BP - Indonesia: Artificial Lift
BP - Indonesia: Artificial Lift
ARTIFICIAL LIFT
1. DOCUMENTATION
- Material Certificate shall be issued by manufacture. Specific material or
equipment shall comply with standard requirement is listed as follow:
- Gas lift valve, gas lift dummy valve, and chemical injection valve shall
comply with section 4.3 API Specification 11V1.
- Chemical injection package shall comply with section 5 BP Specification
number ARII-MS-305.
- Mandrel shall comply with section 5.1.2 API Specification 11V1.
- Electrical Submersible Pump (ESP), motor, motor controller, and motor
protector (motor seal chamber) shall comply with section 3 API Recommended Practice
11S4 or section 5 BP Specification number ARII-MS-315.
- Submer pump cable shall comply with API Recommended practice 11S5.
- Pack off (ESP cable and gas lift)
- By pass tubing clamp
- Control line protector
Page of 15
Project : Document Number
Development Quality System BPI-SPC- -A
Discipline :
BP - INDONESIA Vol. Revision
SCM and QA/QC Group No. A
Author’s Org : Material Purchase Specification Revision Date
September 10, 2002
Page of 15
Project : Document Number
Development Quality System BPI-SPC- -A
Discipline :
BP - INDONESIA Vol. Revision
SCM and QA/QC Group No. A
Author’s Org : Material Purchase Specification Revision Date
September 10, 2002
- Visual inspection:
- The Inspection to make sure the condition of equipment.
- Identification Check:
- Inspection based on material certificate.
- Pressure/Leak Test:
- Examination shall comply with section 4.4 and 5.2 API Specification 11V1
for all valve.
- Performance/Functional Test:
- Examination of Electric Submersible Pump (ESP) shall comply with API
Recommended Practice 11S2.
- Examination of Submer pump cable shall comply with section 7 API
Recommended Practice 11S6.
Page of 15
Project : Document Number
Development Quality System BPI-SPC- -A
Discipline :
BP - INDONESIA Vol. Revision
SCM and QA/QC Group No. A
Author’s Org : Material Purchase Specification Revision Date
September 10, 2002
b. Packaging Requirement
c. Marking Requirement
- Gas lift valve, gas lift dummy valve, chemical injection valve shall shown
manufacture name or trademark, API specification number, API monogram, and date of
manufacture. Requirement can be seen on section 4.5 or Appendix E API Specification
11V1.
- All mandrel shall be marked according to section 5.1.6 or Appendix E API
Specification 11V1 which are showing manufacture name, API monogram, API license,
date of final acceptance by the manufacture, Manufacture Mandrel type identification,
and part number. Especially for mandrel painted marking are required.
4. REFERENCE
- API Specification 11V1
- API Recommended Practice 11S2
- API Recommended Practice 11S4
- API Recommended Practice 11S5
- API Recommended Practice 11S6
- ASME section IX BP&V Code
- BP Specification ARII-MS-305
- BP Specification ARII-MS-315
Page of 15
Project : Document Number
Development Quality System BPI-SPC- -A
Discipline :
BP - INDONESIA Vol. Revision
SCM and QA/QC Group No. A
Author’s Org : Material Purchase Specification Revision Date
September 10, 2002
Page of 15