Danalock V3 BT Euro

www.danalock.com EN
3
4
5
6
7
 X
8
 32 15

X = 25 10

22 7

9
 x +
x

10
11
12
13
 10
10
5

14
 10 mm

10mm
15 mm

5 mm 15mm
20 mm

10 mm 20mm
25 mm

5+10 mm 25mm
30 mm

10+10 mm 30mm

15
16
17
 10-35 mm

18
Click!

19
20
21
 Click!

22
23
The following instructions are in english. Localized versions can be
found with the QR-code below.

guide.danalock.com

24
Download the Danalock App
Go to Google Play or App Store and download the Danalock App.
When the App has been installed, create a user profile and sign in.
You will use this profile each time you sign into the App.
You can now add your Danalock to your keychain in the App.

25
Dismounting

26
LED-Signals

LED-Mode LED color Status indication

Constant red till light finishes Lock has successfully locked
Constant green till light finishes Lock has successfully unlocked
Constant white for 3 seconds Power on. Batteries are activated
Red light flashes every 5 minutes Critical battery level
Constant purple Firmware is being updated
Blue light flashes Settings are changed/saved

27
Configuring the Danalock V3 with click-commands
You can configure the Danalock via the button found in the small
hole on the top of the lock. When you click through settings, the
LED will change color according to the scheme on the next page.
When you get to the setting you want to change, wait for 5 seconds
and the Danalock will react to your command. If you make a wrong
number of clicks, just stop at a number of clicks where the LED
doesn’t light up and wait for 5 seconds. The LED will flash red to
indicate that it has timed out.

28
Clicks Color Activity
1 Green Inclusion mode
This mode is used to in- or exclude your Danalock with a Z-Wave or Zigbee gateway.
When the Danalock blinks green it is in ex/inclusion mode and you have 30 seconds
to pair the Danalock with a gateway.
2 Yellow Manual calibration
Turn the Danalock to the desired unlocked position. Start the calibration with the
click command and wait for the LED to start blinking yellow. Turn the Danalock to the
desired locked position while the LED blinks and click the button once to save the
locked position. If the lock doesn’t receive a response from you within 30 seconds the
calibration will be canceled.
3 White Auto calibration
Turn the Danalock to unlocked position and lift the handle if needed. Leave the door
open while the Danalock auto calibrates. Start the auto calibration with the click
command. The Danalock will blink white while auto calibrating.
7 Cancel

10 Red Reset user settings

This action deletes all user settings on the Danalock. The Danalock responds by
blinking red.

29
Simple Guidelines resulting in bodily injury or even death.
Please follow these guidelines when configuring, using or Areas with a potentially explosive atmosphere are often,
recycling the Danalock. Violating these guidelines may be but not always marked clearly. Potential areas may include:
dangerous, illegal or otherwise detrimental. Further detailed fueling areas (such as gasoline stations); below deck on boats;
information is provided in this manual. fuel or chemical transfer or storage facilities; areas using
Do Not Operate Where Prohibited liquefied petroleum gas (such as propane or butane); areas
Do not allow the Danalock unit to operate wherever wireless where the air contains chemicals or particles (such as grain,
radio communication use is prohibited or when doing so dust, or metal powders); and any other area where it would
may cause interference or danger as the Danalock cannot normally be advisable not to install the Danalock.
be turned off after installation. Examples include but are not Battery Safety Information
limited to operation in hospitals, buildings near blasting sites Adhere to the following guidelines to avoid the risk of fire
or wherever operation can cause interference. or explosion:
Avoid Body Contact with Device during Operation 1. Dispose of the used battery according to the instructions
Do not operate the Danalock in direct contact with your body. provided with the battery.
Maintain at least 8 inches (20 cm) separation between the 2. Do not drop, puncture, disassemble, mutilate, or incinerate
device and any parts of your body. the battery.
Fire doors 3. Touching both terminals of a battery with a metal object
The Danalock is not approved for use with fire doors. EN will short circuit the battery. Do not carry batteries loosely if
14846 suitability for use on fire/smoke doors classification the contacts may touch coins, keys, and other metal objects
grade=0. (such as in pockets or bags).
Water-Resistance 4. Do not stack batteries taken out of the carry case.
The Danalock is not water-resistant. The lock must therefore 5. Do not heat the batteries to try to rejuvenate their charge.
be installed on the inside of the door where it is dry and not 6. Do not exceed the temperature ranges or other
subjected to either water streams or submersion. EN 14846 environmental conditions specified by the battery
corrosion resistance classification grade=0. manufacturer.
Accessories and Batteries 7. Never use the Danalock without the battery cover installed.
The Danalock uses 4 x CR123 lithium batteries. Use
Disclaimer
only approved accessories or batteries. Do not connect
It is very important to replace all 4 batteries at the same
incompatible products. There is risk of explosion or fire if an
time. Please use only standard CR123 lithium batteries.
incorrect type replacement battery contacts are shorted. Do
Not replacing all batteries at the same time can affect the
not exceed the temperature ranges or other environmental
batteries to heat and potentially cause them to explode.
conditions specified by the battery manufacturer. Dispose
Danalock has no responsibility in any way if the replacement
of used batteries according to the instructions provided
of batteries is done inaccurately.
with the batteries.
Potentially Explosive Atmospheres
The Danalock cannot be turned off after installation, so any
building installed with Danalock etc. must not be located
in an area with a potentially explosive atmosphere and
obey all signs and instructions not to use Danalock in such
areas. Sparks in such areas could cause an explosion or fire
30
 Disposal of Waste Batteries Disposal of Waste Electrical & Electronic
(Applicable in the European Union only) Equipment of products for Household use
The symbol (crossed out wheeled-bin) on your (Applicable in the European Union only)
battery indicates that the battery shall not be disposed with For further information regarding the disposal of products for
other unsorted waste, but shall be collected separately and business purposes, please contact your dealer or distributor
handed over to your local community waste collection point in your country. This product shall not be mixed or disposed
or other available collection points for the recycling, at the with commercial waste.
end of its use. The product complies with the essential
If a chemical symbol is printed under the symbol it indicates requirements of the R&TTE Directive 1999/5/EC
that chemical substances (Hg = mercury, Cd = cadmium or Pb as stated by the EC Declaration of Conformity.
= lead) are contained in the battery. Certificates and Declaration of conformity (DOC) statements
Inappropriate waste handling could possibly have a negative can be downloaded from the danalock website: https://
effect on the environment and human health due to potential danalock.com/
hazardous substances. With your cooperation in the correct Product approvals and certificates
disposal of this battery, you contribute to reuse, recycle and Please refer to product declaration/technical manual on
recover the batteries and our environment will be protected. Danalock website for all applicable product approvals and
For more information, please contact the Government certificates.
Waste-Disposal department in your country or the shop
where the battery was purchased.
Disposal of Waste Electrical & Electronic
Equipment of products for Household use
(Applicable in the European Union only)
The symbol (crossed out wheeled-bin) on your
product indicates that the product shall not be mixed or
disposed with your household waste, at the end of its use.
This product shall be handed over to your local community
waste collection point for the recycling of the product.
For more information, please contact the Government
Waste-Disposal department in your country.
Inappropriate waste handling could possibly have a negative
effect on the environment and human health due to potential
hazardous substances. With your cooperation in the correct
disposal of this product, you contribute to reuse, recycle and
recover the product and our environment will be protected.

31
Danalock International ApS
Gammel Stillingvej 427C
8462 Harlev, DK

+45 4242 8122

info@danalock.com

www.danalock.com DV3-EURO-EN-2019/11/12