Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
128 views

Beam Flexure & Deflection Check (Aci 318M-08)

This document summarizes flexure and deflection calculations for a cantilever platform beam. It provides the beam dimensions, material properties, reinforcement details, and calculation of nominal moment capacity, reinforcement ratio, and deflection. The calculations show the beam meets requirements for flexure design and allowable deflection, with a capacity ratio of 0.11 and depth exceeding the minimum. Skin reinforcement is noted as not applicable.

Uploaded by

Amanda Smith
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
128 views

Beam Flexure & Deflection Check (Aci 318M-08)

This document summarizes flexure and deflection calculations for a cantilever platform beam. It provides the beam dimensions, material properties, reinforcement details, and calculation of nominal moment capacity, reinforcement ratio, and deflection. The calculations show the beam meets requirements for flexure design and allowable deflection, with a capacity ratio of 0.11 and depth exceeding the minimum. Skin reinforcement is noted as not applicable.

Uploaded by

Amanda Smith
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

DOCUMENT NO.

SHEET
Prepared by: JPJ Date:

Checked by: AC / RPD Date:


SUBJECT
Branch to Warehouse - Non Standard Tunnel_Cantilever Platform_X-Direction_Bottom
REFERENCE CALCULATIONS OUTPUT

BEAM FLEXURE & DEFLECTION CHECK (ACI 318M-08)


INPUT Beam Tag: Cantilever Platform Location: Bottom

DESIGN PARAMETERS: MATERIAL SPECIFICATIONS:


Design Moment Location = SpanSpan Concrete Compressive Strength, f'c= 35 N/mm2
Design Moment, Mu = 6 kN-m Reinforcing Steel Yield Strength, fy = 420 N/mm2
Beam Width, b = 1000 mm Ec 27806 MPa
Beam Depth, h = 300 mm Es 200000 MPa
Beam Length, L = 3700 mm
Clear Cover (FF) = 50 mm MAIN REINFORCEMENT (TENSION ZONE):
Clear Cover (NF) = 30 mm Layer Diameter No. of Bars
Shear Link Dia. = 0 0 1 1212 5
(9.3.2.1) Capacity Reduction = 0.90 2 ------ 0
Factor, φ (Flexure)
(10.2.7.3) β1 = 0.800 Effective Depth, d = 252.00 mm
AsTotal = 565.49 mm2

Service Moment =
Long Term Deflection
2 20 10
20 0

Beam Support Type Both


BothEnds
Ends Continuous
Continuous

OUTPUT
A. FLEXURE DESIGN:
(B.8.4.2) b  0.85f'cβ1 600 = 0.03333
fy 600 + fy
(B.10.3.3)  max = 0.75ρb = 0.02500 Ok!
(10.5.1)  min = 0.00180 Ok!

  As / bd = 0.00224 Capacity


= 7.98 mm 0.11
a Ratio
φMn = 53.01 kN-m Flexure Design Adequate

B. DEFLECTION CHECK: C. SIDE BARS CHECK:


(Table 9.5(a)) Minimum Depth, h = 177 mm Skin Reinforcement is N/A
(Table 9.5(a) Enhancement Factor = 1.00
Note (b)) Adjusted Depth = 177 mm
Depth sufficient

You might also like