plantar flexion
Recently Published Documents

Time-dependent measures consisting of rate of torque development (RTD), rate of velocity development (RVD), and rate of neuromuscular activation can be used to evaluate explosive muscular performance, which becomes critical when performing movements throughout limited ranges of motion (ROM). Using a HUMAC NORM dynamometer, seven males (27 ± 7 years) and six females (22 ± 3 years) underwent 8 weeks of maximal isometric dorsiflexion training 3 days/week. One leg was trained at 0° (short-muscle tendon unit (MTU) length) and the other at 40° of plantar flexion (long-MTU length). RTD and rate of neuromuscular activation were evaluated during 'fast' maximal isometric contractions. Power, RVD, and rate of neuromuscular activation were assessed during maximal isotonic contractions in four conditions (small (40° to 30° of plantar flexion) ROM at 10 and 50% MVC; large (40° to 0° of plantar flexion) ROM at 10 and 50% MVC) for both legs, pre- and post-training. Despite no change in rate of neuromuscular activation following training, peak power, RTD, and RVD increased at both MTU lengths (p < 0.05). Strong relationships (R2=0.73) were observed between RTD and peak power in the small ROM, indicating that fast time-dependent measures are critical for optimal performance when ROM is constrained. Meanwhile, strong relationships (R2=0.90) between RVD and power were observed at the 50% load, indicating that RVD is critical when limited by load and ROM is not confined. Maximal isometric dorsiflexion training can be used to improve time-dependent measures (RTD, RVD) to minimize power attenuation when ROM is restricted.

Background: This study aimed to evaluate the effects of the ankle flexion angle during anterior talofibular ligament (ATFL) reconstruction on ankle kinematics, laxity, and in situ force of a graft. Methods: Twelve cadaveric ankles were evaluated using a 6–degrees of freedom robotic system to apply passive plantar flexion and dorsiflexion motions and multidirectional loads. A repeated measures experiment was designed using the intact ATFL, transected ATFL, and reconstructed ATFL. During ATFL reconstruction (ATFLR), the graft was fixed at a neutral position (ATFLR 0 degrees), 15 degrees of plantar flexion (ATFLR PF15 degrees), and 30 degrees of plantar flexion (ATFLR PF30 degrees) with a constant initial tension of 10 N. The 3-dimensional path and reconstructed graft tension were simultaneously recorded, and the in situ force of the ATFL and reconstructed grafts were calculated using the principle of superposition. Results: The in situ forces of the reconstructed grafts in ATFLR 0 degrees and ATFLR PF 15 degrees were significantly higher than those of intact ankles. The ankle kinematics and laxity produced by ATFLR PF 30 degrees were not significantly different from those of intact ankles. The in situ force on the ATFL was 19.0 N at 30 degrees of plantar flexion. In situ forces of 41.0, 33.7, and 21.9 N were observed at 30 degrees of plantar flexion in ATFLR 0, 15, and 30 degrees, respectively. Conclusion: ATFL reconstruction with the peroneus longus (PL) tendon was performed with the graft at 30 degrees of plantar flexion resulted in ankle kinematics, laxity, and in situ forces similar to those of intact ankles. ATFL reconstructions performed with the graft fixed at 0 and 15 degrees of the plantar flexion resulted in higher in situ forces on the reconstructed graft. Clinical Relevance: Fixing the ATFL tendon graft at 30 degrees of plantar flexion results in an in situ force closest to that of an intact ankle and avoids the excessive tension on the reconstructed graft.

Common in-lab, marker-based gait analyses may not represent daily, real-world gait. Real-world gait analyses may be feasible using inertial measurement units (IMUs), especially with recent advancements in open-source methods (e.g., OpenSense). Before using OpenSense to study real-world gait, we must determine whether these methods: (1) estimate joint kinematics similarly to traditional marker-based motion capture (MoCap) and (2) differentiate groups with clinically different gait mechanics. Healthy young and older adults and older adults with knee osteoarthritis completed this study. We captured MoCap and IMU data during overground walking at self-selected and faster speeds. MoCap and IMU kinematics were computed with appropriate OpenSim workflows. We tested whether sagittal kinematics differed between MoCap- and IMU-derived data, whether tools detected between-group differences similarly, and whether kinematics differed between tools by speed. MoCap data showed more flexion than IMU data (hip: 0-47 and 65-100% stride, knee: 0-38 and 58-91% stride, ankle: 18-100% stride). Group kinematics differed at the hip (young extension > knee osteoarthritis at 30-47% stride) and ankle (young plantar flexion > older healthy at 62-65% stride). Group-by-tool interactions occurred at the hip (61-63% stride). Significant tool-by-speed interactions were found, with hip and knee flexion increasing more for MoCap than IMU data with speed (hip: 12-15% stride, knee: 60-63% stride). While MoCap- and IMU-derived kinematics differed, our results suggested that the tools similarly detected clinically meaningful differences in gait. Results of the current study suggest that IMU-derived kinematics with OpenSense may enable the valid and reliable evaluation of gait in real-world, unobserved settings.

