Ibexu 04 Atex 1125 X

IBExU Institut fr Sicherheitstechnik GmbH
An-Institut der TU Bergakademie Freiberg
UNCERTIFIED TRANSLATION
[1]
EC-TYPE EXAMINATION CERTIFICATE

according to Directive 94/9/EC Annex III
[2]
Equipment and Protective System intended for use in Potentially

Explosive Atmospheres, Directive 94/9/EC
[3]
EC-Type Examination Certificate Number:
[4]
Equipment:
Miniature limit switch Type 8064/2.--..-
[5]
Applicant:
R. Stahl Schaltgerte GmbH
[6]
Address:
Am Bahnhof 30
D-74638 Waldenburg
[7]
This equipment specified under [4] and any acceptable variation thereto is specified in
the schedule to this certificate, and the documents therein referred to.
[8]
IBExU Institut fr Sicherheitstechnik GmbH, notified body number 0637, in accordance with Article 9 of the Council Directive 94/9/EC of 23 March 1994, certifies that
this equipment has been found to comply with the Essential Health and Safety Requirements relating to the design and construction of equipment intended for use in
potentially explosive atmospheres given in Annex II to the Directive.
The test results are recorded in report IB-04-3-162 of 02.06.2004.
[9]
Compliance with the Essential Health and Safety Requirements has been assured by
compliance with EN 50281-1-1-1999.
[10]
If the sign X is placed after the certificate number, it indicates that the equipment is
subject to special conditions for safe use specified in the schedule to this certificate.
[11]
This EC-Type Examination Certificate relates only to the design and construction of
the specified equipment. If applicable, further requirements of this Directive apply to
the manufacture and supply of this equipment.
[12]
The marking of the equipment shall include the following:
IBExU04ATEX1125 X
e II 2D T80C IP 66
Authorized for certifications

- Explosion protection By order
Freiberg, June 02, 2004
(signature)
(Dr. Lsch)
Schedule
Page 1 of 3
IBExU04ATEX1125 X
In case of dispute, the German text shall prevail

[13]
Schedule
[14]
to EC-TYPE EXAMINATION CERTIFICATE IBExU04ATEX1125 X
[15]
Description of equipment
The miniature limit switch Type 8064/2. is used as an auxiliary switch for signal control circuits and is designed for use in areas with combustible dust Zone 21 and Zone
22. It will comprise one or two interrupting chambers. The connection is provided by
means of an encapsulated connecting cable (open ended line).
Type designation
Miniature limit switch
8064 / 2 . - ... - .. - ...
Type series
Type attachment
Connecting cable = 2
Contact gap
short opening travel
(2 x 0,3 mm snap-action contact)
=1
positive opening operation wide opening travel

(2 x 1,5 mm slow-action contact)
=5
wide opening travel
(2 x 1,5 mm snap-action contact)
=8
Further options, filled in if required

Technical data
Rated insulation voltage:
Rated operating voltage Ue:
Rated current Ie max:
Based on utilization category:
Number of limit switches:
Degree of Protection to DIN EN 60529:
Type of protection:
Operating temperature range:
[16]
up to 500 V
400 V
250 V
2A
0,15 A
AC-15
DC-13
1 (single or double)
IP 66
Protection by enclosure
-55C to +75C
Test Report
The test results are set down in the test report IB-04-3-162 of 02.06.2004
The test and information documents are components of the test report and are presented there
Page 2 of 3
IBExU04ATEX1125 X

Summary
The miniature limit switch Type 8064/2.--..- meets the requirements of the type of
protection Electrical apparatus protected by enclosures for an electrical apparatus
for use in the presence of combustible dust, equipment group II, category 2D
Safety instructions
[17]
The manufacturer is under an obligation to carry out routine tests and the required
test for meeting the explosion proofness regulations for the miniature limit switch
Type 8064/2. in accordance with EN 50014-1997 + A1 + A2, section 24.
At selection, installation and maintenance the requirements of DIN EN 50281-1-2

shall meet. Under consideration of the safety factor defined in DIN EN 50281-1-2
the maximum surface temperature of the miniature limit switch shall not exceed
the ignition temperature of the dust/air mixture respectively the smouldering temperature.
The quality of the connection cable shall satisfy the thermal and mechanical requirements within the functional range. If the connecting cable is not shielded, the
connecting cable must be protected from damage. The partly limit temperature
range of the cable (max. 70 C) has to be taken into account.
Special Conditions
-
The miniature limit switch Type 8064/2. shall be installed in such way, that the
mechanical protection against impact energy in accordance with EN 50014 section 23.4.3.1 is always guaranteed.
The open ends of the connecting cable are to be protected according to the requirements of the dust explosion protection (e.g. terminal box IP 6X).
The maximum surface temperature T 80 C is valid for the following ambient temperatures and maximum currents:
ambient temperature
rated thermal current
one interrupting chambers
rated thermal current
two interrupting chambers
[18]
60 C
75 C
7A
3A
6A
2A
Essential health and safety requirements

Met by compliance with standards (see [9]).
By order
Freiberg, June 02, 2004
(signature)
(Dr. Lsch)
Page 3 of 3
IBExU04ATEX1125 X

Ibexu 04 Atex 1125 X

Uploaded by

Copyright:

Available Formats

Ibexu 04 Atex 1125 X

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Ibexu 04 Atex 1125 X

Uploaded by

Copyright:

Available Formats

IBExU Institut fr Sicherheitstechnik GmbH

An-Institut der TU Bergakademie Freiberg

EC-TYPE EXAMINATION CERTIFICATE

Equipment and Protective System intended for use in Potentially

EC-Type Examination Certificate Number:

Miniature limit switch Type 8064/2.--..-

R. Stahl Schaltgerte GmbH

The marking of the equipment shall include the following:

Authorized for certifications

Freiberg, June 02, 2004

In case of dispute, the German text shall prevail

IBExU Institut fr Sicherheitstechnik GmbH

to EC-TYPE EXAMINATION CERTIFICATE IBExU04ATEX1125 X

8064 / 2 . - ... - .. - ...

positive opening operation wide opening travel

Further options, filled in if required

In case of dispute, the German text shall prevail

IBExU Institut fr Sicherheitstechnik GmbH

At selection, installation and maintenance the requirements of DIN EN 50281-1-2

Essential health and safety requirements

Freiberg, June 02, 2004

In case of dispute, the German text shall prevail

You might also like