In electronic circuits, resistors are used to reduce current flow, adjust signal levels, to
divide voltages, bias active elements, and terminate transmission lines, among other uses. High-power
resistors that can dissipate many watts of electrical power as heat, may be used as part of motor controls,
in power distribution systems, or as test loads for generators.

Procedure:

 Calculate the resistance of the resistors available by using color codes.


 2. Switch the selector of multi-meter to resistance measurement. 3. Select the minimum
range and measure resistance by connecting both probes of meter to the ends of resistor.
Be sure, not to touch both ends of the resistor while the probes of meter are connected to
the resistor. This will make a resistive path through your body in parallel with the
resistor, thus affecting the correct reading.
 4. If the reading of the multi-meter is pegged, i.e. displays “1” on the left hand side of
LCD display, this means the resistance is greater than the selected range.
 5. Switch to the next available range and measure the resistance again.
 6. Repeat step 5 till a reading is available on the display.

 7. Check whether the calculated and measured values are comparable.


 8. Repeat the procedure for different resistors available.

Calculations:

NO.OF COLOR CODE MULTIMETER DIFFERENCE


RESISTORS RESISTANCE
1
2
3
4
5

You might also like