Background Following stretch of an active muscle, muscle force is enhanced, which is known as residual force enhancement (rFE). As earlier studies found apparent corticospinal excitability modulations in the presence of rFE, this study aimed to test whether corticospinal excitability modulations contribute to rFE. Methods Fourteen participants performed submaximal plantar flexion stretch-hold and fixed-end contractions at 30% of their maximal voluntary soleus muscle activity in a dynamometer. During the steady state of the contractions, participants either received subthreshold or suprathreshold transcranial magnetic stimulation (TMS) of their motor cortex, while triceps surae muscle responses to stimulation were obtained via electromyography (EMG), and net ankle joint torque was recorded. B-mode ultrasound imaging was used to confirm muscle fascicle stretch during stretch-hold contractions in a subset of participants. Results Following stretch of the plantar flexors, an average rFE of 7% and 11% was observed for contractions with subthreshold and suprathreshold TMS, respectively. 41–46 ms following subthreshold TMS, triceps surae muscle activity was suppressed by 19–25%, but suppression was not significantly different between stretch-hold and fixed-end contractions. Similarly, the reduction in plantar flexion torque following subthreshold TMS was not significantly different between contraction conditions. Motor evoked potentials, silent periods and superimposed twitches following suprathreshold TMS were also not significantly different between contraction conditions. Discussion As TMS of the motor cortex did not result in any differences between stretch-hold and fixed-end contractions, we conclude that rFE is not linked to changes in corticospinal excitability.

Purpose: This study aimed to determine whether triceps surae’s muscle architecture and Achilles tendon parameters are related to running metabolic cost (C) in trained long-distance runners.Methods: Seventeen trained male recreational long-distance runners (mean age = 34 years) participated in this study. C was measured during submaximal steady-state running (5 min) at 12 and 16 km h–1 on a treadmill. Ultrasound was used to determine the gastrocnemius medialis (GM), gastrocnemius lateralis (GL), and soleus (SO) muscle architecture, including fascicle length (FL) and pennation angle (PA), and the Achilles tendon cross-sectional area (CSA), resting length and elongation as a function of plantar flexion torque during maximal voluntary plantar flexion. Achilles tendon mechanical (force, elongation, and stiffness) and material (stress, strain, and Young’s modulus) properties were determined. Stepwise multiple linear regressions were used to determine the relationship between independent variables (tendon resting length, CSA, force, elongation, stiffness, stress, strain, Young’s modulus, and FL and PA of triceps surae muscles) and C (J kg–1m–1) at 12 and 16 km h–1.Results: SO PA and Achilles tendon CSA were negatively associated with C (r2 = 0.69; p &lt; 0.001) at 12 km h–1, whereas SO PA was negatively and Achilles tendon stress was positively associated with C (r2 = 0.63; p = 0.001) at 16 km h–1, respectively. Our results presented a small power, and the multiple linear regression’s cause-effect relation was limited due to the low sample size.Conclusion: For a given muscle length, greater SO PA, probably related to short muscle fibers and to a large physiological cross-sectional area, may be beneficial to C. Larger Achilles tendon CSA may determine a better force distribution per tendon area, thereby reducing tendon stress and C at submaximal speeds (12 and 16 km h–1). Furthermore, Achilles tendon morphological and mechanical properties (CSA, stress, and Young’s modulus) and triceps surae muscle architecture (GM PA, GM FL, SO PA, and SO FL) presented large correlations with C.

