Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                
Scribd
Upload
34 views

Cruise Control Command Switch

The document provides instructions for removing, installing, and inspecting a cruise control command switch on a vehicle. It instructs to disconnect the battery and remove the airbag module and horn switch before removing the two TORX bolts securing the command switch. When installing, reverse the removal steps. Inspection includes measuring resistance across switch terminals in different positions and comparing to standard values to determine if replacement is needed.

Uploaded by

le sciellour
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

Cruise Control Command Switch

The document provides instructions for removing, installing, and inspecting a cruise control command switch on a vehicle. It instructs to disconnect the battery and remove the airbag module and horn switch before removing the two TORX bolts securing the command switch. When installing, reverse the removal steps. Inspection includes measuring resistance across switch terminals in different positions and comparing to standard values to determine if replacement is needed.

Uploaded by

le sciellour
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

CRUISE CONTROL COMMAND SWITCH

CRUISE CONTROL SYSTEM

5. Cruise Control Command 7) Disconnect the horn and cruise control com-
mand switch connector, then remove the cruise
Switch control command switch.
A: REMOVAL
WARNING:
Before servicing, be sure to read the notes in
the AB section for proper handling of the driv-
er's airbag module. <Ref. to AB-3, CAUTION,
General Description.>
1) Set the front wheels in straight ahead position.
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and
CC-00020
wait for at least 20 seconds before starting work.
4) Using the TORX BIT T30 (Tamper resistant B: INSTALLATION
type), loosen the two TORX bolts which secure Install in the reverse order of removal.
driver's airbag module.
C: INSPECTION
Measure the cruise control command switch resis-
tance.

(1)

4 3 2 1
CC-00018

(1) TORX BIT T30


CC-00183
5) Disconnect the airbag module connector on
back of airbag module. Switch Position Terminal No. Standard value
6) Remove the horn switch from steering wheel as ON 1 (+) and 2 (−) Less than 1 Ω
shown. CANCEL
ON 1 (+) and 3 (−) Less than 1 Ω
OFF 1 and 2 More than 1 MΩ
SET/COAST
ON 1 and 2 Less than 1 Ω
RESUME/ OFF 1 and 3 More than 1 MΩ
ACCEL ON 1 and 3 Less than 1 Ω

If NG, replace the cruise control command switch.

CC-00019

CC-7

You might also like