This document provides instructions for replacing the scan window on an AdaptaScan bar code reader. It describes replacement window kits that are available and provides step-by-step instructions for removing the old window and installing the new one. Special attention is given to avoiding eye damage and preventing static discharge during the replacement process.
This document provides instructions for replacing the scan window on an AdaptaScan bar code reader. It describes replacement window kits that are available and provides step-by-step instructions for removing the old window and installing the new one. Special attention is given to avoiding eye damage and preventing static discharge during the replacement process.
This document provides instructions for replacing the scan window on an AdaptaScan bar code reader. It describes replacement window kits that are available and provides step-by-step instructions for removing the old window and installing the new one. Special attention is given to avoiding eye damage and preventing static discharge during the replacement process.
This document provides instructions for replacing the scan window on an AdaptaScan bar code reader. It describes replacement window kits that are available and provides step-by-step instructions for removing the old window and installing the new one. Special attention is given to avoiding eye damage and preventing static discharge during the replacement process.
Plastic window kit includes bezel/window assembly with hard coated, anti–reflective optical plastic window.
ATTENTION: Disconnect the power to the Reader before
attempting to replace the scan window to avoid potential eye ! damage from the laser beam.
5HPRYLQJWKH6FDQ:LQGRZ
ATTENTION: Many electronic components in the scanner are
static sensitive. Anyone servicing the scanner should be well ! grounded through an ESD strap and ground cord. For additional protection from static discharge, the Reader should be attached to the wiring base.
1. Shut off power to the Reader.
2. Clean around the window bezel. 3. Refer to the figure below and remove the six #6–32 screws located around the bezel/window assembly.
4. Carefully pull away the bezel/window assembly from the front of the Reader.
ATTENTION: Do not touch internal mirrors. Smudges from
fingerprints will diffuse the laser beam. Do not allow any ! debris to fall into the open Reader.
5. Discard the old bezel/window assembly.
,QVWDOOLQJWKH5HSODFHPHQW:LQGRZ
1. Be careful not to smudge the window when removing the bezel/window assembly from its packaging. If needed, refer to the AdaptaScan Reader user manual for cleaning instructions.
2. Place the bezel/window assembly against the front of the Reader, aligning the six #6–32 screws with the six holes on the Reader body. Make sure that the bezel/window assembly is positioned with the wider side to the top of the Reader.
Top of Scan Window
3. Tighten the six #6–32 screws to a torque of 10 in/lbs (1.1 N–m) in a side to side sequence to provide even compression of the sealing gasket.
4. Refer to the AdaptaScan user manual to install, align, and verify optimum operation before returning the Reader to service. Observe all warnings and cautions on the product and in the user manual.