BACKGROUND: The effects of a long-term static stretching program on physical performance parameters have not been elucidated completely, although the effects on muscle flexibility have a consensus. OBJECTIVE: This study aimed to investigate the effect of a long-term static stretching program on physical performance and muscle properties. METHODS: Participants performed a 2-min static stretching for the ankle joint 5 times per week for 4 weeks. Physical performance and muscle properties was measured before and after the static stretching program. RESULTS: Results showed that range of motion (ROM), dynamic postural stability, and muscle hardness were positively changed, whereas other variables i.e. maximal isometric plantar flexion moment, jump heights, muscle-tendon junction displacement and its angle, were not. CONCLUSIONS: Four-week of SS program may improve ROM, dynamic postural stability, and muscle hardness without decreasing physical performance.

There are two techniques for a lateral sprint start: crossover (CS) and jab step (JS) starts. This study aimed to elucidate the difference in the CS and JS starts in terms of sprint performance and leg kinetics in athletes from ball-and-goal type sports (e.g. soccer and handball). Nineteen male athletes performed CS and JS starts, during which their motion and the force they applied to the ground were simultaneously recorded using a motion-capture system and two force platforms. The results showed that, although 5-m time via video analysis did not differ between CS and JS starts, forward velocity of centre of gravity (CG) and normalised average horizontal external power were greater for the JS start than the CS start. From waveform analysis, greater positive joint power in the sagittal plane leading to greater positive work in the JS start were found in the first three quarters of the push-off phase for rear hip extension and in the subsequent push-off phase for rear ankle plantar flexion. In conclusion, the results suggest that the JS start is superior to the CS start for start quickness, though the gains in the start did not appear to transfer to the 5-m performance. Moreover, greater positive joint power in the first three quarters of the push-off phase for the rear hip extension and in the subsequent push-off phase for the rear ankle plantar flexion were considered to be important contributing factors to the better performance of the JS start.

Custom-made dynamometry was shown to objectively analyze human muscle strength around the ankle joint with accuracy, easy portability and low costs. This paper describes the full method of calibration and measurement setup and the measurement procedure when capturing ankle torque for establishing reliability of a portable custom-built electronic dynamometer. After considering the load cell offset voltage, the pivotal position was determined, and calibration with loads followed. Linear regression was used for calculating the proportionality constant between torque and measured voltage. Digital means were used for data collection and processing. Four healthy consenting participants were enrolled in the study. Three consecutive maximum voluntary isometric contractions of five seconds each were registered for both feet during plantar flexion/dorsiflexion, and ankle torque was then calculated for three ankle inclinations. A calibration procedure resulted, comprising determination of the pivotal axis and pedal constant. Using the obtained data, a measurement procedure was proposed. Obtained contraction time graphs led to easier filtering of the results. When calculating the interclass correlation, the portable apparatus demonstrated to be reliable when measuring ankle torque. When a custom-made dynamometer was used for capturing ankle torque, accuracy of the method was assured by a rigorous calibration and measurement protocol elaboration.

The purpose of this study was to investigate the effect of a 12-week ankle-specific block progression training program on saut de chat leaping performance [leap height, peak power (PP), joint kinetics and kinematics], maximal voluntary isometric plantar flexion (MVIP) strength, and Achilles tendon (AT) stiffness. Dancers (training group n = 7, control group n = 7) performed MVIP at plantarflexed (10◦) and neutral ankle positions (0◦) followed by ramping isometric contractions equipped with ultrasound to assess strength and AT stiffness, respectively. Dancers also performed saut de chat leaps surrounded by 3-D motion capture atop force platforms to determine center of mass and joint kinematics and kinetics. The training group then followed a 12-week ankle-focused program including isometric, dynamic constant external resistance, accentuated eccentric loading, and plyometric training modalities, while the control group continued dancing normally. We found that the training group's saut de chat ankle PP (59.8%), braking ankle stiffness (69.6%), center of mass PP (11.4%), and leap height (12.1%) significantly increased following training. We further found that the training group's MVIP significantly increased at 10◦ (17.0%) and 0◦ (12.2%) along with AT stiffness (29.6%), while aesthetic leaping measures were unchanged (peak split angle, mean trunk angle, trunk angle range). Ankle-specific block progression training appears to benefit saut de chat leaping performance, PP output, ankle-joint kinetics, maximal strength, and AT stiffness, while not affecting kinematic aesthetic measures. We speculate that the combined training blocks elicited physiological changes and enhanced neuromuscular synchronization for increased saut de chat leaping performance in this cohort of dancers.