Nissaninfiniti Re5r05a
Nissaninfiniti Re5r05a
Nissaninfiniti Re5r05a
BACK
Figure 1
23 28 38 26 27 25 29 37 30 31 33 32 34 35 36 24
BACK
Figure 2
3 23 4 5 7 8 10 9 6
BBACAKCK
Figure 3
There Are 4 Valve Body Screens That "Must" Go In As Shown, As They Pilot Into Spacer Plate
Check Valve "A" (Drainback) Check Valve "B" (Reverse Brake)
BALL DIAMETER .312" BALL DIAMETER .312" .350" .705" .285" .316" .016" .039" 5 11 SPRING FREE LENGTH SPRING FREE LENGTH SPRING DIAMETER SPRING DIAMETER WIRE DIAMETER WIRE DIAMETER APPROX COILS APPROX COILS
BACK
Figure 5
09-07
Page 5 of 12 1st design RE5R05A, UPPER VALVE BODY CHECK BALLS
Forward Brake Clutch Reverse Brake Clutch Low Coast Brake Clutch 5 Steel Check Balls Required 5.5mm (.218") Diameter Copyright 2009 ATSG
Figure 4
BACK
Figure 6
23 LOWER VALVE BODY CASTING. 24 SPACER PLATE AND BONDED GASKETS CODE "BC". 25 UPPER VALVE BODY CASTING. 26 MANUAL VALVE BODY CASTING. 27 CHECK VALVE "C" (FORWARD BRAKE). 28 MANUAL VALVE. 29 FORWARD ENGAGEMENT ACCUMMULATOR. 30 LINE PRESSURE SOLENOID. 31 TORQUE CONVERTER CLUTCH SOLENOID. 32 DIRECT CLUTCH SOLENOID. 33 FRONT BRAKE BAND SOLENOID.
34 INPUT CLUTCH SOLENOID. 35 HIGH & LOW REVERSE CLUTCH SOLENOID. 36 LOW COAST BRAKE CLUTCH SOLENOID. 37 SOLENOID RETAINING BOLT (7 REQUIRED). 38 OIL PUMP SCREEN. 23 25 26 27 28 29 37 24 30 31 32 33 34 35 36
BACK
Figure 7
09-07
Page 7 of 12
1 2 3 23 4 5 6 7 8 10 9 11 12 13 14 15 17 18 19 20 21 22 16 1 CHECK VALVE "A" (DRAINBACK). 2 VALVE BODY SCREENS (5 REQUIRED). 3 CHECK VALVE "B" (REVERSE BRAKE). 4 REVERSE BRAKE CLUTCH PRESSURE CONTROL VALVE. 5 DIRECT CLUTCH SWITCH VALVE. 6 DIRECT CLUTCH PRESSURE CONTROL VALVE. 7 INPUT CLUTCH PRESSURE CONTROL VALVE. 8 HIGH AND LOW REVERSE CLUTCH PRESSURE CONTROL VALVE. 9 TORQUE CONVERTER CLUTCH CONTROL VALVE. 10 TORQUE CONVERTER LUBRICATION SWITCH VALVE. 11 COOLER BYPASS VALVE.
12 LINE PRESSURE RELIEF VALVE. 13 TORQUE CONVERTER REGULATOR VALVE. 14 LINE PRESSURE REGULATOR VALVE. 15 FRONT BRAKE BAND PRESSURE CONTROL VALVE. 16 ACCUMMULATOR PRESSURE CONTROL VALVE. 17 PILOT VALVE "A". 18 PILOT VALVE "B". 19 LOW COAST BRAKE SWITCH VALVE. 20 LOW COAST BRAKE REDUCING VALVE. 21 NEUTRAL TO REVERSE ACCUMMULATOR. 22 NEUTRAL TO REVERSE ACCUMMULATOR. 23 LOWER VALVE BODY CASTING.
BACK
Figure 8
09-07
Page 8 of 12
Check Valve "B" Check Valve "A"
There Are 5 Valve Body Screens That "Must" Go In As Shown, As They Pilot Into Spacer Plate
Check Valve "A" Drainback Check Valve "B" Reverse Brake
BALL DIAMETER .312" BALL DIAMETER .312" .350" .705" .285" .316" .016" .039" 5 11 SPRING FREE LENGTH SPRING FREE LENGTH SPRING DIAMETER SPRING DIAMETER WIRE DIAMETER WIRE DIAMETER APPROX COILS APPROX COILS
BACK
Figure 9 Figure 10
2nd design RE5R05A, UPPER VALVE BODY CHECK BALLS 2nd design RE5R05A, MANUAL VALVE BODY
Forward Brake Clutch Low Coast Brake Clutch Reverse Brake Clutch Copyright 2009 ATSG Copyright 2009 ATSG
BACK
.029" Built In Orifice Regulated Oil From Pilot Valve
ON
Solenoid Pressure Port Blocked
X Blocked X Open
09-07
Page 10 of 12
BACK
ON
Solenoid Pressure Port Blocked
X Blocked X open Figure 12 LINE PRESSURE, TCC & FRONT BRAKE CONTROL SOLENOIDS .029" Built In Orifice Regulated Oil From Pilot Valve
09-07
Page 11 of 12
BACK
ON
Pressure Blocked
Figure 13 LOW COAST BRAKE SOLENOID Solenoid Resistance is approximately 11-15 or 20-40 ohms across the 2 solenoid terminals
09-07
Page 12 of 12
Solenoid Pressure
BACK