Qcsolprob
Qcsolprob
Qcsolprob
1. Which of the wavefunctions shown in the figure are well behaved? Give reasons for your
answer.
3. State, giving your reasons, which of the following functions would make satisfactory
2 2 2
wavefunctions for all values of the variable x: (i) Neax ; (ii) Ne−ax ; (iii) Ne−ax /(3 − x );
and (iv) Ne−ax , where N and a are constants.
4. Calculate the wavelength of the radiation that will be absorbed in promoting an electron
from the highest occupied molecular orbital (HOMO) to the lowest unoccupied molecular
orbital (LUMO) in butadiene.
6. For a one-dimensional gallium arsenide quantum well of width 21 nm, calculate the
difference in energies between the n = 2 and n = 3 states for travel of conduction
electrons across the width of the well. Compare your answer with the experimentally
determined value of approximately 0.05 eV.
7. For a particle moving freely along the x-axis, show that the Heisenberg uncertainty
principle can be written in the alternative form:
λ2
∆λ∆x ≥
4π
where ∆x is the uncertainty in position of the particle and ∆λ is the simultaneous
uncertainty in the de Broglie wavelength.
what is the probability of obtaining the energy of the ground state, E1 , if a measurement
of the energy is carried out?
1. Which of the wavefunctions shown in the figure are well behaved? Give reasons for your
answer.
Answer: Only the wavefunction shown in (c) is well behaved. The one shown in (a)
tends towards infinity, and therefore violates the rule that the integral of ψ∗ ψ over
all space must be equal to one because the particle is certain to be somewhere. This
requires that the wavefunction is finite. The one shown in (b) has multiple values of
for a given value of x, and the one shown in (d) has discontinuities in the gradient,
so that dy/fdx cannot be defined at certain points.
2. The wavefunction of a particle confined to the x axis is ψ = e− x for x > 0 and ψ = e+ x
for x < 0. Normalize this wavefunction and calculate the probability of finding the
particle between x = −1 and x = 1.
Answer: Normalization refers to the requirement that
Z ∞
ψ∗ ψ dx = 1.
−in f ty
In this instance, the denominator in the above expression is unity. The probability
of finding the particle in the desired region is
Z 1 Z −1
1 2
e− x e− x dx + ex ex dx = e − e−2
P=
0 0 2
3. State, giving your reasons, which of the following functions would make satisfactory
2 2 2
wavefunctions for all values of the variable x: (i) Neax ; (ii) Ne−ax ; (iii) Ne−ax /(3 − x );
and (iv) Ne−ax , where N and a are constants.
4. Calculate the wavelength of the radiation that will be absorbed in promoting an electron
from the highest occupied molecular orbital (HOMO) to the lowest unoccupied molecular
orbital (LUMO) in butadiene.
Answer: First, an estimate has to be made of the length of the potential well, L, in
which the π-electrons move. It seems reasonable to take the mean C-C distance
to be equal to the average of the carbon-carbon single and double bond lengths
found in a variety of non-conjugated compounds - this is a different approach from
that adopted in HW4. With d(C−C)= 154 pm and d(C−C) = 135 pm, this leads to
a value of 144.5 pm. The total length of the box is then taken to be equal to four
carbon-carbon bond lengths, giving L = 578 pm.
The highest occupied n electron state has n = 2, and the lowest unoccupied state
has n = 3. The energy required to promote an electron from one state to the other
is given by the equation:
2
32 − 22 h 2 5 × 6.626 × 10−34 J s−1
E3 − E2 = =
8mL2 8 × 9.109 × 10−31 kg × (578 × 10−12 m)2
Answer: The energy separation between the first and second state of nitrogen molecule
(mN2 = 28 × 1.661 × 10−27 kg in a box of length 1 cm is
2
22 − 12 h2 3 × 6.626 × 10−34 J s−1
E2 − E1 = =
8mN2 L2 8 × 4.651 × 10−26 kg × (1.0 × 10−2 m)2
∆E = 3.54 × 10−38 J
The n corresponding to thermal energy is so high that quantum effects are unlikely
to be observed.
6. For a one-dimensional gallium arsenide quantum well of width 21 nm, calculate the
difference in energies between the n = 2 and n = 3 states for travel of conduction
electrons across the width of the well. Compare your answer with the experimentally
determined value of approximately 0.05 eV.
Answer: Semiconductor quantum wells are sandwich structures made from semicon-
ducting materials. They have numerous applications in modern electronic devices.
