Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Mercedes-E-Class (W212) 2010-2016

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4
At a glance
Powered by AI
The document discusses the CAN signals available for the Mercedes E-Class (W212) 2010-2016) and how to connect Racelogic products like VBox Video HD2 to access these signals.

Signals like brake position, engine speed, steering angle, throttle position, and wheel speeds are available.

You need to connect to the OBDII port using an appropriate cable. The CAN High pin is pin 6 and CAN Low pin is pin 14.

Vehicle CAN Database

Mercedes
E-Class (W212) 2010-2016
Overview
Racelogic have acquired CAN signals for customers to use with VCI (Vehicle CAN Interface)
products. This information is available by listening on the relevant CAN bus on the vehicle
and interpreting the messages to form easy to use information which is then available for
data logging.

VBox Video HD2 Users


Users of VBox Video HD2 will find this vehicle available to be selected via the VBox Video
setup software which can be downloaded from our website. The software is supplied with
instant access to the CAN information for a large array of vehicles and is kept automatically
up to date as new vehicles and signals are added (Subject to internet connection).
To start using HD2 with your vehicle simply follow the steps below:
1. Open VBox Video Setup
2. Click the “Settings” menu option
3. Select “CAN”
4. Select “Vehicle database” under “Source”
5. Select “Mercedes” and “E-Class (W212) 2010-2016”
6. Tick the signals you wish to use

Use with other Racelogic Products


Users of other Racelogic products will need to download a file from our website here:
https://vboxmotorsport.co.uk/index.php/en/customer-area/vehicle-can-database
Select "Mercedes" and "E-Class (W212) 2010-2016" from the dropdown selection to
download the relevant file.
Refer to the user manual of your product for details on how to use this file.

2
Wiring Connection
On this vehicle all information is available via the OBD-II connector, this uses the
standard pins of CAN High on pin 6 and CAN low on pin 14.

PLEASE NOTE: This information is provided as a general guide to CAN Bus wire colours only
and colours may be subject to change without notice. Racelogic accepts no responsibility for
damage or malfunction caused by incorrect wiring of its products to a vehicle. Any
connection to a vehicle CAN Bus should be done by a trained automotive technician.

CAN bus Connection


The CAN bus must be configured at a baud rate of 500k.

Cable - VBox Video HD2


To connect the HD2 system to an OBDII port, an RLCAB069L cable must be used.
Click here for a cable drawing including PIN outs for the RLCAB069L.

Cable - Other Racelogic Products


To connect between your racelogic product and the vehicle a standard OBD Cable is
available, if this was not supplied with the product please contact us for details.

3
Available CAN Channels
The following signals are available for selection:

Signal Default Units


Brake Position %
Engine Speed rpm
Steering Angle °
Throttle Position
Wheel Speed FL km/h
Wheel Speed FR km/h
Wheel Speed RL km/h
Wheel Speed RR km/h
Note: not all signals listed above will be applicable to all variants of this vehicle and so may
not be available for your specific vehicle.

Support
If any data contained in this document is incorrect or for further support please visit our
website here:https://www.vboxmotorsport.co.uk/support

You might also like