D) 8 Bit, On Chip 128 Byte RAM
D) 8 Bit, On Chip 128 Byte RAM
D) 8 Bit, On Chip 128 Byte RAM
3. Which pin of port 3 is has an alternative function as write control signal for external data
memory?
a. a) P3.8 b) P3.3 c) P3.6 d) P3.1
c) 8-bit auto reload mode, 8-bit auto reload time/counter; THx holds a
value which is to be reloaded into TLx each time it overflows
9. Which special function register play a vital role in the timer/counter mode selection
process by allocating the bits in it?
10. Who controls the timer1 especially when it is configured as a timer in mode'0',where gate
and TR1 bits are attributed to be '1” in TMOD register ?
11. What is the maximum delay generated by the 12 MHz clock frequency in accordance to
an auto-reload mode (Mode 2 ) operation of the timer?
12. Which among the below mentioned reasons is / are responsible for the generation of
Serial Port Interrupt ?
A. Overflow of timer/counter 1
B. High to low transition on pin INT1
C. High to low transition on pin INT0
D. Setting of either TI or RI flag
13. What is the bit addressing range of addressable individual bits over the on-chip RAM?
a. 00H to FFH
b. 01H to 7FH
c. 00H to 7FH
d. 80H to FFH
15. Give the names of the buses present in a controller for transferring data from one place to
another?
a) data bus, address bus
b) data bus
c) data bus, address bus, control bus
d) address bus.
16. Find out the roll over value for the timer in Mode 0, Mode 1 and Mode 2?
a) 00FFH,0FFFH,FFFFH
b) 1FFFH,0FFFH,FFFFH
c) 1FFFH,FFFFH,00FFH
d) 1FFFH,00FFH,FFFFH
17. If Timer 0 is to be used as a counter, then at what particular pin clock pulse need to be
applied?
a) P3.3
b) P3.4
c) P3.5
d) P3.6
18. With what frequency UART operates( where f denoted the crystal frequency )?
a) f/12
b) f/32
c) f/144
d) f/384
19. Which register is used to make the pulse a level or an edge triggered pulse?
a) TCON
b) IE
c) IPR
d) SCON
20. Which memory allow the execution of instructions till the address limit of 0FFFH
especially when the External Access (EA) pin is held high?