General Notes:: LP-01 LP-02
General Notes:: LP-01 LP-02
General Notes:: LP-01 LP-02
LP-01
b
LP-02
GENERAL NOTES : WIRING METHOD SHALL BE DONE IN RIGID NON-METALLIC PVC CONDUIT TYPE UNLESS
OTHERWISE INDICATED IN THE PLAN.
S3Wd SINGLE GANG, THREE WAY SWITCH, 5A, FLUSH TYPE ALL MATERIALS TO BE USED SHALL BE NEW AND OF APPROVED TYPE AS TO LOCATION
S1
AND PURPOSE INTENDED, PROVIDE PULL BOX WHENEVER NECESSARY EVEN WHEN
S3wd
INDICATED IN DARWING.
CEILING LIGHT OUTLET
MINIMUM SIZE OF WIRE AND CONDUIT SHALL BE 2.0mm.2 THHN ( SOLID WIRE ) AND 20mm. O/
CO RIGID PVC PNS:14 TRADE SIZE RESPECTIVELY.
DUPLEX CONVENIENCE OUTLET, W/ GROUND,
FLUSH TYPE W/ PLATE & COVER STANDARD TYPES OF ACCESSORIES, SPLICING DEVICES TERMINATION AND OTHER
LP
APPURTENANCES OF THE ENTIRE ELECTRICAL INSTALLATION SHALL BE USED.
dn to S3wd S1 SWITCH, 1-GANG, FLUSH TYPE W/ PLATE & COVER THE CONTRACTOR SHALL BE RESPONSIBLE FOR CONSULTING AND COORDINATING
POWER WITH THE LOCAL POWER COMPANY AS REGARDS TO SERVICE CONNECTION
a REQUIREMENTS.
LP LIGHTING PANEL, IN NEMA 1 ENCLOSURE
MOUNTING HEIGHTS HEREUNDER SHALL BE AS FOLLOWS :
CIRCUIT BREAKER, RATING AS INDICATED TUMBLER SWITCHES ------------------------------ 1.40 m. ABOVE FINISH FLOOR
LP-02 up to LT. a CONVENIENCE OUTLETS ------------------------- 0.30 m. ABOVE FINISH FLOOR
CO
GROUND PANEL BOARD ---------------------------------------- 1.60 m. ABOVE FINISH FLOOR
S3wd
COUNTER TOP OUTLET --------------------------- 0.30 m. ABOVE FINISH FLOOR
ELECTRICAL SERVICE ENTRANCE THE CONTRACTOR SHALL SECURE ALL NECESSARY WIRING PERMITS, CERTIFICATE
OF THE ELECTRICAL INSPECTION AND PAY ALL THE FEES NECESSARY THERE TO.
M KILOWATT - HOUR METER OPEN WIRING INSTALLATION SHALL BE RUN IN PARALLEL WITH AND/OR AT RIGHT
ANGLE TO TRUSSES AND COLUMNS, DIAGONAL RUNS SHALL NOT BE PERMITTED.
PROVIDED CONDUIT CLAMP ON CONDUITS TO ENSURE FIRM ANCHORAGE.
LOFT FLOOR ALL INSTALLATION HEREIN SHALL BE DONE UNDER THE DIRECT SUPERVISION OF
LICENSED ELECTRICAL ENGINEER OR MASTER ELECTRICIAN.
2 ELECTRICAL LAYOUT PLAN SUBMIT AS-BUILT PLANS OF COMPLETED ELECTRICAL INSTALLATION.
E-1 SCALE : 1 : 50 MTS.
PROVIDE LOCKNUT AND ADAPTOR TO ALL ATTACHMENT/CONNECTIONS OF PIPES
AND METAL FRAMES OR BOXES.
GROUND FLOOR
1 ELECTRICAL LAYOUT PLAN
E-1 SCALE : 1 : 50 MTS.
1 LIGHTING 4-100VA 230 400 1.74 2-1.6mm.2 THHN, SOLID WIRE 20mm. O
/ RIGID PVC 15 50 2 10 BOLT-0N
LP UNIT TYPICAL ( NEMA 1 )
230 800 3.48 2-3.5mm.2 THHN + 20 50 2 10 BOLT-ON
2 POWER 4-200VA 20mm. O
/ RIGID PVC
1-2.0mm.2 THHN (G)
3 SPARE 230 1500 6.52 20mm. O
/ RIGID PVC 20 50 2 10 BOLT-ON
LO 2 15AT 20AT 1 CO
COMPUTATION / FEEDER SIZE COMPUTATION IL AT 100% DEMAND FACTOR :
2700
20AT 20AT IL = x 100 % DF USE : 2 - 5.5mm.2 THHN + 1-5.5mm.2 THHN (G)
RANGE 4 3 SPARE 230
IN 20mm. O/ RSC
IL = 11.74 AMPS
PROJECT TITLE : Republic of the Philippines ARCHITECT / ENGINEER DESIGNED: PLIBARDALOZA CHECKED: RGRAMOS SHEET NO.
MUNICIPALITY OF TIGAON Office of the President
Tigaon, Camarines Sur DRAWN: PLIBARDALOZA DATE:
NATIONAL HOUSING AUTHORITY
CHECKED BY RECOMMENDING APPROVAL SHEET CONTENT District II, VGH, Concepcion Grande, Naga City
LOCATION : Engr. CRISTINA A. CABANGON Engr. ALBERT A. PERFECTO MARCELINO P. ESCALADA JR. 11 13
REG No.: DATE: PROJECT MANAGER, DISTRICT II - REGION V ACTING REGIONAL MANAGER, REGION V GENERAL MANAGER, NHA
BRGY. SALVACION, TIGAON, CAMARINES SUR Hon.
MUNICIPAL MAYOR PTR No.: PLACE: