FMDS0786 - Cellulose Nitrate
FMDS0786 - Cellulose Nitrate
FMDS0786 - Cellulose Nitrate
CELLULOSE NITRATE
Table of Contents
Page
©2000 Factory Mutual Insurance Company. All rights reserved. No part of this document may be reproduced,
stored in a retrieval system, or transmitted, in whole or in part, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without written permission of Factory Mutual Insurance Company.
7-86 Cellulose Nitrate
Page 2 FM Global Property Loss Prevention Data Sheets
1.0 SCOPE
This data sheet covers the storage and use of cellulose nitrate as a wetted fiber in drums. Cellulose nitrate
is also known as nitrocellulose or pyroxylin plastic.
1.1 Changes
May 2000. This revision of the document has been reorganized to provide a consistent format.
June 1999. This document was restructured and data sheet and NFPA references were updated.
2.1 Occupancy
2.1.1 Cellulose nitrate fibers and powders should only be stored wetted and in metal drums. Drums should
not be opened in storage areas.
2.1.2 Stock should be rotated to ensure that the oldest material is used first.
2.1.3 Handling equipment and personnel practices should be designed to avoid dragging, dropping,
puncturing, or otherwise damaging drums.
2.1.4 Factory Mutual Research Approved (see Appendix A, for definition) safety tools should be used for
opening drums and handling material.
2.1.5 If any material is spilled, it should be immediately wet with water, preferably by placing it in a pail of
water, and safely disposed.
2.1.6 The quantity of cellulose nitrate brought into dispensing or processing areas should be limited to that
required for a shift
2.1.7 Cellulose nitrate should not be permitted to dry out. If a drum is opened but not immediately emptied,
the material should be amply wet with water or solvent, and the drum tightly resealed.
2.1.8 After emptying, drums should be wiped clean, recovered, and sealed. Used rags should be placed in
an Approved waste can, wet down, and disposed of daily.
2.2 Protection
2.2.1 Drums of cellulose nitrate should be stored in separate rooms used only for that purpose. The rooms
should be designed and protected as recommended for flammable liquids with flashpoint under 200°F (93°C)
in Data Sheet 7-29, Flammable Liquid Storage in Portable Containers, with the following modifications:
a) Drums should be stored in an upright position only.
b) If the cellulose nitrate is wetted only with water, natural ventilation is sufficient.
c) For new sprinkler installations, open-head deluge systems actuated by fast acting fire detectors are
preferred.
d) The probability of a flowing flammable liquid fire is slight. Drainage requirements may be reduced
accordingly. Provide drainage to safely dispose of large quantities of water. Refer to Data Sheet 7-83,
Drainage Systems for Flammable Liquids.
2.2.2 Rooms used for dispensing or use of cellulose nitrate should be designed and protected as
recommended in Data Sheet 7-32, Flammable Liquid Operations.
2.2.3 Outdoor storage in drums should be arranged and protected as recommended for outdoor flam-
mable liquid drum storage in Data Sheet 7-29, with the following exceptions:
a) Minimum spacing from important buildings should be 50 ft (15 m).
b) Curbing and drainage is required only as necessary to control large amounts of fire protection water.
2.3 Training
2.3.1 As part of the plant property conservation program, employees should be instructed in the fire hazards
and in recommended preventive and protective practices involving the storage and use of cellulose nitrate.
3.1 Discussion
The storage and use of dry, solid cellulose nitrate (pyroxylin) has been largely discontinued because of the
development of better substitutes. It is likely to be found only in rare instances, such as the storage of old
motion picture film or imported table tennis balls. Since its use is so rare, publication of recommended prac-
tices for this material has been discontinued.
Cellulose nitrate is more commonly present, particularly in lacquer manufacturing plants, as a white fibrous,
pulp-like material or amorphous powder in steel drums. It is wet with 20 to 30% alcohol or other organic
solvent having a flash point not lower than 30°F (-1°C) or wet with 20 to 25% water. For properties and haz-
ards of this material, see Appendix C.
Cellulose nitrate also may be in solution in the form of a lacquer, with low flash point organic solvents. Unless
the cellulose nitrate is more concentrated than in normal commercial lacquers, it may be treated as an ordi-
nary flammable liquid with the hazard based on the flash point. Appropriate safeguards should be provided
as needed for flammable liquid storage and handling. Where lacquers containing cellulose nitrate are used
in spray applications, some special safeguards are needed as specified in Data Sheet 7-27, Spray
Application of Flammable and Combustible Materials.
4.0 REFERENCES
4.1 FM Global
Data Sheet 7-27, Spray Application of Flammable and Combustible Materials.
Data Sheet 7-29, Flammable Liquid Storage in Portable Containers.
Data Sheet 7-32, Flammable Liquid Operations.
Data Sheet 7-83, Drainage Systems for Flammable Liquids.