Features: SLP Series Model 33
Features: SLP Series Model 33
Features: SLP Series Model 33
FEATURES
Low Cost
Rigid Plastic DIP
High Level Output
High Impedance
APPLICATION
Non-invasive Blood Pressure
Air Mattress
Water Level
DESCRIPTION
The SLP Series model 33 is piezoresistive silicon pressure sensor in 6-pin
plastic DIP package. It is intended for high volume application where
simplest pressure connection and low cost is required.
The pressure sensor consists of gage pressure chip that is attached to the
housing directly. The pressure is applied to the back side of chip. It is
designed to operate with non-corrosive media, such as air, fluid and the
like. Easy air interface can be obtained through the molded pressure port.
Either constant current or voltage can be used as excitation. Due to high
impedance, it is suitable for battery operated devices. It is shipped in tube
or tray. Other pin out assignment and performance are also available,
please contact factory for detail.
1/2
Characteristics
Unless otherwise specified, all parameters are measured at 25 °C and excitation of 5Vdc
10.2±0.2 10 10
C0.5
0.8
O3.0
6
R 0.5
Atmospheric
Vent Port
8.6
3.3
1 9942
XXX
4.9
5-15° 0.2
2.54
Note:
Soldering of lead pins: 250 °C for 5 sec max. Unit: mm
(1)
Ordering Information
(2)
3 3 1 9 9 4 2
Lead Direction
1: same as tube
Range 2: opposite as tube
1 = 5.8 PSI
= 300mmHg
Series