Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 7 views

    Design of Structures QSTN PPR

    Uploaded by

    faychidaks

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Design of Structures QSTN PPR

    Uploaded by

    faychidaks
    7 views4 pages

    Original Title

    Design of Structures Qstn Ppr

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    7 views4 pages

    Design of Structures QSTN PPR

    Uploaded by

    faychidaks

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 4

    NATIONAL UNIVERSITY OF SCIENCE AND TECHNOLOGY

    DEPARTMENT OF CIVIL AND WATER ENGINEERING


    FACULTY OF INDUSTRIAL TECHNOLOGY
    BACHELOR OF ENGINEERING (HONOURS) DEGREE
    PART V FIRST SEMESTER EXAMINATION- DECEMBER 2006
    DESIGN OF STRUCTURES II – TCW 5102

    INSTRUCTIONS

    Answer All Questions


    Open Book Examination Time: 4hours
    Total Marks:100

    QUESTION ONE

    Analyse the continuous beam for the three load cases shown in Figure 1.0. Draw the
    separate shear force and bending moment diagram for ultimate loads. Construct the
    maximum shear force and bending moment envelopes.
    Assume characteristic dead load gk = 20.0 kN/m; TL – Total Load
    characteristic imposed load qk = 10.0 kN/m DL – Dead Load

    Case 1.0 TL TL TL
    Case 2.0 DL TL DL
    Case 3.0 TL DL TL

    8000 6000 8000

    Figure 1.0
    Marks 30

    QUESTION TWO

    Design the end span of the continuous beam analysed in Question One. The materials are
    grade 30 concrete and grade 460 and 250 reinforcement. Assume cover to reinforcement as
    30 mm
    Marks 20

    1
    QUESTION THREE

    Design a single angle tie to carry a characteristic dead load of 80kN and a characteristic
    imposed load of 35 kN and connected by
    (a) welded connection – connected by long leg
    (b) bolted connection – connected by long leg
    Material : Use Grade 43 steel

    Marks25

    QUESTION FOUR

    ( a ) Design an angle purlin for a roof with slope of 1 in 2.5. The purlins are simply
    supported and span 5.0m between roof trusses. The purlins are at 1.6m centers. The
    characteristic dead load, including self weight of purlin, is 0.35 kN/m2 on the slope
    and the characteristic imposed load is 0.75 kN/m2 on plan. Use Grade 43 steel.
    Marks 15
    (b)Design the purlin using the empirical method from BS 5950
    Marks 10

    2
    3
    4

    You might also like