12 - 22 Bindhu Rubini

ISSN (Print) : 2320 3765
ISSN (Online): 2278 8875
International Journal of Advanced Research in Electrical,

Electronics and Instrumentation Engineering
(An ISO 3297: 2007 Certified Organization)
Vol. 5, Special Issue 5, March 2016
Modelling and Simulation of Z Source Matrix

Converter fed Induction Motor
V.Bindhu1, J.Rubini2
Head of the Department, Dept. of EEE, Arunai Engineering College, Thiruvannamalai, Tamilnadu, India1
PG Student [PED], Dept. of EEE, Arunai Engineering College, Thiruvannamalai, Tamilnadu, India2
ABSTRACT: This project presents a single phase z-source buck-boost matrix converter which can buck and boost the
output voltage with step change frequency i.e. both the voltage and the frequency can be stepped up or stepped down.
Also, this converter uses a safe-commutation technique to conduct current in a continuous path, resulting in the
elimination of voltage spikes on switches without the need for a snubber circuit. It has no energy storage devices,
performing the energy conversion by directly connecting input with output phases through bidirectional switches. For
this reason, it is known as all-silicon power converters. In the proposed scheme, micro controller is used to produce
PWM signals. In particular it can be applied to the starting of an induction motor as well as to the speed control of an
induction motor. The operating principles, analysis and experimental results of the proposed single phase z-source
buck-boost matrix converter fed induction motor are implemented in Matlab / Simulink.
KEYWORDS: Buckboost voltage, single-phase matrix converter, stepup and stepdown frequency, Zsource converter
I.INTRODUCTION
A matrix converter is an ac/ac converter that can directly convert an ac voltage of constant amplitude into an ac
voltage of variable amplitude and frequency without large energy storage element. The use of safe-commutation
switches with pulse width modulation (PWM) control can significantly improve the performance of ac/ac converters. In
this project work we apply the Z-source concept to a single phase matrix converter to create a new type of converter
called a single phase Z-source buck-boost matrix converter. In contrast to the existing single phase PWM AC-AC
converters, this proposed single phase Z-source buck-boost matrix converter can provide a wide range of output AC
voltages in buck-boost mode with step up/step down frequencies. The safe commutation scheme establishes a
continuous current path in dead time to eliminate voltage spikes on the switches without a snubber circuit. The
proposed single-phase Z-source buckboost matrix converter can be used for voltage applications that require stepchanged frequency or amplitude. In particular, it can be applied to the starting of an asynchronous motor as well as to
the speed control of an induction motor, which needs a step-changed speed. The various graphs/waveforms are
analyzed and studied on MATLAB / SIMULINK.
II. PROPOSED SYSTEM
In this paper, we apply the Z-source concept to a single-phase matrix converter to create a new type of converter called
a single-phase Z-source buckboost matrix converter. We use a safe-commutation technique that is very simple to
implement as a free-wheeling path to provide the required free-wheeling operation similar to what is available in other
converter topologies. It also provides a continuous current path by using a commutation strategy. The use of this safecommutation strategy is a significant improvement as it makes it possible to avoid voltage spikes on the switches
without the use of a snubber circuit.
III.Z SOURCE CONVERTER
The Z-source converter (ZSC) is an alternative power conversion topology that can both buck and boost the
input voltage using passive components. It uses a unique LC impedance network for coupling the converter main
circuit to the power source, which provides a way of boosting the input voltage, a condition that cannot be obtained in
Copyright to IJAREEIE
www.ijareeie.com
68
ISSN (Print) : 2320 3765



the traditional inverter. It also allows the use of the shoot-through switching state, which eliminates the need for deadtimes that are used in the traditional inverters to avoid the risk of damaging the inverter circuit.
Fig 1 Circuit diagram of z source converter

STEADY STATE OPERATION OF ZSC
Operation of ZSC in continuous conduction mode (CCM) based on two states,
1. Shoot-through state
(S2 is on & S1 is off)
2. Active state
(S1 is on & S2 is off)
SHOOT-THROUGH STATE
Fig 2 circuit diagram for shoot-through state

For Z-source network to be symmetrical,
Let the converter is in the shoot-through state for an interval of T0 during a switching cycle T,
ACTIVE STATE
Similarly, if the converter is in the active state for an interval of T1, during the switching cycle T,
www.ijareeie.com
69
ISSN (Print) : 2320 3765


