Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

DD AFD 101 Lesson1 Pretest1

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Lesson 1 Pre-Test

Answer the following questions. Questions that you are not sure of, leave blank.

Multiple Choice
1. Adjustable Frequency Drives work with which of the following motors?
a. Single-Phase Motors
b. Three-Phase Motors
c. Four-Pole Motors
d. B and C are correct but not A.
e. A, B and C are all correct.

2. The setting for the speed of an AFD is known as which of the following:
a. Setpoint
b. Control Point
c. Reference
d. Speed Point
e. All of the above are common names for the speed setting.

3. Braking becomes important with an AFD during which of the following:


a. Stopping of the motor.
b. Starting the motor.
c. Holding the motor at zero speed.
d. Holding the motor at maximum speed.
e. Ramp-up of the motor.

4. During the Ramp-Down of the motor, which of the following limits might
cause the AFD to trip and give an alarm condition?
a. Over-Current
b. Torque Limits
c. Over-Frequency
d. Over-Voltage
e. Minimum Limits

5. During the acceleration of the AFD, this is also known inside the drive as
which of the following:
a. Increase Speed
b. Increase Setpoint
c. Speed UP
d. Ramp-Up
e. Run-Up
How did you do?

Answers:
1. D. Both Three-Phase and 4-Pole motors work with an AFD but not a
single-phase motor.
2. C. Reference
3. A. Braking is involved with stopping the motor.
4. D. Over-Voltage alarms appear mainly during ramp down.
5. D. Acceleration is also known as Ramp-Up.

If you got 4 or 5 right – skip to Lesson 2.

If you only got 3 or less right please review this lesson.

You might also like