Machine Terminals REM 543 REM 545: 1MRS751173-MBG
Machine Terminals REM 543 REM 545: 1MRS751173-MBG
1MRS751173-MBG
Design (cont´d)
11
Machine Terminals REM 543 REM 545
1MRS751173-MBG
12
Machine Terminals REM 543 REM 545
1MRS751173-MBG
13
Machine Terminals REM 543 REM 545
1MRS751173-MBG
The recording can be triggered by any (or several) of the alternatives listed below:
- triggering on the rising or falling edge of any (or several) of the digital inputs
- triggering on overcurrent, overvoltage or undervoltage
- manual triggering via the menu or with the push-button F on the front panel (if configured)
- triggering via serial communication or a parameter
- periodic triggering
The recording length depends on the number of recordings and inputs used. For example, the following
combination of recording length, number of recordings and number of inputs is available at 50 Hz:
recordings \ channels 1 3 10
1 1066 cyc. 399 cyc. 125 cyc.
21.3 s 7.9 s 2.5 s
5 212 cyc. 79 cyc. 25 cyc.
4.2 s 1.5 s 0.5 s
10 106 cyc. 39 cyc. 12 cyc.
2.1 s 0.7 s 0.24 s
14
Machine Terminals REM 543 REM 545
1MRS751173-MBG
15
Machine Terminals REM 543 REM 545
1MRS751173-MBG
16
Machine Terminals REM 543 REM 545
1MRS751173-MBG
17
Machine Terminals REM 543 REM 545
1MRS751173-MBG
Technical data (cont´d) Note! The values below apply when f/fn = 0.95...1.05
Operation accuracy 0.1...10 x In: ±2.5% of set value or ±0.01 x In
10...40 x In: ±5.0% of set value
±2.5% of measured voltage or ±0.01 x Un
±2q
Start time Injected currents > 2.0 x start current:
internal time < 42 ms
total time < 50 ms
Reset time 40...1000 ms (depends on the minimum pulse width set for
the trip output)
Reset ratio, typically 0.95
Retardation time < 45 ms
Operate time accuracy at DT mode ±2% of set value or ±20 ms
18
Machine Terminals REM 543 REM 545
1MRS751173-MBG
19
Machine Terminals REM 543 REM 545
1MRS751173-MBG
20