Fig 3 circuit diagram for active state

IV. MATRIX CONVERTER
Since no energy storage components are present between the input and output side of the matrix converter, the
output voltages have to be generated directly from the input voltages. Each output voltage waveform is synthesized by
sequential piecewise sampling of the input voltage waveforms. The sampling rate has to be set much higher than both
input and output frequencies ,and the duration of each sample is controlled in such a way that the average value of the
output Waveform within each sample period tracks the desired output waveform. As consequence of the input-output
direct connection, at any instant, the output voltages have to fit within the enveloping curve of the input voltage system.
Under this constraint, the maximum output voltage the matrix converter can generate without entering the overmodulation range is equal to v3/2 of the maximum input voltage: this is an intrinsic limit of matrix converter.
V.THE INPUT CURRENT
Likewise to the output voltages, the input currents are directly generated by the output currents, synthesized by
sequential piecewise sampling of the output current waveforms. If the switching frequency of the matrix converter is
set to a value that is much higher than the input and output frequency, the input currents drawn by the converter are
sinusoidal their harmonic spectrum consists only of the fundamental desired component plus a harmonic content
around the switching frequency.The matrix converter performance in terms of input currents represent a significant
improvement with respect to the input currents drawn by a traditional VSI converters with a diode bridge rectifier,
whose harmonic spectrum shows a high content of low-order harmonics. By the light of the standards related to power
quality and harmonic distortion of the power supply this is a very attractive feature of matrix converter.
VI. SIMULATION RESULTS
BUCK OPERATION
www.ijareeie.com
70
ISSN (Print) : 2320 3765



BOOST OPERATION
BOOST OPERATION OF Z SOURCE MATRIX CONVERTER VOLTAGE
BOOST OPERATION OF Z SOURCE MATRIX CONVERTER CURRENT
www.ijareeie.com
71
ISSN (Print) : 2320 3765



BUCK OPERATION OF Z SOURCE MATRIX CONVERTER VOLTAGE
BUCK OPERATION OF Z SOURCE MATRIX CONVERTER CURRENT
BOOST OPERATION OF Z SOURCE MATRIX CONVERTER SPEED
www.ijareeie.com
72
ISSN (Print) : 2320 3765



VII.CONCLUSION
In this project, a new Z-source Buck-Boost single phase matrix converter proposed that can buck and boost the input
voltage to the desired output voltage. The proposed SPZMC can produce a boosted output voltage when compared with
a normal matrix converter. The output voltage is boosted when there is change in pulse width of the switching
frequency. The use of this safe-commutation strategy is a significant improvement as it makes it possible to avoid
voltage spikes on the switches without the use of a snubber circuit. The proposed converter is particularly suitable for
controlling the speed of a fan or a pump without the use of an inverter because for these applications, the input voltage
frequency must be changed to control their speed by stages.
REFERENCES
[1] Siinter and O. Aydogmus, Modelling and simulation of matrix converter induction motor drive, "Springer Electr. Eng., vol. 90, no. 6,pp. 425
433, 2012
[2] A. Zuckerberger, D. Weinstock, A. Alexandrovitz, Single -phase matrix converter, IEE Proceedings Electric Power Application, Vol. 144 (4),
Page(s): 235-240, Jul2013
[3] X. P. Fang, Z. M. Qian, and F. Z. Peng, Single-phase z-source PWM ac-ac converters,IEEE Power Electron. Lett., vol. 3, no. 4, pp. 121
124,2013.
[4] P. C. Loh, R. Rong, F. Blaabjerg, and P.Wang, Digital carrier modulation and sampling issues of matrix converters, IEEE Trans. Power
Electron., vol. 24, no. 7, pp. 16901700, Jul. 2009.
[5] Y. D. Yoon and S. K. Sul, Carrier-based modulation technique for matrix converter, IEEE Trans. Power Electron., vol. 21, no. 6, pp. 1691
1703, Nov. 2006.
[6] M. Jussila and H. Tuusa, Comparison of simple control strategies of space-vector modulated indirect matrix converter under distorted supply
voltage, IEEE Trans. Power Electron., vol. 22, no. 1, pp. 139148, Jan. 2007.
[7] I. Sato, J. Itoh, H. Ohguchi, A. Odaka, and H. Mine, An improvement method of matrix converter drives under input voltage disturbances,
IEEE Trans. Power Electron., vol. 22, no. 1, pp. 132138, Dec. 2011.
www.ijareeie.com
73

12 - 22 Bindhu Rubini

Uploaded by

Copyright:

Available Formats

12 - 22 Bindhu Rubini

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

12 - 22 Bindhu Rubini

Uploaded by

Copyright:

Available Formats

ISSN (Print) : 2320 3765

ISSN (Online): 2278 8875

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

Modelling and Simulation of Z Source Matrix

ISSN (Print) : 2320 3765

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

Fig 1 Circuit diagram of z source converter

Fig 2 circuit diagram for shoot-through state

ISSN (Print) : 2320 3765

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

Fig 3 circuit diagram for active state

ISSN (Print) : 2320 3765

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

BOOST OPERATION OF Z SOURCE MATRIX CONVERTER VOLTAGE

BOOST OPERATION OF Z SOURCE MATRIX CONVERTER CURRENT

ISSN (Print) : 2320 3765

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

BUCK OPERATION OF Z SOURCE MATRIX CONVERTER CURRENT

BOOST OPERATION OF Z SOURCE MATRIX CONVERTER SPEED

ISSN (Print) : 2320 3765

International Journal of Advanced Research in Electrical,

Vol. 5, Special Issue 5, March 2016

You might also like