DAC1 24 03 Rev 2
DAC1 24 03 Rev 2
DAC1 24 03 Rev 2
2. Effectivity: DA20-C1 aircraft from S/N C0001 to S/N C0148 and C0150.
This estimate is for direct labour performed by a technician and it does not
include setup, planning, familiarization, cure time, part fabrication or tool
acquisition.
10.1 Remove the existing battery (reference DA201-C1, chpt. 24-31, sec.3A).
10.3 Remove the existing anchor strap and its mounting hardware.
10.4 Remove the rubber plug from right side of battery housing and install the new rubber
grommet as in Figure 1.
10.7 The new positive cable terminal has a larger diameter (5/16"Ø) ring terminal at the
battery end. Do one of the following procedures:
A. Enlarge the existing ring terminal hole by drilling it with a 5/16" bit. Use a
soldering iron and solder to tin the exposed copper on the inside of the hole.
OR
B. Cut off the existing terminal and crimp on the new one (P/N 322870).
OR
C. Replace the existing battery lead with the new one. This would require partial
disassembly of the electrical junction.
10.8 Install the new rubber plug in the left side hole in the battery housing.
10.9 Install the new battery (reference DA201-C1, chpt. 24-31, sec. 3B). Discard old
anchor strap latch bolt and install new bolt P/N AN4-16A as in Figure 1.
10.10 Install the support bracket. Elongation of the housing holes may be necessary for
proper fit on the battery (see Note in Figure 1).
10.11 Update the Airplane Flight Manual weight and balance record.
10.12 Make the appropriate entry into the aircraft technical log.
SERVICE BULLETIN
Service Bulletin No.: DAC1-24-03 Rev 2 Date Issued: 27 April 2010
Title: G-35 Battery, Optional Installation Page: 3 of 4
11. Weight and Balance: Refer to DA202-C1, chpt. 6, Equipment List for changes in the
weight and balance.
To obtain satisfactory results, procedures specified in this service bulletin must be accomplished in accordance with
accepted methods and current government regulations. Diamond Aircraft Industries Inc. cannot be responsible for the
quality of work performed in accomplishing the requirements of this service bulletin. Diamond Aircraft reserves the right
to void continued warranty coverage in the area affected by this service bulletin if it is not incorporated.
If you no longer own the aircraft to which this service bulletin applies, please forward it to the current owner and send
the name of the current owner to Diamond Aircraft Industries Inc. at the address below.
Diamond Aircraft Industries Inc. 1560 Crumlin Sideroad, London, Ontario, Canada N5V 1S2
Customer Support: Phone: (519) 457-4041 Fax: (519) 457-4045 E-mail: custsupp@diamondair.com
Technical Publications: Phone: (519) 457-4030 Ext. 3173 E-mail: techpubs@diamondair.com
COPYRIGHT 2010
SERVICE BULLETIN
Service Bulletin No.: DAC1-24-03 Rev 2 Date Issued: 27 April 2010
Title: G-35 Battery, Optional Installation Page: 4 of 4
Figure 1