SKN 5

1.
The ideal Am-meter should have ________________

(a) zero resistance
(b) high resistance
(c) infinite resistance
(d) small resistance
2. The sensitivity of Galvanometer can be increased by ______________
I. increasing the number turns
II. increasing the area of coil
III. Increasing the strength of magnetic field
(a) I only
(b) II only
(c) III only
(d) I & III only
(e) I, II & III only
3. Rank the following instrument as per high resistance
1. galvanometer
2. Am-meter
3. Voltmeter
(a) 1, 2, 3
(b) 3,1,2
(c) 2,3,1
(d) 3,2,1
4. which of the following is known as ideal volt meter
(a) wheat stone bridge
(b) potentiometer
(c) AVO meter
(d) meter bridge
5. The length of wire used in meter bridge is _______
(a) 1meter
(b) 2 meter
(c) 3 meter
(d) 4 meter
6. A Galvanometer can be converted into volt-meter by _______
(a) connecting high resistance in series with it
(b) connecting low resistance in series with it
(c) connecting low resistance in parallel with it
(d) connecting high resistance in parallel with it
7. ________________useful device for rapid measurement of resistance. It consists of a
galvanometer, and adjustable resistance r, and a cell connected in series.
(a) ohm meter
(b) wheat stone bridge
(c) Potentio meter
(d) volt meter
8. The resistance of voltmeter must have very high resistance because
a. It does not draw any current
b. It is very accurate
c. It does not change circuit current considerably
d. None of these
9. A voltmeter has resistance of 2000 ohms and it can measure up to 2V. if we want to
increase its range to 10V then required resistance in series will be
a. 2000 Ώ
b. 4000 Ώ
c. 6000 Ώ
d. 8000 Ώ
10. The resistances of three arms of the balanced wheat stone bridge are 50 ohm, the
resistance in the 4th arm is
a. 25 ohm
b. 50ohm
c. 75ohm
d. 100ohm
11. A wheat stone bridge has the resistances 10ohm, 10ohm, 10ohm, and 30ohm in
its four arms. What resistance joined in parallel to the 30 ohm resistance will bring it to the
balanced condition?
a. 2 ohm
b. 5 ohm
c. 10 ohm
d. 15 ohm
12. A galvanometer give deflection of 150 at a current of 15mA, when current it in is
20A it produce a deflection of :
(a) 100
(b) 200
(c) 300
(d) 250
13. which of the following work(s) on the principle of wheat stone bridge
I. Meter bridge
II. Ohm meter
III. Post office box
IV. Potentiometer
(a) I only
(b) I & III only
(c) I , II & III only
(d) I, III & IV only
14. AVO meter is used to measure __________
(a) current
(b) voltage
(c)resistance
(d) A.O.T
15. Sensitivity of potentiometer can be increased by _______
(a) increasing the length of the potentiometer
(b) decreasing the length of potentiometer wire
(c) increasing the emf of cell
(d) using sensitive galvanometer
16. internal resistance of cells can be determine by using _______
(a) ohm meter
(b) volt meter
(c)potentio meter
(d) ampere meter
17. In meter bridge the balancing length from the left end (standard resistance of one
ohm is in the right gap) is found to be 20cm , then unknow resistance is
(a) 0.25 ohm
(b) 0.5 ohm
(c) 0.75 ohm
(d) 2 ohm
18. The wire used in meter bridges and potentio meter are always of ________
(a) Constantin
(b) Copper
(c) tungsten
(d) Aluminum
19. The speed of _______________________ depends up on permeability and permittivity
of medium
(a) Mechanical wave
(b) Sound wave
(c) electromagnetic waves
(d) A.O.T
20. The speed of electromagnetic wave is _________ the speed of light
(a) same
(b) less than
(c)greater than
(d) double than
21 .We should expect radiation only, when charges are ___________
(I) in rest
(II) moving with constant velocity
(III) are accelerated
(a) I & III only
(b) I & II only
(c) III only
(d) II & III Only
22. The process of combining audio frequency (a-f) and radio frequency (r-f) waves to
accomplish translation is known as _______________
(a) doping
(b) oscillation
(c) rectification
(d) modulation
23. _______________ types of modulations can be advised .
(a) 2
(b) 3
(c) 4
(d) 5
24. FM broadcast transmitters operate at frequencies of ____________
(a) 20 Hz to 20000Hz
(b) 88 MHz to 108 MHz
(c) 50 MHz to 108 MHZ
(d) 120 Mhz to 135 Mhz
25.Through __________ the electrical properties of semiconductors are changed
(a) rising temperature
(b) doping
(c) amplification
(d) rectification
26. The study of the geometric form of crystalline solids by using X-rays, electron or
neutron beams constitute a science known as _______
(a) crystal lattice
(b) unit cell
(c) electroluminescence
(d) crystallography
27. There are two special purpose diode
I. LED II. Photo diode
Which of the following choice gives their mode of operation
I II
A Forward biased Forward biased
B Reversed biased Forward biased
C Forward biased Reversed biased
D Reversed biased Reversed biased
28. When p-n junction diode is forward biased then

(a) both the depletion region and barrier height are reduced.
(b) the depletion region is widened and barrier height is reduced.
(c) the depletion region is reduced and barrier height is increased.
(d) both the depletion region and barrier height are increased.
29. The valency of an impurity element added to germanium crystal in order to convert in into
P-type semiconductor is
(a) 6 (b) 5
(c) 4 (d) 3.
30. An intrinsic semiconductor at absolute zero of temperature behaves as
(a) an insulator. (b) a metallic conductor.

(c) a superconductor. (d) a semiconductor.
31. The part of a transistor which is most heavily doped to produce large number of majority
carriers is
(a) emitter
(b) base
(c) collector
(d) A.O.T
32. The arrow of transistor shows the direction of _________
(a) electronic current
(b) conventional current
(c) both a and b
(d) N.O.T
33. The transistor has two junctions
I. Emitter- base
II. Collector – base
For operation of transistor , which choice is correct
I II
A Forward biased Forward biased
B Reversed biased Forward biased
C Forward biased Reversed biased
D Reversed biased Reversed biased
34. which of following is known as transistor equation
(a) IE = IB + IC
(b) IB = IC + IE
(c) IC = IB + IE
(d) N.O.T
35. Semiconductor are __________
(a) Trivalent
(b) Penta valent
(c) Tetravalent
(d) both b and c
36. A diode is said to forward biased , if
(a) anode is connected to + and cathode is connected to – of battery
(a) anode is connected to - and cathode is connected to + of battery
(a) anode is connected to + and cathode is connected to +of battery
(a) anode is connected to - and cathode is connected to – of battery
37. A device which convert alternating current into direct current is known as
(a) amplifier
(b) commutator
(c) rectifier
(d) oscillator
38. The transistor has ________ terminals
(a) 2
(b) 3
(c) 4
(d) 5
39. The process by which the potential barrier of the depletion region can be increased or
decreased is called
A. Amplifier
B. Biasing
C. Modulation
D. Doping
40. AC voltage is passed through single diode rectifier, the output of the bridge rectifier is?
a. Full wave DC voltage

b. Half wave DC voltage
c. Double frequency AC voltage
d. None

SKN 5

Uploaded by

Copyright:

Available Formats

SKN 5

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

SKN 5

Uploaded by

Copyright:

Available Formats

1.

The ideal Am-meter should have ________________

28. When p-n junction diode is forward biased then

(a) an insulator. (b) a metallic conductor.

a. Full wave DC voltage

You might also like