Professional Documents
Culture Documents
DPP 3 Physics
DPP 3 Physics
Subject : Physics
2.
3.
4.
5.
6.
7.
8.
(D) elliptical
9.
You have a coil and a bar magnet. You can produce an electric current by moving : (A) the magnet, but not the coil (B) the coil, but not the magnet (C) either the magnet or the coil (D) neither the magnet nor the coil A device that can be used to produce an electric current in a circuit is : (A) an ammeter (B) a motor (C) a generator
10.
(D) a galvanometer
11.
A charge q is moving with a velocity (v) parallel to a magnetic field (B) . Force on the charge due to magnetic field is : (A) qvB (B) qB/v (C) zero (D) Bv/q
12. As shown in the diagram, two mutually perpendicular wires are placed very close to each other, but are not touching each other. The regions where the intensity of magnetic field is zero is/are :
(B) B, D
(C) A, B
(D) B only
A coil is connected to 2V battery. Now this battery is replaced by a 4V battery, the magnetic field around the coil : (A) increases (B) decreases (C) does not change (D) none of these The direction of magnetic lines of force produced by passing a direct current in a conductor is : (A) perpendicular to the conductor & coming outwards (B) parallel to the conductor (C) surrounding the conductor and of circular nature (D) perpendicular to the conductor & coming inwards The surest test of magnetism is : (A) attraction (B) repulsion
14.
15.
16.
If two bulbs, whose resistance are in the ratio of 1 : 2, are connected in series. The power dissipated in them has the ratio of : (A) 1 : 1 (B) 1 : 2 (C) 2 : 1 (D) 1 : 4 A circuit has fuse of 5A. What is the maximum number of 100W (220 V) bulb that can be safely used in the circuit ? (A) 5 (B) 7 (C) 9 (D) 11 Choose the correct statement : (A) Ammeter measure current and is always connected in parallel in electric circuit. (B) Ammeter measure accurate current and is always connected in series in electric circuit. (C) In ammeter, a high resistance is connected in series. (D) Resistance of an ideal ammeter should be zero. Reading of ammeter in ampere for the following circuit is :
17.
18.
19.
(B) 1
(C) 0.4
(D) 2
If the length of a wire is doubled and its cross-section area is also doubled, then the resistance will be : (A) increase eight times (B) decrease four times (C) become four times (D) remain unchanged