SERVERON TM8 ® ™

On-line DGA Monitor

Protect Transformer Assets

• Avoid transformer failures
• Enable condition based maintenance
• Extend transformer life
• Defer capital expenditures
• The most comprehensive DGA assessment available

Product Summary
Description: Our industry leading on-line DGA

monitors and TM VIEW™ software are monitoring

generation, transmission and distribution power

transformers worldwide. DGA (dissolved gas

analysis) of transformer oil is the single best

indicator of a transformer’s overall condition.

The Model TM8 offers the most comprehensive

DGA assessment available. This assessment is

provided through accurate and repeatable on‑line

measurements of the 8 critical fault gases plus

nitrogen, moisture and other key parameters.

Application: Throughout your system are

transformers that are vital to the reliability of your

grid – GSU’s, large transmission transformers,

and critical substation transformers. Serveron

DGA transformer monitors provide the important

and timely information needed to maintain the

reliability and safety of transformer fleets.

Comprehensive Data Requires Powerful Tools

• Serveron TM View™ software and services offer simple yet powerful analytical tools for transformer monitor
management, data visualization and analysis including our exclusive TOAN diagnostic tool.

• Seamlessly move from single user software to enterprise capability for large deployments of monitors in your
fleet with our SmartSUB solution.

• SmartSUB includes the DGA analysis features of TM View and adds the ability of combining data from
additional transformer condition based monitoring devices (tank pressure, cooling bank current, winding
current & temperature, bushing monitor, partial discharge and others).

Gas-in-Oil Trend Chart Transformer Oil Analysis and Notification (TOAN)

• On-line correlation of 8 fault gases for the most • Neural network based DGA diagnostic technology
comprehensive DGA condition assessment that provides the most accurate DGA diagnostic
available. results over all other diagnostic tools.

Duval Triangles Rogers and Basic Gas Ratios

• Multiple Duval Triangles provide diagnostic • Offer three dimensional views of diagnostic
outcomes for various combinations of the fault outcomes for various combinations of the fault
gases (IEC 60599‑2007‑05). gases (IEEE C57.104‑2008 & IEC 60599-2007-05).
SERVERON® TM8™ on-line DGA monitor

Accuracy and Reliability • The Model TM8 measures all fault gases using a single Gas
Chromatography (GC) measurement system. Gas Chromatography
is the accepted measurement science for DGA and is the only DGA
measurement technology specified in IEEE, ASTM, CIGRE and IEC
standards.

• Serveron has delivered more GC based DGA monitors with industry

leading accuracy than any other vendor.

• On-board automated calibration verification ensures performance to

specification throughout the entire operating life of the monitor.

• Performs accurate DGA analysis on mineral and ester-based insulating fluids.

Low Total Cost of • Field-proven reliability combined with low lifetime maintenance
Ownership (TCO) requirements offers superior value.

• Economical maintenance costs compared to other multi-gas monitors.

• All scheduled maintenance can be performed on-site for minimal

disruption to monitor up-time.

Avoid transformer failures • Continuous trending of key fault gases gives early and immediate
notification of incipient faults that can lead to transformer failure.

• Many transformer failures can be prevented through the correlation of

DGA data to real events.

• All 8 fault gases plus nitrogen, oil temperature, ambient temperature,

transformer load and moisture-in-oil are correlated by the Model TM8.

Enable condition based • Only comprehensive on-line monitoring can provide the information that
maintenance enables continuous transformer condition assessment.

• Data from the Model TM8 supports all IEEE and IEC diagnostic tools for
rapid warning and diagnosis of developing faults.

Extend transformer life and • Comprehensive analysis of key fault gases, moisture and other key
defer capital expenditures parameters enables intelligent management of transformers, extending
their useful life and deferring capital expenditures.
Technical Specifications

DGA Method: Accuracy¹ Repeatability² Range³

Laboratory
Hydrogen (H2) ±5% or ±3 ppm <2% 3-3,000 ppm
Grade Gas
Chromatography Oxygen (O2) ±5% or +30/-0 ppm <1% 30-25,000 ppm
Methane (CH4) ±5% or ±5 ppm <1% 5-7,000 ppm
Carbon Monoxide (CO) ±5% or ±5 ppm <2% 5-10,000 ppm
Carbon Dioxide (CO2) ±5% or ±5 ppm <1% 5-30,000 ppm
Ethylene (C2H4) ±5% or ±3 ppm <1% 3-5,000 ppm
Ethane (C2H6) ±5% or ±5 ppm <1% 5-5,000 ppm
Acetylene (C2H2) ±5% or ±1 ppm <2% 1-3,000 ppm
Nitrogen (N2) ±10% or ±5,000 ppm <20% 5,000-100,000 ppm
All specifications are independent of oil temperature and gas pressure levels.
1) Percent or PPM - whichever is greater
2) At the calibration level
3) Gas-in-Oil

Additional Accuracy4 Range

Monitoring
Moisture-in-Oil ±2% 0-100% RS
Options
< 10% of reading for oil temperature > 30°C 0 to 805 ppm
< 18% of reading for oil temperature < 30°C 0 to 805 ppm
Oil Temperature 0.1°C (typically) -40°C to +180°C
4) Includes non-linearity and repeatability
5) Upper range limited to saturation

