Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Watertite TS 15

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Watertite TS 15

(Formerly known as Bitutape TS)

Twin sided adhesive bitumen tape


Non-reinforced twin side adhesive bitumen membrane.

CHARACTERISTICS
Watertite TS 15 is mainly used as an adhesive for the fixing
of Bituboard protecting boards to the Bitustick range of self
adhesive waterproofing membranes. Watertite TS 15 is also
ideal for sealing of pipe joints in concrete structures and
other corner joints.

TDS_Watertite TS 15_GCC_0519
self adhesive greate
adhesion

DESCRIPTION
Watertite TS 15 is a non-reinforced twin side adhesive
bitumen membrane which comprises of polymerized
bitumen sandwiched between a plastic release film on
either side.
1
APPLICATION INSTRUCTIONS
The substrate to which Watertite TS 15 needs to be applied
should be free of oil, water and dust. The presence of any
DISPOSAL
of these contaminants affects the adhesive properties of the Watertite TS 15 is a non-hazardous, non-flammable
membrane. Cut the membrane into the desired width and material and therefore can be disposed to in any regular
length and stick it on to the surface. Remove the release disposal areas. Watertite TS 15 should be disposed on
film form the order side and then stick the boards on place. after wrapping with paper, plastic or clothe as the modified
material has tendency to soften under heat and pressure,
HANDLING which would make further handling very tough.
Watertite TS 15 are supplied in rolls of 10 m length and 50
mm width. The membranes can be unloaded by hand or
HEALTH AND SAFETY
other convenient means, but making sure the absence of Watertite TS 15 contains a tacky Bitumen compound which
any protruded sharp edges nearby to avoid punctures. while applied can adhere to human skin. Such stains of
Bitumen can be removed by using a cloth dipped in light
STORAGE solvents. Incase the effected area is sensitive like the eye
Watertite TS 15 range of tapes have to be stored in a please contact the company physician for advice.
shaded are on wooden pallets neatly covered by any thick
fabric like tarpaulin sheets tied and secured properly to
ensure no excessive exposure to sunlight.
TECHNICAL PROPERTIES Apart from the information given here it is also important to observe the relevant
guidelines and regulations of various organisations and trade associations as
Roll length, [m] 10 well as the respective standards. The aforementioned characteristics are based
on practical experience and applied testing. Warranted properties and possible
Roll Width, [mm] 50/100/150/200/1000 uses which go beyond those warranted in this information sheet require our
(other sizes available written confirmation. All data given was obtained at an ambient and material
on request) temperature of +23°C and 50 % relative air humidity at laboratory conditions
unless specified otherwise. Please note that under other climatic conditions
Thickness, [mm] 1.5 hardening can be accelerated or delayed.
The information contained herein, particularly recommendations for the
Softening Point, [°C] >105 handling and use of our products, is based on our professional experience.
Elongation, [%] ≥1000 As materials and conditions may vary with each intended application, and
thus are beyond our sphere of influence, we strongly recommend that in each
Hydrostatic pressure case sufficient tests are conducted to check the suitability of our products
@ 5 bar No leakage for their intended use. Legal liability cannot be accepted on the basis of the
contents of this data sheet or any verbal advice given, unless there is a case
of wilful misconduct or gross negligence on our part. This technical data sheet
supersedes all previous editions relevant to this product.
TDS_Watertite TS 15_GCC_0519

Henkel Polybit Industries Ltd.; PO Box: 293, Umm Al Quwain, UAE


Tel:+971(6)76 70 777; Fax:+971(6)76 70 197; henkelpolybit@henkel.com
Henkel Polybit Industries Ltd.; PO Box: 5911, Dammam-31432, KSA
Tel:+96613808 4061 / 62, Fax: +966 13 812 1164; polybitdammam@henkel.com
www.henkelpolybit.com

You might also like