Programming Device Manual Booklet: AVR Prog USB v2, STK500 v2
Programming Device Manual Booklet: AVR Prog USB v2, STK500 v2
Programming Device Manual Booklet: AVR Prog USB v2, STK500 v2
Manual Booklet
Page 1
Content
Page 2
1. Installation
The programmer is connected to a computer using a USB A-B mini connection
(most frequently used with digital cameras ). It is advised to use a cord not longer than
1.8m.
A connection with the programmed set is conducted by a IDC-10 data tape. A
connection with a programmed device performed by IDC-10 connectors on both ends.
Programmer uses a set of pins Atmela standard compatible to use it, take a one-one
one, non interlaced cable.
ATTENTION !!
If, after a successful installation, a programmer is detected by Windows and lits a
green LED, but does not operate, connect the programmer to a PC/laptop excluding
HUBs and docking station. In some specific situations, programmers functions may be
interrupted by these devices.
http://www.and-tech.pl/programy
In order to programme a processor, set the following fileds: Programmer and Port (see
picture below). Choose a processor type in the Device field and a file to programme the
processor in the Flash field. Start programming by pressing the Terminal button.
After installing a driver, the programming device should be visible at your system device
manager under the name: AVRProg USB v2. Installing it at any other USB port will effect
in another installation.
After installing the programmer, change PORTU COM settings at your system device
manager, where the programmer is installed as follows:
If the programmer installs at a distant COM port (it is advised to install it between COM1
and COM9). See the below picture for more details.
In order to change the COM port, enter programmers advanced settings to choose
a port between COM1 and COM9 (if these are already in use, try to relieve one and than
check programmers correct operation).
When a programmer is not detected by the software, the below window will appear on
the screen, and the programmer has to be disconnected from a USB port and
reconnected again, pressing the AVR icon. If this action will not provide programmer
detection, check if the programmer type STK500 and AUTO have been chosen.
9. Other software
AVR Prog USB v2 programmer is able to use any software capable of choosing STK500v2
programmer.