1|Page CIVIL ENGINEERING

1.The simply supported beam is 4. Based on 30th hour volume for how
subjected to a uniformly distributed much % time during the year can the
load of intensity w per unit length on designer willingly tolerate the
half of the span from one end . The unfavourable operating condition?
length of the span and the flexural
(a) 0.33 % (b) 3.3 %
stiffness are denoted as L and EI
(c) 33 % (d) 0.03 %
respectively. The deflection at mid span
of the beam is 5. The effective stress friction angle of
saturated cohesionless soil is 38 degree.
4 4
5w L 5w L The ratio of shear stress to normal
(a) (b)
6144 EI 768 EI effective stress on the failure plane is

5w L4 5w L4 (a) 0.871 (b) 0.781

(c) (d)
384 EI 192 EI (c) 0.5 (d) 1

2. Calculate the minimum sight distance 6. A layer of normally consolidated ,

required to avoid a head on collision of saturated silty clay of 1 m thickness is
two cars approaching from the opposite subjected to one dimensional
directions at 90 and 60 kmph . Assume a consolidation under a pressure
reaction time of 2.5 seconds , coefficient increment of 20 kpa .The properties of
of friction of 0.7 and a brake efficiency the soil are specific gravity = 2.7 ,
of 50 % . natural moisture content = 45 %,
compression index = .45 , and
(a) 236 m (b) 290 m
(c) 360 m (d) 180 m recompression index = 0.05 . The initial
average effective stress within the layer
3. For a circular curve of radius 200 m ,
is 100 kpa. Assuming Terzaghi’s theory
the coefficient of lateral friction of 0.15
to be applicable, the primary
and the design speed is 40 kmph . Find
consolidation settlement (rounded off to
the equilibrium super elevation (for
the nearest mm) is
equal pressure on inner and outer
wheel) (a) 10 mm (b)16mm
(c) 160 mm (d) 1.6 mm
(a) 7.3 % (b) 6.3 %
(c) 9 % (d) 5 %

ENGINEERS CAREER GROUP www.engineerscareergroup.com

S.C.O-61, SEC-40/C, CHANDIGARH engineerscareergroup@live.in
2|Page CIVIL ENGINEERING

7. Determine the moment of resistance 11. If the principal stresses in a two

for the rectangular section of width = dimensional case are -10 MPa and 10
250 mm and effective depth = 310 mm , MPa respectively, then maximum shear
area of tension reinforcement consist of stress at a point is
3-12 Ф bars . Use M 20 and Fe 500
(a) 20 MPa (b) 10 MPa
(a) 41 kN m (b) 151 kNm (c) 5 MPa (d) zero
(c) 81 kN m (d) 101 kN m
12. A steel column, pinned at both ends
8. A two dimensional flow is described ,has a buckling load of 200 kN . If the
by velocity component column is restrained against lateral
. The discharge between points (1,1) movement at its mid height, its buckling
and (2,2) is equal to load will be

(a) 6 unit (b) 60 unit (a) 200 kN (b) 283 kN

(c) 8 unit (d) 80 unit (c) 400 kN (d) 800 kN

9. Find the critical depth for a discharge 13.The flexural tensile strength of M 30
of 4 m3/sec for flow in right angled concrete as per IS 456 2000 is
triangular channel .
(a) 30 MPa (b) 21.23 Mpa
(a) 1.027 m (b) 1.15 m (c) 3.83 MPa (d) 6 MPa
(c) 1.27 m (d) 1.20 m
14.The shape of cross section having
10.An incompressible fluid flows largest shape factor , is
steadily through two pipes of diameter
(a) Rectangular (b) I section
0.15 m and 0.2 m which combined to
(c) solid circular (d) diamond
discharge in a pipe of 0.3 m diameter . If
the average velocity in the 0.15 m and 15. A 6 m thick clay layer undergoes 90
0.2 m diameter pipes are 2 m/s and 3 % consolidation 4 times faster under
m/s respectively, then find the average two two way drainage as compared to
velocity in the 0.3 m dia pipe one way drainage. In an identical clay
layer of 12 m thickness, two way
(a) 1.90 m /sec (b) 1.83 m/sec drainage will be faster as compared to
(c) 1.73 m/sec (d) 1.53 m/sec
one way drainage by

(a) 8 times (b) 4 times

(c) 2 times (d) 16 times
ENGINEERS CAREER GROUP www.engineerscareergroup.com
S.C.O-61, SEC-40/C, CHANDIGARH engineerscareergroup@live.in
3|Page CIVIL ENGINEERING

16. A water sample has a pH of 9.25 . 21. The values of a function f(x) are
The concentration of hydroxyl ions in tabulated below :
the water sample is
x 0 1 2 3
(a) 0.302 mg/L f(x) 1 2 1 10
(b) moles /L Using Newton’s forward difference
(c) 10 4.75 milli moles /L formula the cubic polynomial that can
(d) None
be fitted to the above data is

17. A circular primary clarifier processes 3 2

(a) 2x 7 x 6x 2
an average flow of 5005 m3 / d of
3 2
municipal waste water. The overflow (b) 2 x 7 x 6x 2
rate is 35 / d. The diameter of 3 2 2

clarifier shall be (c) x 7 x 6x 1

(a) 11.5 m (b) 12.5 m 3 2

(d) 2 x 7 x 6x 1
(c) 13.5 m (d) 10.5 m
22. The rank of the matrix :
18. The magnetic bearing of a line AB is
2 3 1 1
S E and the declination is 5 degree
1 1 2 4
west . The true bearing of the line AB is is
3 1 3 2
(a) S 45 E (b) S 40 E 6 3 0 7
(c) S 50 E (d) S 50 W (a) 1 (b) 2
(c) 3 (d) 4
19. In a hand of Bridge, Probability that
a person have 5 spades and his partner 23. f(x) = x , then in the interval [-1, 1]
has remaining? f(x) is
(a) 2.6083 10 6
(b) 2.7016 10 5
(a) Satisfied all the conditions of Rolle’s
6 9 Theorem
(c) 9.999 10 (d) 2.026 10
(b) Satisfied all the conditions of mean
value theorem
20. A player losses 6 coin’s then the (c) Does not satisfied the condition of
probability that both the aces are the man value theorem
(d) None of these
same Number.
(a) 0.3125 (b) 0.2343
(c) none of these (d) does not exist

ENGINEERS CAREER GROUP www.engineerscareergroup.com

S.C.O-61, SEC-40/C, CHANDIGARH engineerscareergroup@live.in
4|Page CIVIL ENGINEERING

24. The Laplace transform of sinh at is 1

25. The value of 2
c as ax is
a s D a2
(a) (b) x x
s2 a2 s2 a2 (a) cosax (b) sinax
2a 2a
s a
(c) 2 2
(d) 2 x
s a s a2 (c) sinax (d) none of these
2a

ENGINEERS CAREER GROUP www.engineerscareergroup.com

S.C.O-61, SEC-40/C, CHANDIGARH engineerscareergroup@live.in