18W Single Output Switching Power Supply L P H - 1 8 series

■ Features :
180-264VAC input only
Fully encapsulated with IP67 level (Note.5)
Protections:Short circuit / Overload / Over voltage / Over temperature
Cooling by free air convection
Class Ⅱ power unit, no FG
Pass LPS
100% full load burn-in test
Suitable for LED lighting and moving sign applications
High reliability / Low cost
2 years warranty

SPECIFICATION
LPS IP67
MODEL LPH-18-12 LPH-18-24 LPH-18-36
DC VOLTAGE 12V 24V 36V
RATED CURRENT 1.5A 0.75A 0.5A
CURRENT RANGE 0 ~ 1.5A 0 ~ 0.75A 0 ~ 0.5A
RATED POWER 18W 18W 18W
RIPPLE & NOISE (max.) Note.2 120mVp-p 150mVp-p 200mVp-p
OUTPUT
VOLTAGE TOLERANCE Note.3 ±3.0%
LINE REGULATION ±1.0%
LOAD REGULATION ±2.0%
SETUP, RISE TIME 1500ms, 30ms / 230VAC
HOLD UP TIME (Typ.) 50ms/230VAC at full load
VOLTAGE RANGE 180 ~ 264VAC 254 ~ 370VDC
FREQUENCY RANGE 47 ~ 63Hz
EFFICIENCY(Typ.) 77% 82% 83%
INPUT
AC CURRENT 0.3A/230VAC
INRUSH CURRENT(Typ.) COLD START 50A(twidth=155μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A 17 units (circuit breaker of type B) / 28 units (circuit breaker of type C) at 230VAC
CIRCUIT BREAKER
LEAKAGE CURRENT 0.25mA / 240VAC
Above 105% rated output power
OVERLOAD
Protection type : Hiccup mode, recovers automatically after fault condition is removed
13.8~ 16.2V 27.6~ 32.4V 41.4 ~ 48.6V
PROTECTION OVER VOLTAGE
Protection type : Shut off o/p voltage, clamping by zener diode
OVER TEMPERATURE Hiccup mode, recovers automatically after temperature goes down
WORKING TEMP. -30~ +70℃ (Refer to "Derating Curve")
WORKING HUMIDITY 20 ~ 90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT ±0.03%/℃ (0 ~ 50℃)
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY STANDARDS TUV EN60950-1, IP67 approved; design refer to UL1310 Class 2,CAN/CSA No. 223-M91
SAFETY & WITHSTAND VOLTAGE I/P-O/P:3KVAC
EMC ISOLATION RESISTANCE I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
(Note 4)
EMC EMISSION Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3
EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
MTBF 1200.6K hrs min. MIL-HDBK-217F (25℃)
OTHERS
DIMENSION 140*30*22(L*W*H)
PACKING 0.175Kg; 70pcs/13.3Kgs/0.71CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
NOTE
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
5. Suitable for indoor use or outdoor use without direct sunlight exposure.
6. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.

File Name: LPH-18-SPEC 2016-02-17

 18W Single Output Switching Power Supply L P H - 1 8 series
Mechanical Specification Unit:mm

300±20 140 300±20

3.5
UL 1015 18AWG

3.5
UL 1015 18AWG

AC IN
AC/N(Blue)

20
.6

DC OUT
-V(Black)
ψ3 .6

30
AC/L(Brown) 56
ψ3 +V(Red)
3.5
T case
3.5

※ T case: Max. Case Temperature

22
Recommend Mounting Direction

Block Diagram
fosc : 60KHz

POWER RECTIFIERS +V
I/P EMI FILTER RECTIFIERS SWITCH- &
-V
ING FILTER

DETECTION
CIRCUIT
PWM
CONTROL

Derating Curve Static Characteristics

100
100
90
80
80

60 70
50
LOAD (%)

LOAD (%)

60
40
50
20
40

-30 0 10 20 30 40 50 60 70 (HORIZONTAL) 180 190 200 210 220 230 240 250 264

AMBIENT TEMPERATURE (℃) INPUT VOLTAGE (VAC) 60Hz

File Name: LPH-18-SPEC 2016-02-17