LM358

UNISONIC TECHNOLOGIES CO.
, LTD LM358
DUAL OPERATIONAL AMPLIFIER
DESCRIPTION
LINEAR INTEGRATED CIRCUIT
The UTC LM358 consists of two independent high gain, internally frequency compensated operational amplifier. It can be operated from a single power supply and also split power supplies.
FEATURES
*Internally frequency compensated for unity gain. *Wide power supply range 3V - 32V. *Input common-mode voltage range include ground. *Large DC voltage gain.
ORDERING INFORMATION
Ordering Number Lead Free LM358L-D08-T LM358L-G09-T LM358L-P08-R LM358L-P08-T LM358L-S08-R LM358L-S08-T LM358L-SM1-R LM358L-SM1-T Halogen-Free LM358G-D08-T LM358G-G09-T LM358G-P08-R LM358G-P08-T LM358G-S08-R LM358G-S08-T LM358G-SM1-R LM358G-SM1-T Package DIP-8 SIP-9 TSSOP-8 TSSOP-8 SOP-8 SOP-8 MSOP-8 MSOP-8 Packing Tube Tube Tape Reel Tube Tape Reel Tube Tape Reel Tube
www.unisonic.com.tw Copyright 2011 Unisonic Technologies Co., Ltd
1 of 7
QW-R105-001,O
LM358
PIN DESCRIPTION
SOP-8/DIP-8/MSOP-8/TSSOP-8
SIP-9
1 VCC
9 VCC
OUT1 IN1(-) IN1(+) GND
IN2(+) IN2(-) OUT2
UNISONIC TECHNOLOGIES CO., LTD

www.unisonic.com.tw
2 of 7
QW-R105-001,O
LM358
BLOCK DIAGRAM

www.unisonic.com.tw
3 of 7
QW-R105-001,O
LM358
ABSOLUTE MAXIMUM RATINGS
PARAMETER SYMBOL RATINGS UNIT Supply Voltage VCC 16 or 32 V Differential Input Voltage VI(DIFF) 32 V Input Voltage VI -0.3 ~ +32 V Output Short to Ground Continuous SIP-9 750 DIP-8 625 Power Dissipation SOP-8 PD 440 mW TSSOP-8 360 MSOP-8 300 Junction Temperature TJ +125 C Operating Temperature TOPR -40 ~ +85 C Storage Temperature TSTG -65 ~ +150 C Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied.
ELECTRICAL CHARACTERISTICS (VCC=5.0V, VEE=GND, TA=25, unless otherwise specified

PARAMETER SYMBOL VI(OFF) VI(CM) VI(DIFF) VOH VOL TEST CONDITIONS VCM=0V toVCC-1.5V VO(P)=1.4V, RS=0 VCC=30V VCC=30V, RL=2K VCC=30V, RL=10K VCC=5V, RL10K VCC=15V, RL2K VO(P)=1V ~ 11V RL=, VCC=30V RL=, Full Temperature Range MIN TYP 2.0 0 26 27 25 MAX 5.0 VCC-1.5 VCC 28 5 100 0.8 0.5 5 45 40 10 10 12 65 65 f=1KHZ ~ 20KHZ 30 15 100 80 100 120 2.0 1.2 50 250 60 UNIT mV V V V V mV V/mV mA mA nA nA mA mA mA A dB dB dB
Input Offset Voltage Input Common Mode Voltage Differential Input Voltage Output Voltage Swing Large Signal Voltage Gain Power Supply Current Input Offset Current Input Bias Current Short Circuit Current to Ground
20
GV ICC II(OFF) II(BIAS) ISC ISOURCE
Output Current ISINK Common Mode Rejection Ratio Power Supply Rejection Ratio Channel Separation CMRR PSRR CS
VI(+)=1V, VI(-)=0V VCC=15V, VO(P)=2V VI(+)=0V, VI(-)=1V VCC=15V, VO(P)=2V VI(+)=0V, VI(-)=1V VCC=15V, VO(P)=200mV

www.unisonic.com.tw
4 of 7
QW-R105-001,O
LM358
TYPICAL CHARACTERISTICS
Fig.1 Input Voltage Range

15 100
Fig.2 Input Current vs Temperature
10 Positive Input
Input Current (mA)
Input Voltage
Negative Input
80 Vcc=+30V
60
Vcc=+15V 40 Vcc=+5V
5 20
0 0
10 Power Supply Voltage

5
15
-50
-25
25
50
75
100
Temperature(C)
Fig.3 Supply Current vs Supply Voltage

4 160 VCC Ic
Fig. 4 Voltage Gain vs Supply Voltage

RL=20k 120
Supply Current (mA)
Voltage Gain
(dB)
RL=2k
80
TA= 0~+85C TA= -20C
40
0 0 10 20 30 40
0 0 7.5
Supply Voltage (V)
15
22.5
30
Supply Voltage (V)
Fig. 5 Open Loop Gain vs Frequency

120
Vcc 0.1 F
Fig. 6 Common Mode Rejection Ratio vs Frequency

120
Common Mode Rejection Ratio (dB)
(dB)
100 80
100M
100
80
Voltage Gain
Vin
VCC=+7.5V VEE=-7.5V
+7.5V 100k 100
Vcc/2
60
60 40
20 0
40 VCC=15V 20
VCC=30V
100 Vin 100k -7.5V
0
10
10
10
10
10
105
10 6
10
10
10
10
10 5
10 6
Frequency (Hz)
Frequency (Hz)

www.unisonic.com.tw
5 of 7
QW-R105-001,O
LM358
TYPICAL CHARACTERISTICS(Cont.)

www.unisonic.com.tw
6 of 7
QW-R105-001,O
LM358
UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.

www.unisonic.com.tw
7 of 7
QW-R105-001,O

LM358

Uploaded by

Copyright:

Available Formats

LM358

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

LM358

Uploaded by

Copyright:

Available Formats

UNISONIC TECHNOLOGIES CO.

LINEAR INTEGRATED CIRCUIT

www.unisonic.com.tw Copyright 2011 Unisonic Technologies Co., Ltd

LINEAR INTEGRATED CIRCUIT

OUT1 IN1(-) IN1(+) GND

IN2(+) IN2(-) OUT2

UNISONIC TECHNOLOGIES CO., LTD

LINEAR INTEGRATED CIRCUIT

UNISONIC TECHNOLOGIES CO., LTD

LINEAR INTEGRATED CIRCUIT

ELECTRICAL CHARACTERISTICS (VCC=5.0V, VEE=GND, TA=25, unless otherwise specified

GV ICC II(OFF) II(BIAS) ISC ISOURCE

UNISONIC TECHNOLOGIES CO., LTD

LINEAR INTEGRATED CIRCUIT

Fig.1 Input Voltage Range

Fig.2 Input Current vs Temperature

Input Current (mA)

10 Power Supply Voltage

Fig.3 Supply Current vs Supply Voltage

Fig. 4 Voltage Gain vs Supply Voltage

Supply Current (mA)

TA= 0~+85C TA= -20C

Supply Voltage (V)

Supply Voltage (V)

Fig. 5 Open Loop Gain vs Frequency

Fig. 6 Common Mode Rejection Ratio vs Frequency

Common Mode Rejection Ratio (dB)

100 Vin 100k -7.5V

UNISONIC TECHNOLOGIES CO., LTD

LINEAR INTEGRATED CIRCUIT

UNISONIC TECHNOLOGIES CO., LTD

LINEAR INTEGRATED CIRCUIT

UNISONIC TECHNOLOGIES CO., LTD

You might also like