Checklist A320 A330 A340 Wilco Airbus Series
Checklist A320 A330 A340 Wilco Airbus Series
Checklist A320 A330 A340 Wilco Airbus Series
Airbus A318/A319/A320/A321
+
Airbus A330/A340
Checklist / Flow-Procedure
including basic Flight-Planning-Charts
Version 7.0
Print Notice: Page size DIN A5. Print 2 pages per A4 or Letter page. This page is the
front cover.
Attention:
1) You need a saved Flight with the aircraft parked at parking position and
parking break set!
If you don’t have such a flight you won’t be able to load the aircraft in Dark
& Cold mode. So create such a flight, set the parking break and save it.
For every new flight, set D&C in the configurator, load the flight and then
change the location the desired airport.
2) Auto-Functions in FMC are only available in Beginner and Intermediate
mode (configurator).
3) Intermediate mode is recommended as IRS alignment otherwise takes 10
minutes.
4) Thrust levers (e.g. CH Throttle Quadrant) have to be calibrated in special
way for the Wilco Airbus Series, because FLEX and TO/GA detents can’t be
reached otherwise. When calibrating set the max forward position about
1cm behind the normal max forward position. With the configuration you
can push the Airbus Series thrust levers over the 100% manual thrust
position to reach FLEX and TO/GA detents. Alternate method: Use keyboard
for t/o thrust setting and use throttles only for taxi and manual approach.
- ARRIVAL Page ➔ 1R
- Choose runway ➔ xL
o x = line no. of desired runway
o You can change this in-flight if required.
- Choose STAR and Transition ➔ xL ➔ xR
o x = line no. of desired STAR / TRANS
o You can change this in-flight if required.
o You don’t have to choose a STAR / TRANS (choose NONE / 1R).
- INSERT ➔ 6R
- Clear any discontinuities at arrival route ➔ CLR Button ➔ xL
o x = line no. of discontinuity
--- next steps are not necessary---
- Scroll page up to Dep. AP ➔ 2x AIRPORT Button
- VERT REV Page (of Dep. AP) ➔ 1R
- Enter estimated time of departure (UTC time) ➔ 2R
- RETURN ➔ 6L
--- next steps are necessary again---
- PERF TO Page ➔ PERF Button
- Enter Flap configuration for T/O (1, 2 or 3) → 3R
- Enter FLEX T/O TEMP ➔ 4R (average value: 50)
o (Auto-Flex-Temp ➔ 2x 4R)
- Enter V1 ➔ 1L
- Enter VR ➔ 2L
- Enter V2 ➔ 3L
o (Auto-V1, -VR, -V2 ➔ 2x L1 ➔ 2x L2 ➔ 2x L3)
- Enter Thrust-Reduction Alt. in ft. (>1500) (or leave suggested value) ➔
5L
- Enter Transition Alt. ➔ 4L
- Next PHASE ➔ 6R
- Enter Climb Speed (KIAS) ➔ 4L
- Next PHASE ➔ 6R
- Enter Cruise-Speed (KIAS or .Mach) ➔ 4L
- Next PHASE ➔ 6R
---FMC finished---
• Wing Lights On
• Nose Light Taxi
• Runway Turnoff Lights On
• No Smoking On (or Auto)
• Seat Belts Auto
• Flaps Select (as filled in FMC)
• Spoiler Armed
• Autobrake MAX (A340-600: RTO)
• ENG-Mode NORM
--- wait till take-off memo shows up ---
• Engine GENerators Check On
• APU Bleed Off
• APU Master Off
Taxi:
• Taxi-Clrc Request
• Taxiways Note (if required)
• Ground-Guidance Request (if required)
h/p:
• Hand-off GND to TWR Change frequency
• l/u & t/o clrc Request (rdy for dep h/p xx)
• Landing Lights On
• Nose Light TO
• Strobe Light On
• T/O Memo Check all green
• IVAP-Transponder On
• TCAS On (TA or TA/RA)
• TCAS Mode Above (or All)
• Postion & hold Taxi & stop on rwy
Ready to Takeoff:
• Parkingbreak Set
• Thrust Levers Forward to 60-70% N1
o Flex–t/o Thrust Levers up to FLX detent
--- there should be 2 audible sounds ---
o Power–t/o Thrust Levers up to TO/GA
--- there should be 3 audible sounds ---
• Parking Break Release
• Yoke Press forward till 80kts
• FMA Display-Check:
o 1st column MAN FLEX flex-number
(or TO/GA if TO/GA selected)
o 2nd column CLB (blue) and SRS (green)
o 3rd column NAV (blue) and RWY (green)
o 4th column A/THR (blue)
