Meiosis - Clay Modelling
Meiosis - Clay Modelling
Meiosis - Clay Modelling
The replicated chromosomes con- Homologous chromosomes line Each chromosome separates The nucleus completes its divi-
dense. Homologous chromosomes up at the equatorial plate. from its homologue. They move to sion. The chromosomes are still
come together in synapsis and opposite poles of the cell. composed of sister chromatids.
crossing-over occurs. The cytoplasm divides after
Chromosomes attach to the spindle. telophase.
Figure 1
Stages of meiosis I.
108 Chapter 3
3.7
Mitosis
The chromosomes condense, Chromosomes line up at the The centromeres divide and the Chromosomes lengthen again,
becoming shorter and thicker. The equatorial plate. The nuclear resulting chromosomes, formerly the spindle fibres dissolve, and a
centrioles assemble and spindle membrane completely dissolves. chromatids, move to opposite nuclear membrane forms around
fibres attach to the centromeres poles of the cell. An identical the chromosomes.
of the chromosomes. The nuclear set of chromosomes moves to
membrane starts to dissolve. each pole.
Meiosis II
The centrioles in the two new Chromosomes line up at the Sister chromatids of each chro- The cytoplasm separates, leaving
cells move to opposite poles and equatorial plate. mosome separate and move to four haploid daughter cells. The
new spindle fibres form. The opposite poles. chromosome number has been
chromosomes become attached reduced by half. These cells may
to the spindle. become gametes.
Figure 2
Comparsion of the stages in mitosis and meiosis II
Materials
blue modelling clay plastic knife
red modelling clay sheets of paper
green modelling clay pencil
Procedure
For each step, make a coloured sketch of your model with appropriate labels.
Include brief descriptions of your steps and make sure to use the same step num-
bers as given.
Part 1: Mitosis
1. Take some red clay and roll it between your hands to create a piece 10 cm
long and about as thick as your finger. Make another piece about 5 cm long.
2. Repeat step 1 with the blue clay.
3. Make an identical copy of each piece of clay. Then attach the identical
pieces with a green ball of clay (Figure 3).
4. Draw a line down the length of a sheet of paper. Line up the four chromo-
somes along the line (Figure 4).
110 Chapter 3
3.7
5. Remove the green balls and move each of the single pieces of clay to opposite
ends of the paper (Figure 5).
6. If the cell is going to divide again, each single chromosome must synthesize
a duplicate during interphase. Make an identical copy
of each piece of clay as before (Figure 6).
Part 2: Meiosis
7. Follow steps 1 to 3 from part 1.
8. Demonstrate crossing-over. Break off a piece of clay from one chromosome
and attach it to the other chromosome (Figure 7). Repeat a few times if
you like.
9. To simulate metaphase I, place the chromosomes on either side of the
equatorial plate, represented by a line drawn on a piece of paper (Figure 8).
10. Choose one of the haploid daughter cells and line the chromosomes up
along the equatorial plate. Remove the centromere and move chromosomes
to opposite poles (Figure 9).
Analysis
Part 1: Mitosis
(a) In step 3, what process did you model?
(b) What do the red and blue pieces of clay represent? What do the green balls
of clay represent?
(c) In step 4, what is the diploid chromosome number of the cell?
(d) What phase of mitosis does the model represent?
(e) In step 5, what structure do the single pieces of clay represent after separa-
tion?
(f) What phase of mitosis does the model represent?
(g) In step 6, how many chromosomes are in each of the daughter cells?
(h) Compare the daughter cells with the parent cell.
Part 2: Meiosis
(i) In steps 1 to 3, on what basis are chromosomes considered to be homolo-
gous?
(j) What is the diploid chromosome number?
(k) In step 8, what must happen before the homologous chromosomes can
cross over?
(l) In which phase does crossing over occur?
(m) What happens during crossing over?