Reading Measured Value Block: Readout Specifications For Unit Injectors
Reading Measured Value Block: Readout Specifications For Unit Injectors
unit injector)
Page 1 of 2
Copyright VW AG
Workshop manual
DMS order no.: undefined
VIN: WAUZZZ8DZ1A081895
Sales code: 8D50F4
Engine code: AJM
Official licence plate number:
Username: Calin
Indicated on display
XXX.X
C
Coolant temperature
80...110 C: okay
< 80 C: => run engine till warm
Specified injection period required by control unit: 5 ...
8 CA okay
Injection quantity: 3.0 ... 11.0 mg/stroke okay
< 3.0 mg/stroke:
Unit injectors defective => Renew unit injectors, Page 23-26
Engine speed
Front-wheel drive 800...900 rpm okay
Four-wheel drive 860...940 rpm okay
2)Check fuel supply system for leaks:
Display Group 004 at idling speed (engine warm, coolant temperature not below 80 C)
Read measured value
block 4
XX.X
XXXX
XX.X
B(A)
rpm
CA
TDC
Indicated on display
XX.X
CA
Synchronisation angle: -3 ... +3 CA okay
> +3 CA or < -3 CA:
Hall sender -G40 defective;
Gap width between sender
and sender wheel on
=> Testcamshaft not okay;
G40,
Open circuit or short circuit
Page 23-82
to earth
Hall sender -G40 loose,
Sender wheel defective or
turned out of
=> Test3)
position
Injection period specified by control unit: 3 ... 8,5 CA
okay
https://portal.cpn.vwg/elsapro/elsaweb/ctr/RMContentAction?docId=20847772&levelCo...
19.02.2013
TDI diesel direct injection and glow plug system (4-cyl. unit injector)
Page 2 of 2
rpm
CA
BTDC
Indicated on display
XX.X
CA
Indicated on display
XX
https://portal.cpn.vwg/elsapro/elsaweb/ctr/RMContentAction?docId=20847772&levelCo...
19.02.2013