Exp-8 Staircase Wiring
Exp-8 Staircase Wiring
Exp-8 Staircase Wiring
UNIVRSI7
Name of Laboratory: Basic Electrical Engineering Lab
Lab Subject Code :BEEE101P
Nameof School :SELECT
Materials Required
4x 3.5 1 No.
Wooden Board
1 sq. mm" As required
Wires
Tools Required
Screw driver, Wire stripper, Hacksaw, combination plier, drilling machine, electrician knife.
Theory
In this wiring, a single lamp is controlled from two places. For this purpose two numbers of two way
switches are used. This wiring which makes use of 2 switches to operate bulb at the beginning of the stair lights
and the bulb gives off by pushing the buton in the end. One of the teminals of the bulb is conected to the
main line whose power line is connected to midle slot of two-way switch. Remaining first of these slots is
connected in parallel as in crossed node.
Procedure
1. Collect the materials required for this experiment.
2. Draw the layout of the given circuit diagram in the circuit board.
3. Fix the necessary materials, by using drilling machine in the layout board.
4. One end of the lamp holder is connected to neutral point and another point is connected at the
center of the two-way switch ($2)
5. The center of the switch (S1) is connected to the phase line.
6. The connection of the other two ends of wo-way switch is connected as follows. The point 1 of switch
s1 is connected to point 1 of switch $2 and point 2 of S1 is connected to point 2 of $2.
7. The given lamp is fixed on the lamp holders.
8. Test the Circuit for all possible combination of switch positlons.
Precautions
9
VIT
Name of
Laboratory
Lab Subject Code Bask Electrical
Engineering lab
Name of School :BEEE101P
SELECT
5 When
disassembing a circuit, frst remove the source of
power
Fuse Rating Catculations
Circuit Diagram
$1 -O 230V, 25 Ww
O- Lamp
2
N
S1, $2 2-way switche
10
Name of Laboratory: Basic Electrical Engineering Lab VIT
Lab Subject Code :BEEE101P
Name of School SELECT
Circuit Diagram
L
$1 S2
Observation
1 ON1 1 ON
2 OFF
| 2 OFF
2 OFF
2 1 |oFF
22ON2 2 0N
Result
11