B2281
B2281
B2281
CIRCUIT DESCRIPTION
The power source control ECU and the transmission control ECU are connected by a cable and BEAN. If
the cable information and BEAN information are inconsistent, this DTC will be output.
DTC No. DTC Detection Condition Trouble Area
Power source control ECU
Cable and BEAN between power source control ECU and
B2281 Transmission control ECU
transmission control ECU are inconsistent
Wire harness
WIRING DIAGRAM
P6
T4 Power Source
Transmission Control ECU Control ECU
B75961
INSPECTION PROCEDURE
1 READ VALUE OF HAND–HELD TESTER
(a) Connect the hand–held tester (with CAN VIM) to the DLC3.
(b) Turn the power switch ON (IG) and press the hand–held tester main switch ON.
(c) Read the DATA LIST according to the displays on the tester.
Standard (Power source control ECU):
Measurement Item/Range Diagnostic
Item Normal Condition
(Display) Note
States of the Shift P Signal / ON: Shift P signal ON (Shift position is ”P”)
SHIFT P SIG –
ON or OFF OFF: Shift P signal OFF (Shift position is except ”P” position)”
OK
T4
Transmission Control ECU
PPOS
B80050
NG REPAIR OR REPLACE HARNESS AND CON-
NECTOR
OK
(a) After replacing the power source control ECU with a normally functioning ECU, check that the hybrid
control system can start normally.
OK: Hybrid control system can start normally.
NG Go to SHIFT CONTROL SYSTEM
(See page 05–1139)
OK