FPGA Board

Mimas V2 Spartan 6 FPGA Development
Board with DDR SDRAM

SKU: FPGA006
Features
 FPGA: Spartan XC6SLX9 in CSG324 package

 DDR Memory: 166MHz 512Mb LPDDR (MT46H32M16LF/W949D6CBHX6E)
 Flash memory: 16 Mb SPI flash memory (M25P16)
 USB 2.0 interface for On-board flash programming
 FPGA configuration via JTAG and USB
 VGA Connector, Stereo Jack
 3 x Seven Segment Displays
 32 IOs for user-defined purposes
Mimas – Spartan 6 FPGA Development

Board
SKU: FPGA002
Features
 FPGA: Spartan-6 XC6SLX9 in TQG144 package

 Flash memory: 16 Mb SPI flash memory (M25P16)
 100MHz CMOS oscillator
 USB 2.0 interface for On-board flash programming
 FPGA configuration via JTAG and USB
 70 IOs for user-defined purposes
 Onboard voltage regulators for single power rail operation
Papilio Pro
The Papilio Pro is an Open Source FPGA development board based on the Xilinx Spartan 6 LX FPGA. It
has 48 I/O lines, dual channel USB, integrated JTAG programmer, 64Mb SDRAM, and an efficient
switching power supply.
 Spartan 6 LX9 FPGA (Datasheet)

 High efficiency LTC3419 Step Down Dual Voltage Regulator (Datasheet)
 Dual Channel FTDI FT2232 USB 2.0 Full Speed Interface (Datasheet)
 64Mbit Micron MT48LC4M16 SDRAM (Datasheet)
 64Mbit Macronix MX25L6445 SPI Flash (Datasheet)
 48 I/O pins arranged in a Papilio Wing form factor
 32Mhz Crystal Oscillator
https://papilio.cc/index.php?n=Papilio.PapilioPro
DE1-SoC-MTL2
DE1-SoC Development Board
Cyclone V SE SoC—5CSEMA5F31C6N
 Dual-core ARM Cortex-A9 (HPS)

 85K programmable logic elements
 4,450 Kbits embedded memory
 6 fractional PLLs
 2 hard memory controllers
Configuration Sources
 Serial configuration device – EPCS128 for the FPGA

 On-board USB Blaster II (normal type B USB connector)
Memory Device
 64MB (32Mx16) SDRAM for the FPGA

 1GB (2x256MBx16) DDR3 SDRAM for the HPS
 microSD card socket for the HPS
Peripherals
 Two USB 2.0 Host Ports (ULPI interface with USB type A connector) on HPS
 UART to USB (USB Mini B connector)
 10/100/1000 Ethernet
 PS/2 mouse/keyboard
 IR emitter/receiver
 I2C multiplexer
Connectors
 Two 40-pin expansion headers

 One 10-pin ADC input header
 One LTC connector (one Serial Peripheral Interface (SPI) master ,one I2C bus, and one GPIO
interface)
Display
 24-bit VGA DAC
Audio
 24-bit CODEC, Line-in, line-out, and microphone-in jacks
Video Input
 TV decoder (NTSC/PAL/SECAM) and Video-in connector

ADC
 sample rate: 500 KSPS

 Channel number: 8
 Resolution: 12 bits
 Analog input range : 0 ~ 4.096 V
Switches, Buttons and LEDs
 5 user keys (4 for the FPGA and 1 for the HPS)

 10 user switches for the FPGA
 11 user LEDs (10 for the FPGA and 1 for the HPS)
 2 HPS reset buttons (HPS_RESET_n and HPS_WARM_RST_n)
 Six 7-segment displays
Sensors
 G-Sensor on HPS
Power
 12V DC input
Capacitive Multi-touch Screen
LCD Display
 7-inch TFT LCD with pixel resolution of 800*480

 16 million colors (8-bit RGB)
 LED backlight
Capacitive Muti-Touch
 Five points multi-touch

 I2C interface
 Gesture supporting
DE0-Nano Development and Education Board

DE0-Nano Development and Education Board
Cyclone® IV EP4CE22F17C6N FPGA
 22,320 Logic elements (LEs)

 594 Embedded memory (Kbits)
 66 Embedded 18 x 18 multipliers
 4 General-purpose PLLs
 153 Maximum FPGA I/O pins
Configuration Status and Set-Up Elements
 On-board USB-Blaster circuit for programming

 FPGA Serial Configuration Device (EPCS)
Expansion Header
 Two 40-pin Headers (GPIOs) provides 72 3.3V I/O pins

 Two 5V power pins, two 3.3V power pins and four ground pins
 One 26-pin header provides 16 3.3V digital I/O pins and 8 analog input pins to connect to
analog sensors, etc
Memory Devices
 32MB SDRAM
 2Kb I2C EEPROM
General User Input/Output
 8 green LEDs
 2 debounced push-buttons
 4 dip switches
G-Sensor
 ADI ADXL345, 3-axis accelerometer with high resolution (13-bit)
A/D Converter
 NS ADC128S022, 8-Channel, 12-bit A/D Converter

 50 ksps to 200 ksps
Clock System
 On-board 50MHz clock oscillator
Power Supply
 USB Type mini-AB port (5V)

 Two DC 5V pins of the GPIO headers (5V)
 2-pin external power header (3.6-5.7V)
Nexys3 Spartan-6 FPGA Board
 Xilinx Spartan6 XC6LX16-CS324
 16Mbyte Micron Cellular RAM, 16Mbyte Micron Parallel PCM, 16Mbyte Micron
Quad-mode SPI PCM
 10/100 SMSC LAN8710 PHY, USB-UART, Type-A USB host for mouse, keyboard
or memory stick
 8-bit VGA, 100MHz fixed-frequency oscillator, Four double-wide Pmod connectors,
one VHDC connector
 USB cable included

FPGA Board

Uploaded by

Copyright:

Available Formats

FPGA Board

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

FPGA Board

Uploaded by

Copyright:

Available Formats

Mimas V2 Spartan 6 FPGA Development

Board with DDR SDRAM

 FPGA: Spartan XC6SLX9 in CSG324 package

Mimas – Spartan 6 FPGA Development

 FPGA: Spartan-6 XC6SLX9 in TQG144 package

 Spartan 6 LX9 FPGA (Datasheet)

 Dual-core ARM Cortex-A9 (HPS)

 Serial configuration device – EPCS128 for the FPGA

 64MB (32Mx16) SDRAM for the FPGA

 Two 40-pin expansion headers

 24-bit VGA DAC

 24-bit CODEC, Line-in, line-out, and microphone-in jacks

 TV decoder (NTSC/PAL/SECAM) and Video-in connector

 sample rate: 500 KSPS

Switches, Buttons and LEDs

 5 user keys (4 for the FPGA and 1 for the HPS)

Capacitive Multi-touch Screen

 7-inch TFT LCD with pixel resolution of 800*480

 Five points multi-touch

DE0-Nano Development and Education Board

Cyclone® IV EP4CE22F17C6N FPGA

 22,320 Logic elements (LEs)

Configuration Status and Set-Up Elements

 On-board USB-Blaster circuit for programming

 Two 40-pin Headers (GPIOs) provides 72 3.3V I/O pins

General User Input/Output

 ADI ADXL345, 3-axis accelerometer with high resolution (13-bit)

 NS ADC128S022, 8-Channel, 12-bit A/D Converter

 On-board 50MHz clock oscillator

 USB Type mini-AB port (5V)

You might also like