www.DataSheet4U.

com

www.fairchildsemi.com

UC3842A/UC3843A
SMPS Controller

Features Description
• Low Start Current 0.2mA (typ) The UC3842A/UC3843A are fixed PWM controller for Off-
• Operating Range Up To 500KHz Line and DC to DC converter applications. The internal cir-
• Cycle by Cycle Current Limiting cuits include UVLO, low start up current circuit, tempera-
• Under Voltage Lock Out With Hysteresis ture compensated reference, high gain error amplifier,
• Short Shutdown Delay Time: typ.100ns current sensing comparator, and high current totem-pole out-
• High Current Totem-pole Output put for driving a POWER MOSFET. Also UC3842A/
• Output Swing Limiting: 22V UC3843A provide low start up current below 0.3mA and
short shutdown delay time typ. 100ns. The UC3842A has
UVLO threshold of 16V(on) and 10V(off). The UC3843A is
8.4V(on) and 7.6V(off). The UC3842A and UC3843A can
operate within 100% duty cycle.

8-DIP

1
8-SOP

Internal Block Diagram

7 VCC
29V
5V SET/
VREF 8 VREF RESET 5 GND
UVLO
Internal
Bias Good LOGIC

7 PWR
1/2VREF VC
Error Amp C.S PWM
Comp. LATCH
+
1/3
VFB 2 - R
22V 6 OUTPUT
1V
S
COMP 1
5 PWR
T GND
C.S 3

RT/CT 4 OSCILLATOR

Rev. 5.0
©2000 Fairchild Semiconductor International
 www.DataSheet4U.com
UC3842A/UC3843A

Absolute Maximum Ratings

Parameter Symbol Value Unit
Supply Voltage VCC 30 V
Output Current IO ±1 A
Analog Inputs (pin 2, 3) VI(ANA) - 0.3 to 6.3 V
Error Amp. Output Sink Current ISINK(EA) 10 mA
Power Dissipation PD 1 W

Electrical Characteristics
(VCC = 15V, RT = 10KΩ, CT = 3.3nF, TA = 0°C to + 70°C ,Unless otherwise specified)

Parameter Symbol Conditions Min. Typ. Max. Unit

REFERENCE SECTION
Output Voltage VREF TJ = 25°C, IO = 1mA 4.9 5.0 5.1 V
Line Regulation ∆VREF VCC = 12V to 25V - 6 20 mV
Load Regulation ∆VREF IO = 1mA to 20mA - 6 25 mV
Output Short Circuit ISC Ta = 25°C - - 100 - 180 mA
OSILLATOR SECTION
Initial Accuracy FOSC TJ = 25°C 47 52 57 KHz
Voltage Stability STV VCC = 12V to 25V - 0.2 1 %
Amplitude VOSC VPIN4, Peak to Peak - 1.7 - V
Discharge Current IDISCHG TJ = 25°C, Pin4 = 2V 7.8 8.3 8.8 mA
CURRENT SENSE SECTION
Gain GV (NOTE 2, 3) 2.85 3 3.15 V/V
Maximum Input Signal VI(MAX) VPIN1 = 5V(NOTE 2) 0.9 1.0 1.1 V
PSRR PSRR VCC = 12V to 25V (NOTE 1, 2) - 70 - dB
Input Bias Current IBIAS - - -2 -10 uA
Delay to Output TD VPIN3 = 0 V to 2V (NOTE1) - 100 200 ns

2
 www.DataSheet4U.com
UC3842A/UC3843A

Electrical Characteristics (Continued)

(VCC = 15V, RT = 10KΩ, CT = 3.3nF, TA = 0°C to + 70°C, Unless otherwise specified)

