Low Idle RPM Adjust
Low Idle RPM Adjust
Page 1 of 4
Shutdown SIS
Previous Screen
$0/ 1$0
Note: Refer to Special Instruction, NEHS0605 for the operating instructions of the 9U-7400 Multitach
Tool Group and the instructions for the test procedure.
320C & 320C L Excavators GNG00001-UP (MACHINE) POWERED BY 3066 Engine(... Page 2 of 4
Illustration 1 g00569479
Points of Adjustment on Governor
Note: For any adjustments, ensure that the coolant and oil temperature are above 70 °C (158 °F).
2. At approximately 150 rpm, the engine will begin to start and the engine will pick up speed.
Immediately after the engine is running, move the control lever (2) in order to hold the engine rpm
between 800 and 1000 rpm.
3. When the engine is running at a steady rpm, move the control lever (2) to the low idle position.
320C & 320C L Excavators GNG00001-UP (MACHINE) POWERED BY 3066 Engine(... Page 3 of 4
Illustration 2 g00569487
Adjusting Low Idle
4. Hold control lever (2) at the position needed for no load minimum rpm, and set low idle set screw
(3) (if equipped). Low idle is 900 ± 20 rpm.
5. Turning the low idle set screw (3) clockwise raises the idle rpm.
320C & 320C L Excavators GNG00001-UP (MACHINE) POWERED BY 3066 Engine(... Page 4 of 4
Illustration 3 g00569488
Adjusting The Idler Subspring
6. If the engine rpm tends to fluctuate, turn idler subspring (4) clockwise. Allow the idler subspring
to come into slight contact with the tension lever. The engine rpm will rise slightly and the engine
rpm will stop fluctuating when the idler subspring is exerting some force upon the tension lever.
Note: Tightening the idler subspring adjusting screw is likely to cause the engine to overspeed
when the load is dumped during heavy-duty operation. Tighten the idler subspring slowly until the
unstable condition is eliminated.
23 4 $55 % $$ 2 ) 6 :2 / $ , $$
4# # " 6
" 7 89 :): # #6