Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd Logo
Upload

Welcome to Scribd!

  • 52 views

    No Schematic For This DTC: Diagnostic Trouble Codes (DTC)

    Uploaded by

    luis eduardo corzo enriquez

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    No Schematic For This DTC: Diagnostic Trouble Codes (DTC)

    Uploaded by

    luis eduardo corzo enriquez
    52 views1 page

    Original Title

    P0602

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    52 views1 page

    No Schematic For This DTC: Diagnostic Trouble Codes (DTC)

    Uploaded by

    luis eduardo corzo enriquez

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    You are on page 1of 1

    ALLISON 1000 AND 2000 PRODUCT FAMILIES ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL

    DIAGNOSTIC TROUBLE CODES (DTC)

    DTC P0602 TCM Not Programmed

    NO SCHEMATIC FOR THIS DTC


    Circuit Description

    At the power up and after clearing codes, the Transmission Control Module (TCM) performs a self-test to determine
    if the calibration in memory is valid.

    Conditions for Running the DTC


    • The components are powered and ignition voltage is greater than 9V and less than 18V (12V TCM) or greater
    than 18V and less than 32V (24V TCM).
    • This test will run before any TCM functions.

    Conditions for Setting the DTC

    OTC P0602 sets if the TCM determines the present calibration is invalid.

    Action Taken When the DTC Sets


    • OTC P0602 is stored in the TCM history.
    • The CHECK TRANS light illuminates.
    • The TCM returns to the boot program, and then waits to be recalibrated.
    • The TCM inhibits TCC engagement.

    Conditions for Clearing the DTC/CHECKTRANS Light

    TCM must be recalibrated.

    DTC P0602 TCM Not Programmed


    Step Action Yes No
    1 Was the Beginning The Troubleshooting Process Go to Step 2 Go to
    (Paragraph 5-4A) performed? Beginning The
    Troubleshooting
    Process
    (Paragraph 5-4A)
    2 1. Install the Scan Tool. Go to Step 4 -
    2. If OTC P0602 is present, the TCM must be recalibrated.
    Is recalibration complete?
    3 NOTE: In most cases, the TCM is not at fault. Investigate Go to Step 4 -
    thoroughly before replacing the TCM. Refer to TCM
    Replacement Procedure (Section 3-6).
    Replace the TCM.
    Is replacement complete?
    4 1. Install the Scan Tool. Go to Step 3 System OK
    2. Start the vehicle.
    Did the OTC return?

    Copyright© 2004 General Motors Corp. 5-37

    You might also like