Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
229 views2 pages

Connect As Below:: Serial Suite: ECU Plug

Uploaded by

Osmar Augusto

The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt

Connect As Below:: Serial Suite: ECU Plug

Uploaded by

Osmar Augusto
229 views2 pages
The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Original Description:

ME7.9.8

Original Title

ME7.9.8

Copyright

© © All Rights Reserved

Available Formats

PDF, TXT or read online from Scribd

Did you find this document useful?

Is this content inappropriate?

The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt
229 views2 pages

Connect As Below:: Serial Suite: ECU Plug

Uploaded by

Osmar Augusto
The document provides instructions for connecting an ECU plug to a serial suite and putting the ECU into bootstrap mode. It specifies to connect the red wire to the 2 pin red power supply, black wire to the 1 pin black ground, and green wire to the 1 pin green K line on the ECU plug. It further instructs to connect two 680 ohm resistors as pictured to put the ECU into bootstrap mode, which then allows reading and writing of the ECU.

Copyright:

© All Rights Reserved
Download as PDF, TXT or read online from Scribd
Download as pdf or txt
You are on page 1/ 2

Connect as below:

Serial Suite: ECU Plug:

Red to 2 Pins Red (Power Supply +12 Volt)


Black to 1 Pins Black (Ground)
Green to 1 Pins Green (K Line)

Piasiniengineering info@piasinienginnering.it http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298
Bootstraps Pin:

Connect the 2 resistor (680 Ohm) like in the picture, then ECU is in Bootstraps Mode,
Now you can read and write the ECU.

Piasiniengineering info@piasinienginnering.it http://www.piasiniengineering.it


Tel: +39 0342 489060 - Fax: +39 0342 488298

You might also like