Total Dissolved True Total rue Total Dissolved Combustible Gas (TDCG) output is available reporting
T
Gases Combustible Gas 100% of detected level in PPM for H2, C2H2, C2H4, CO, CH4, C2H6
Total Hydrocarbons Total Hydrocarbons (THC) output is available reporting 100% of detected
level in PPM for CH4, C2H2, C2H4, C2H6

Gas Analysis Oil Sampling Rate Oil sampling is continuous and gas analysis intervals are user-selectable
Parameters from 2 hours to 12 hours (Default: 4 hours). Automatic schedule
acceleration when rate of change alarm limit is exceeded (Default: 1 hr)
Data Management All data is date and time stamped and up to two years of data is stored
in memory
Automated Calibration System performs periodic automated calibration verification to National
Verification Institute of Standards and Technology (NIST) traceable gas standard

Alarms Two individually 50 VDC or 240 VAC @ 3 A max. (125 VDC @ 1 A max.); relay contacts
programmable relays operate as normally open or normally closed
Supported Alarms Gas Caution & Alarm for Level (ppm), Rate-of-Change (ppm/day), Power
and/or Service Event

External Sensor Analog Inputs Three (3) analog 4 to 20 mA inputs, ambient temperature sensor
Inputs included. Optional sensors include transformer load guide and moisture-
in-oil with temperature probe (uses 2 inputs)

www.serveron.com
SERVERON® TM8™ on-line DGA monitor

Technical Specifications

Communications Standard Interfaces RS-232, RS-485, Ethernet Fiber (100Base-FX)

Optional Interfaces Cellular modem, Ethernet Copper (10/100Base‑TX), Wireless Radio,
V.92 Internal POTS modem
Supported Protocols TCP/IP, DNP3, Modbus RTU, ASCII, OPC and IEC 61850

Environmental Operating Temperature -50°C to +55°C

Specifications
Cold Start Temperature -20°C
Operating Humidity 5% to 95% RH, non-condensing
Oil Inlet Pressure 0 to 45 psi (0 to 3 bar)
Storage Temperature -40°C to +75°C
Storage Humidity 5% to 95% RH, non-condensing

Physical Product Dimensions HxWxD: 22.0 in x 20 in x 11.2 in (55.9 cm x 50.8 cm x 28.4 cm)
Specifications
Packaging Dimensions 26.4 in x 26.4 in x 15.9 in (67 cm x 67 cm x 40.3 cm)
Product Weight 65 lb (29.5 kg)
Shipping Weight 70 lb (31.8 kg) (monitor package only)
Enclosure Rating NEMA 4X, IP66

Input Power Voltage 100-280 VAC or 100-300 VDC

Requirements
Frequency 50/60 Hz
Current 6 A Startup Maximum / 4 A Operational Maximum

Radiated and Specification Test Method

Conducted
Radiated Emissions EN 61326-1: 2006 CISPR 11:2009 A1:2010 Class A
Emissions
Conducted Emissions EN 61326-1: 2006 CISPR 11:2009 A1:2010 Class A
Current Harmonics EN 61000-3-2:2006 EN 61000-3-2:2006 A1:2009 Class A
Voltage Fluctuations EN 61000-3-3:2008 EN 61000-3-3:2008 Class A

Radiated and Specification Test Method

Conducted
ESD EN 61326-1:2006 IEC61000-4-2:2009
Immunity
Radiated Immunity EN 61326-1:2006 IEC61000-4-3:2006 A2:2010
EFT EN 61326-1:2006 IEC61000-4-4:2004 A1:2010
Surge EN 61326-1:2006 IEC61000-4-5:2006
Conducted RF Immunity EN 61326-1:2006 IEC61000-4-6:2009
Magnetic Field Immunity EN 61326-1:2006 IEC61000-4-8:2010
Voltage Dips & Interrupts EN 61326-1:2006 IEC61000-4-11:2004

Safety Specification
IEC 61010-1 IEC 61010-2-81
UL 61010-1 (2nd Edition) CSA-C22.2 No. 61010-1-04

www.serveron.com
 SERVERON® TM8™ on-line DGA monitor

On-line DGA Analysis Across Your Power Transformer Fleet

Leading utilities around the globe deploy the Serveron line of transformer monitors to provide superior asset
protection for their transformer fleets across generation, transmission and distribution. With a low total cost
of ownership, reliable field-proven performance and global customer service, Serveron transformer monitors
set the standard for on-line DGA monitoring. Our transformer monitors can be deployed stand-alone or
as part of the Qualitrol SmartSUB condition based monitoring system for transformers and other critical
substation assets.

Model DGA
150/250/400
Model TM8™

Model TM3™

Model TM2™

Model TM1™

Generation Transmission Distribution

About Serveron®
Serveron transformer condition assessment and management tools are critical to utilities in improving grid reliability while
optimizing the management and economics of their asset base. We are a leader in on-line DGA monitoring of power
transformers with solutions across the entire power transformer fleet. Serveron is a QUALITROL Company.

© 2014 Serveron® Corporation. All rights reserved. Information subject to change without notice.
QUALITROL is a registered trademark of Qualitrol Company LLC. SERVERON, LOADGUIDE, and TRUEGAS are registered trademarks
and TM1, TM2, TM3 and TM8 are trademarks of Serveron® Corporation.
All trademarks are properties of their respective companies, as noted herein. AP-G35-02L-03E

Email: info@serveron.com
www.serveron.com