Dyna 230 New
Dyna 230 New
Dyna 230 New
OFF-HIGHWAY CONTROLLER
PART NUMBER: DYN1-10749
GENERAL
This controller is specifically designed to cover a wide
range of control requirements for industrial and off-
highway engines. It has three selectable speeds (LOW,
MID and HIGH) plus a unique gain change feature that
automatically increases the gain for optimum response
when MID and HIGH speeds are selected. In addition,
the controller has a built in limit to prevent overshooting
of the engine speed after extreme loading. This limit
automatically resets the controller's integrator circuit
TYPICAL APPLICATIONS
upon sensing a quick increase in engine speed - i.e.
during an engine load shed. This feature provides • Manlifts • Irrigation Engines
protection against excessive engine speed overshoots. • Cranes • Pumps
• Sweepers • Crop Spraying
Unlike a throttle control, the DYN1-10749 is an isochro- • Chippers • Compactors
nous governor. For any given speed set input, the • Welders • Graders
controller sends a corrective output signal to the actuator • Trenchers • PTOs
to maintain the speed selected. Unlike a throttle positioner, • Compressors • Gensets
this control uses a PID function to provide a quick and
stable engine response to load changes holding engine SPEED SENSING
RPM constant. A magnetic pickup, typically mounted in the flywheel
housing perpendicular to the flywheel, supplies a speed
The DYN1-10749 controller can be used in either diesel reference signal to the controller. The number of teeth
or spark-ignited engine applications. sensed per revolution is converted to a frequency the
controller reads to maintain set speed.
FEATURES
• Rated Input Signal Frequency Engine RPM x Number of
• All Electric in Hertz = Gear Teeth on Flywheel
60
• All Engine Compatible - Gas and Diesel
FAILSAFE
• Three Governed Adjustable Set Speeds The actuator is spring loaded and will return to the
• Automatic Gain Change minimum fuel position if the speed reference signal is lost
• Gas or Diesel Selection Switch or if the DC power is interrupted.
• Remote Speed Selection
• High Reliability SPECIFICATIONS
• Weathertight Enclosure • Operating Voltage: 12 or 24 volts, ±20%
• Temperature Stable • Ambient Operating Temperature: -40°F to
• Flying Leads +180°F (-40° C to + 85°C)
• Mechanical Vibration: 5-500 Hz, curve L, per
MIL-STD-810C
ACTUATOR COMPATABILITY
• Weight: 826 grams (1.82 pounds)
• DYNA 2000
• Sealing: Oil, Water and Dust Tight
• DYNA 2500
• Connections: #18 gauge leads with minimum
length of 10 inches (25.4 cm)
• Input Signal Voltage From Magnetic Pickup:
2.5 VAC RMS minimum during cranking.
• Steady State Speed Band: ±0.25%
• Output Signal: PWM Current to 6 Amps Maxi-
mum
• Magnetic Pickup Frequency Range:
2500 - 5000 Hz DYNA 230
INSTALLATION DIMENSIONS