SPECIFICATION

No.

STK403-120 2002.12.28

TENTATIVE
1. Case Outline 15Pins (See attached Package Outline Diagram)
2. Function 2 channels AF power amplifier
3. Application 80W audio use
4. Maximum Ratings / Ta=25°C
Item Symbol Conditions Ratings Unit
Maximum Power Supply Voltage 0 Vcc max(0) Non- signal +-65 V
Maximum Power Supply Voltage Vcc max(1) Signal ,R L≧6ohm +-57 V
Minimum Operation Supply Voltage Vcc min +-10 V
#12 Maximum Operating Current *7 IST OFF max 0.6 mA
Thermal Resistance Theta j-c Per one power TR 1.9 °C/W
Junction Temperature Tj max 150 °C
Should satisfy Tj max and Tc max
Operating Substrate Temperature Tc max 125 °C
Storage Temperature Tstg -30 to +125 °C
Available Time for Load Vcc=+-40V,RL=6ohm,f=50Hz
ts 0.3 s
Short-circuit *4 PO=80W,1ch drive
5. Operating Characteristics
Tc=25°C ,RL=6ohm(Non-inductive Load),Rg=600ohm,VG=30dB
Conditions *2 Ratings
Item Symbol V f Po THD Unit
MIN. TYP. MAX.
(V) (Hz) (W) (%)
Output Power *1 Po 1 +-40 20 to 20k 0.4 76 80 W
Po 2 +-40 1k 10 120
THD 1 +-40 20 to 20k 0.4
THD *1 5.0 VG=30dB %
THD 2 +-40 1k 0.01
Frequency
fL,fH +-40 1.0 +0 -3 dB 20 to 50k Hz
Characteristics *1
Input Impedance ri +-40 1k 1.0 55 kohm
Output Noise
VNO +-48 Rg=2.2kohm 1.0 mVrms
Voltage *3
Quiescent Current ICCO +-48 No load 20 45 80 mA
Output Neutral
VN +-48 -70 0 +70 mV
Voltage
#13 Stand-By V#13=5V
IST ON +-40 0 mA
Current #13PIN
#13 Operating Resistance
IST OFF +-40 R1=13kohm 0.25 0.6 mA
Current

*Specifications and information herein are subject to change without notice.

Sanyo Electric Co.,Ltd. Module Systems Division NO.1

Free Datasheet http://www.datasheet4u.com/
STK403-120
*Specifications and information herein are subject to change without notice.

Note *1.1channel Operation.

*2.All tests are measured using a constant-voltage supply unless otherwise specified.
*3.The output noise voltage is peak value of an average-reading meter with a rms value scale(VTVM).
A regulated AC supply(50Hz) should be used to eliminate the effects of AC primary line flicker noise.
*4.Available time for load short-circuit and output noise voltage are measured using the specified
transformer power supply.
*5.Please keep the condition always most below Voltage ‘–Pre Vcc(#1pin)’.
*6.In case of heat sink design, we request customer to design in the condition to have assumed market.
*7.Please specify resistance value by satisfying ‘#13(Stand-By)pin’ Maximum Operating Current.
This Circuit change operation mode to give above VBE(about 0.6v) voltage at ‘#13(Stand-By)pin’.

Specified Transformer Power Supply

DBA40C 10000u
+Vcc
+
500ohm

+
500ohm
-Vcc
10000u

(Equivalent to MG-250)

Sanyo Electric Co.,Ltd. Module Systems Division NO.2

Free Datasheet http://www.datasheet4u.com/

 内部等価回路
Equivalent Block Diagram (STK403-090/100/120/130)

3
8
R2 R12
D1 D2

ISB1 ISB2
TR1 TR4
R1 R11

C2 C12
C1 C11

R3 R13
TR3
11
TR6 15
Pre Driver IC R4 Pre Driver IC
R14
CH1 CH2 14
12

TR2 TR5

1 Bias Circuit

SUB

9 10 5 4 6 7 13
Free Datasheet http://www.datasheet4u.com/
 測定回路図
Test Circuit (STK403-090/100/120/130)

STK403-090/100/120/130 (*1)Stand-by 端子(#13)の動作時流入電流が最大定格を

越えないよう制限抵抗値を設定して下さい。
Ch1 Ch1 Ch2 Ch2 Ch1 Ch1 ST-BY Ch2 Ch2
-PRE -Vcc +Vcc OUT OUT OUT OUT +PRE SUB GND IN NF NF IN Please specify resistance value by satisfying
’#13(Stand-by)pin’ Maximum Operating Current.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
0.22Ω 0.22Ω
100 100 (*1)
56kΩ pF pF
Stand-by Control
56kΩ
3pF 2.2μF
/50V 1kΩ
Ch2 IN
3pF 1.8kΩ 1.8kΩ

470pF
56kΩ
10μF 10μF
/10V /10V
GND

470pF
56kΩ
Ch1 IN
2.2μF 1kΩ
/50V
3μH

Ch2 OUT
0.1μF
+Vcc
100Ω/1W 100μF 4.7Ω 4.7Ω/1W
100μF /100v
/100V GND
GND
100μF
/100V GND
4.7Ω/1W
3μH
-Vcc 0.1μF
Ch1 OUT
4.7Ω

SUB.GND
Free Datasheet http://www.datasheet4u.com/
ww
w.s
ne
eze
.c
o.
in
 STK403-100series Stand-by Control & Mute Control Application 2002.07.22

(*1)Stand-by 端子(#13)の動作時流入電流が最大定格を
越えないよう制限抵抗値 R1 を設定して下さい。
Please specify resistance value by satisfying
STK403-100series ’#13(Stand-by)pin’ Maximum Operating Current.
Ch1 Ch1 Ch2 Ch2 Ch1 Ch1 Ch2 Ch2
-PRE -Vcc +Vcc OUT OUT +PRE SUB GND IN NF ST-BY NF IN
OUT OUT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 1kΩ

0.22Ω 0.22Ω 33kΩ Stand-by Control

100pF 100pF (*1) R1 H：Operation Mode(+5V)
56kΩ 13KΩ
33μF 2kΩ
/10V L：Stand-by Mode(0V)
56kΩ
3pF 2.2μF
/50V 1kΩ
Ch2 IN
3pF 1.8kΩ 1.8kΩ 10kΩ

470pF
56kΩ
10μF 10μF
/10V /10V
GND

470pF
56kΩ
10kΩ
Ch1 IN
2.2μF 1kΩ
/50V
3μH 10kΩ

100Ω/1W Ch2 OUT Mute Control

0.1μF
+Vcc H：Single Mute
4.7Ω 2.2kΩ
100μF 4.7Ω/1W
100μF /100V L：Normal
/100V GND
GND
+5V
100μF
GND Stand-by Control
/100V
4.7Ω/1W
3μH +5V
-Vcc 0.1μF
Mute Control
Ch1 OUT
MUTE
4.7Ω

SUB.GND
Free Datasheet http://www.datasheet4u.com/

ST-BY PLAY MUTE ST-BY