• V1 V1, no abort of take-off
• VR Rotate
• V2 V2, Lift-off
Takeoff:
• Trim settings DO NOT adjust
--- Note: Auto-Trim active ---
• Gear Up (at positive climb rate)
• Autopilot 1 / AP1 On
• Flaps Raise (on schedule / at S speed)
• Airborne Publish when on Unicom
• Start time Note (if required/for IVAO)
• FMA Display: Check 1st column: LVR CLB
o Thrust Levers Back to CL detent
--- 1 sound back from FLX ---
• Hand-off TWR to APP(DEP) Change frequency
Climb:
• Landing Lights Off
• Runway Turnoff Lights Off
• Nose Light Off
• Autobreak Off
• Auto-Thrust (A/TH) Reset if required
--- ➔ A/TH Off ➔ A/TH On ---
• FMA Display, Check 2nd column CLB mode active
--- to final FL / when cleared to next flight level ---
• AP altitude (& speed) Change
--- Choose “Selected AP Mode” if required by ATC ---
• TCAS biasing mode All
• Hand-off APP to CTR Change frequency
• Engine & Wing anti-ice On (under 10°C TAT)
• Altimeter Readjust (above 18000ft) (“B”)
Cruise:
• FMA Display Check 2nd column: ALT CRZ
• TCAS All
• Radio /ATC contact Maintain
• Autopilot / FMC Check permanently
• FMC Check FUEL PREDiction page for
fuel consumption
---Touchdown---
• Throttles Idle
• Thrust reversers Engage (if required)
• Thrust reversers Disengage at 80kt, thrust idle
• Brakes Push (at 40-50kt)
--- Note: auto-break now disabled ---
• Runway Vacate („rwy vacated“)
---Touchdown---
• Throttles Idle
• Thrust reversers Engage (if required)
• Thrust reversers Disengage at 80kt, thrust idle
• Brakes Push (at 40-50kt)
--- Note: auto-break now disabled ---
• Runway Vacate („rwy vacated“)
Taxi:
• Transponder Stdby
• Hand-off TWR to GND Change frequency
• Taxiways Note and follow
• ( Ground-Guidance Request if required )
• Flaps Set 0
• Speedbrake Disengage (if engaged)
• Autobrakes Off
• Landing lights Off
• Strobe Off
• Landing time Note (if needed)
• APU Master On
• APU Start On
Parking Position:
• Parking brake Set
• ATC contact End (state “on blocks”)
• All ENG Master switches Off
• Fuel pumps Off
• Seatbelts Off
• Door s Open (shift + e)
• Gangway Enable (CTRL + j)
• Beacon lights Off
• Wing Lights Off
--- wait 1 minute ---
• External Power On
• APU Master Off
• Engine Anti Ice Off
• Wing Anti Ice Off
• Window Heat Off
• Flight Director Reset (Off ➔ On)
---if Dark & Cold is desired continue---
• TCAS Stdby
• Ground power Off
Intentionally Blank
A330-200 Attachments:
A330-200 Optimum & Maximum Flight Level Charts:
➔ Total fuel = Enough fuel for route, 1h contingency (holding & taxi), problematic
winds, alternate fuel for 200nm and a minimum landing fuel (1h). Modify alternate
value as needed.
➔ Load all wing tanks with same amount of fuel; inner tanks full ➔ outer tanks ➔
center tanks.
A330-300 Attachments:
A330-300 Optimum & Maximum Flight Level Charts:
➔ Total fuel = Enough fuel for route, 1h contingency (holding & taxi), problematic
winds, alternate fuel for 200nm and a minimum landing fuel (1h). Modify alternate
value as needed.
➔ Load all wing tanks with same amount of fuel; inner tanks full ➔ outer tanks ➔
center tanks.
A340-300 Attachments:
A340-300 Optimum & Maximum Flight Level Charts:
➔ Total fuel = Enough fuel for route, 1h contingency (holding & taxi), problematic
winds, alternate fuel for 200nm and a minimum landing fuel (1h). Modify alternate
value as needed.
➔ Load all wing tanks with same amount of fuel; inner tanks full ➔ outer tanks ➔
center tanks.
A340-600 Attachments:
A340-600 Optimum & Maximum Flight Level Charts:
➔ Total fuel = Enough fuel for route, 1h contingency (holding & taxi), problematic
winds, alternate fuel for 200nm and a minimum landing fuel (1h). Modify alternate
value as needed.
➔ Load all wing tanks with same amount of fuel; inner tanks full ➔ outer tanks ➔
center tanks.