Parameter Symbol Conditions Min. Typ. Max. Unit

ERROR AMPLIFIER SECTION
Input Voltage VI TPIN1 = 2.5V 2.42 2.50 2.58 V
Input Bias Current IBIAS - - -0.3 -2 uA
Open Loop Gain GVO VO = 2V to 4V (NOTE 1) 65 90 - dB
Unity Gain Bandwidth GBW TJ= 25°C (NOTE 1) 0.7 1 - MHz
PSRR PSRR VCC = 12V to 25V (NOTE 1) 60 70 - dB
VPIN2 = 2.7V
Output Sink Current ISINK 2 6 - mA
VPIN1 = 1.1V
VPIN2 = 2.3V
Output Source Current ISOURCE -0.5 -0.8 - mA
VPIN1 = 5.0V
VPIN2 = 2.3V
Output High Voltage VOH 5 6 - V
R1 = 15KΩ to GND
VPIN2 = 2.7V
Output Low Voltage VOL - 0.8 1.1 V
R1 = 15KΩ to Pin8
OUTPUT SECTION
Output Low Level VOL ISINK = 20mA - 0.1 0.4 V
ISINK = 200mA - 1.5 2.2 V
Output High Level VOH ISOURCE = 20mA 13 13.5 - V
ISOURCE = 200mA 12 13.5 - V
Rise Time tR TJ = 25°C, C1 = 1nF (NOTE 1) - 40 100 ns
Fall Time tF TJ = 25°C, C1 = 1nF (NOTE 1) - 40 100 ns
Output Voltage Swing Limit VOLIM VCC = 27V, C1 = 1nF - 22 - V
UNDER VOLTAGE LOCKOUT SECTION
UC3842A 15 16 17 V
Start Threshold VTH
UC3843A 7.8 8.4 9.0 V
Min. Operating Voltage UC3842A 9 10 11 V
VTL
( After turn on ) UC3843A 7.0 7.6 8.2 V
PWM SECTION
Maximum Duty Cycle DMAX UC3842A/UC3843A 94 96 100 %
Minimum Duty Cycle DMIN - - - 0 %
TOTAL STANDBY CURRENT
Start-Up Current IST - - 0.2 0.4 mA
Operating Supply Current ICC VPIN2 = VPIN3 = 0V - 11 17 mA
VCC Zener Voltage VZ ICC = 25mA - 29 - V

* Adjust VCC above the start threshold before setting at 15V

Notes :
1. These parameters, although guaranteed, are not 100% tested in production.
2. Parameter measured at trip point of latch with V2 = 0V.
3. Gain defined as: GV = ∆VPIN1∆VPIN3(VPIN3 = 0 to 0.8V)

3
 www.DataSheet4U.com
UC3842A/UC3843A

Mechanical Dimensions
Package

8-DIP

)
6.40 ±0.20

0.031
0.79
0.252 ±0.008

1.524 ±0.10
0.060 ±0.004
0.018 ±0.004
0.46 ±0.10
(
#1 #8
0.362 ±0.008
MAX

9.20 ±0.20
0.378
9.60

#4 #5

0.100
2.54

5.08 3.30 ±0.30

MAX 0.130 ±0.012
0.200
7.62
0.300 3.40 ±0.20 0.33
0.134 ±0.008 0.013 MIN

+0.10
0.25 –0.05
+0.004
0.010 –0.002
0~15°

4
 www.DataSheet4U.com
UC3842A/UC3843A

Mechanical Dimensions (Continued)

Package

8-SOP
0.1~0.25
MIN
0.004~0.001
1.55 ±0.20
0.061 ±0.008

)
0.022
0.56
(
#1 #8
0.194 ±0.008
MAX

4.92 ±0.20
0.202
5.13

0.016 ±0.004
0.41 ±0.10
#4 #5
0.050
1.27

6.00 ±0.30 1.80

0.236 ±0.012 MAX
0.071
0.006 -0.002

0.15 -0.05

MAX0.004
MAX0.10

3.95 ±0.20
+0.004

+0.10

0.156 ±0.008
8°

5.72
0~

0.225
0.50 ±0.20
0.020 ±0.008

5
 www.DataSheet4U.com
UC3842A/UC3843A

Ordering Information
Product Number Package Operating Temperature
UC3842AN 8 DIP
UC3842AD 8 SOP
0 ~ + 70°C
UC3843AN 8 DIP
UC3843AD 8 SOP

6
www.DataSheet4U.com
UC3842A/UC3843A

7
 www.DataSheet4U.com
UC3842A/UC3843A

LIFE SUPPORT POLICY

FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES
OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR
INTERNATIONAL. As used herein:
1. Life support devices or systems are devices or systems 2. A critical component in any component of a life support
which, (a) are intended for surgical implant into the body, device or system whose failure to perform can be
or (b) support or sustain life, and (c) whose failure to reasonably expected to cause the failure of the life support
perform when properly used in accordance with device or system, or to affect its safety or effectiveness.
instructions for use provided in the labeling, can be
reasonably expected to result in a significant injury of the
user.

www.fairchildsemi.com

7/12/00 0.0m 001

Stock#DSxxxxxxxx
” 2000 Fairchild Semiconductor International