Geophysics 224 Geophysical Exploration Techniques Final Exam Section Instructor Date Time Allowed

Geophysics 224 Geophysical exploration techniques
Final exam
Section
Instructor
Date
Time allowed
224 Lecture B01

Dr. Martyn Unsworth
Wednesday April 21st 2004, P631
9:00 a.m. 12:00a.m.
Total = 100 points

Please attempt ALL questions.
Notes and books may NOT be used during the exam.
Calculators are permitted.
Please show all working, as credit will be given for your method as well as the final
answer.
All questions should be directed to the invigilator.
Please hand in this exam, with your answer booklet
Name _____________________________________
Question 1
(a) The figure below shows a seismic bright spot due to a gas reservoir. Why does a
concentration of gas produce a strong seismic reflection?
Use the data below to estimate the porosity of the gas reservoir
Reservoir (gas saturated sandstone) v = 2200 m/s
Sandstone with no gas
v = 4200 m/s
Gas
v = 300 m/s
(8 points)
(b) Explain what is meant by common mid-point profiling.
Sketch the distribution of shot points and geophones for a 6-fold CMP gather.
Describe two advantages of multichannel CMP profiling, compared to single
channel profiling.
(8 points)
(c) The smallest vertical distance that can be resolved with seismic reflection is a
quarter of a wavelength (/4). Explain this fact with the aid of a diagram.
Why does an increase in signal frequency not always improve data quality in a
seismic survey?
(8 points)
Total Q1 = 24 points
Question 2
The figure below shows a map of the Bouguer gravity anomaly measured over a landfill.
(a) What does the negative Bouguer anomaly tell us about the density of the landfill?
(b) Where is the deepest part of the landfill? (Mark with X)
(c) The density contrast between the landfill and the bedrock is 200 kg m -3. Estimate
the thickness of the landfill at the deepest point.
(d) Explain two assumptions that you have made in your analysis. How will these
assumptions influence your answer to (c)
Question 3 seismic refraction

The figure below shows the geometry of a seismic refraction survey.
Two shots were fired (S1-S2). Geophones extend from A to B.
(a) On the attached graph, draw the travel times that you would observe. Include both
direct waves and refractions for the 2 shots
Indicate the relative slope of each curve where relevant.
Also indicate relative travel times where necessary.
Also show the travel times for the reflection from the dipping layer
(12 points)
(b) Briefly explain two situations in which refraction exploration can fail to detect a
subsurface layer.
(4 points)
Question 4 Seismic reflection

The figure below shows a common mid-point gather that was collected over a layered
Earth. Selected travel times are listed in the table on the right.
Remember that when the shot is a +x, the geophone is at x. Thus the offset is 2x
x(m)
100.000
80.000
60.000
40.000
20.000
0.000
ref1(ms) ref2(ms)
614.699
609.463
605.353
602.394
600.606
600.000
(a) On the figure, label each seismic signal that is observed.
990.808
989.326
988.161
987.336
986.836
986.667
(3 points)
(b) Compute the velocity (v1) and thickness (z1) of the upper layer (5 points)
(c) Compute the r.m.s. velocity for the second reflection (Vrms,2)
(3 points)
(d) Compute the velocity (v2) and thickness (z2) of the second layer (4 points)
(e) The reflection coefficient for the first reflection was measured at 0.33. Show
that this is consistent with the values of v1 and v2
(4 points)
(f) The amplitude of the second reflection was 0.17. Compute the reflection
coefficient at the second interface. Estimate v3
(5 points)
Assume that density is the same in all layers.
Question 5
(a) Explain what is meant by induced magnetization and remnant
magnetization. Outline the physical basis for each type of magnetization.
(6 points)
(b) What causes the Earths magnetic field to vary over timescale of hours to
days? Why is this a problem for magnetic exploration, and how can it be
overcome?
(6 points)
(c) The figure above shows a section through the Earth at the magnetic North
Pole. Sketch the total magnetic field (F) that would be measured on the
profile A-A. Explain how you obtained your answer.
(6 points)
(d) Repeat this exercise for the profile B-B at the magnetic Equator. (6 points)
Formulae that may be useful

Seismic exploration
v = velocity
x = source-receiver offset
t = travel time
= density
v = distance
time
For a porous rock, the velocity (v) is given by the time average equation:
1 (1 )
v vf
vm
where = porosity, vf = velocity in fluid; vm = velocity in rock matrix
Seismic impedance , Z = v
Seismic wave travelling from layer 1 to layer 2, at normal incidence
Z 2 Z1
Z 2 Z1
2Z 1
Amplitude transmission coefficient, T =
Z 2 Z1
Amplitude reflection coefficient,
Normal move out (NMO) = t t t 0
R=
x2
2t 0 v 2
t0 = travel time at normal incidence

x = distance from shot to receiver
Dix equation
where
and
1
2
2
2
Vrms
, n t n V rms , n 1t n 1
vn
vn
Vrms,n
tn
t n t n 1
= interval velocity of nth layer

= r.m.s velocity of nth reflector
= normal incidence travel time for nth reflector
Gravity exploration
a = radius of sphere or cylinder
= density contrast
z = depth of the sphere or cylinder

G = 6.67 x 10-11 N m2 kg-2
MS = excess mass
x = horizontal distance from sphere/cylinder

1 milligal
= 10-5 ms-2
x
= half width
Cylinder
Sphere
2Ga 2 z
gz
(x 2 z 2 )
gz
x = z
GM S z
3
(x2 z 2 ) 2
x = 0.766z
Gravitational attraction of slab with thickness h (m) and density contrast (kg m-3)
gz = 2Gz (ms-2)
Change in gz when elevation changes by z (m)
gz = 0.3 z (milligals)

Geophysics 224 Geophysical Exploration Techniques Final Exam Section Instructor Date Time Allowed

Uploaded by

Copyright:

Available Formats

Geophysics 224 Geophysical Exploration Techniques Final Exam Section Instructor Date Time Allowed

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Geophysics 224 Geophysical Exploration Techniques Final Exam Section Instructor Date Time Allowed

Uploaded by

Copyright:

Available Formats

Geophysics 224 Geophysical exploration techniques

224 Lecture B01

Total = 100 points

Question 3 seismic refraction

Question 4 Seismic reflection

(a) On the figure, label each seismic signal that is observed.

Formulae that may be useful

where = porosity, vf = velocity in fluid; vm = velocity in rock matrix

Amplitude reflection coefficient,

Normal move out (NMO) = t t t 0

t0 = travel time at normal incidence

= interval velocity of nth layer

z = depth of the sphere or cylinder

x = horizontal distance from sphere/cylinder

You might also like