An example is illustrated in the figure below. The base material is the III/V semi-
conductor gallium arsenide (GaAs). A thin layer of pure GaAs was been created
between two layers of aluminium gallium arsenide, a material in which some of the
gallium has been replaced with aluminium to give the formula Alx Ga1-x As. Nearly
free electrons, known as conduction electrons, can exist in these semiconductors,
and they have a much higher potential energy in Alx Ga1-x As than they do in pure
GaAs. Thus, conduction electrons in the pure GaAs become trapped between two
potential walls and behave like particles in a one-dimensional box when moving in
the x-direction, although they have complete freedom of movement in the y and z
directions. Unlike the idealized particle in an infinite potential well, this one has
finite walls. This affects the wavefunctions and energies to a small extent, but the
equations derived earlier will still give reasonably accurate values for the energies.
The existence of discrete energy levels is confirmed by the observation of selective
absorption of laser light at certain frequencies which correspond to the transition of
an electron from one energy level to another. The GaAs/Alx Ga1-x As combination
mentioned above forms the basis of the semiconductor laser used in compact
disc players. The energies are the same as that of a particle in a box, except that
the conduction electrons behave as though they have a much smaller mass than
ordinary electrons. This mass is known as the effective mass, m∗ ; for gallium
arsenide, m∗ = 0.067me .
2
32 − 22 h2 5 × 6.626 × 10−34 J s−1
E3 − E2 = =
8m∗ L2 8 × (0.067 × 9.109 × 10−31 kg) × (21 × 10−9 m)2
In eV this is 0.064 eV.
7. For a particle moving freely along the x-axis, show that the Heisenberg uncertainty
principle can be written in the alternative form:
λ2
∆λ∆x ≥
4π
where ∆x is the uncertainty in position of the particle and ∆λ is the simultaneous
uncertainty in the de Broglie wavelength.
dp
Answer: Differentiation of the de Broglie relation, p = h/λ, gives dλ = −h/λ2 . The
uncertainty in momentum, ∆p x , can be equated with dp and the uncertainty in
wavelength, ∆λ, with − dλ (the uncertainties are positive). Thus:
∆p x h λ2
= 2 and ∆λ∆x = ∆p x ∆x
∆λ λ h
Plugging in the Heisenberg uncertainty relation yields the desired result.
dP( x
Answer: (a) The peak in P( x ) occurs when dx = 0 that is, when
d x2 e−2αx
= 2x (1 − αx )e−2αx = 0
dx
which is at x = 1/α.
(b)
Z 1/α
1 2 3! 3
Z
dx 4α3 x3 e−2αx = dyy3 e−y =
hxi = =
0 4α 0 4α 2α
Z 1/α
4! 3
h x2 i = dx 4α3 x4 e−2αx = 3 = 2
0 8α α
(c) The desired probability is
Z 1/α
1 2
Z
dx 4α3 x2 e−2αx = dyy2 e−y = 0.32
P=
0 2 0
(b)
Z ∞ Z L
30
hxi = x |ψ|2 dx = x 5 x2 ( L − x )2 dx
−∞ 0 L
30 L
1 2 1 L
Z
2 3 4 5
= ( L x − 2Lx + x ) dx = 30L − + =
L5 0 4 5 6 2
Z ∞ Z L
30 2
h x2 i = x ( L − x )2 dx
x2 |ψ|2 dx = x2
−∞ 0 L5
30 L 2 4 2L2
1 2 1
Z
= 5 ( L x − 2Lx5 + x6 ) dx = 30L2 − + =
L 0 5 6 7 7
r
2 1
q
∆x = h x2 i − h x i = L −
7 4
(c)
Z ∞ Z L
∂ψ 30
h px i = ψ∗ −ih̄ dx = 5
x ( L − x )(−ih̄( L − 2x )) dx = 0
−∞ ∂x 0 L
Z ∞
∗ 2 ∂ψ
h p2x i = ψ −h̄ dx
−∞ ∂x
30h̄2 L 10h̄2
Z
=− 5 x ( L − x )(−2) dx = 2
L 0 L
q √ h̄
∆p x = h p2x i − h p x i = 10
L
10. If the normalized wave function of a particle in a box is given by
(q
30
L5
x( L − x) 0 < x < L
ψ( x ) =
0 elsewhere
what is the probability of obtaining the energy of the ground state, E1 , if a measurement
of the energy is carried out?
Answer: A measurement of the energy yields E1 , the energy of state 1, with probability
−iE t/h̄ 2
e 1
2
P1 = |c1 | = √ =1
2 2
or E2 with probability
−iE t/h̄ 2
e 2
2
P2 = |c2 | = √ =1
2 2
Because ∑∞ 2
n=1 | cn | = 1, Ψ ( x, t ) is properly normalized. The expectation value of
the energy in the state Ψ ( x, t) is
∞
1 1
h Ei = ∑ Pn En = 2 E1 + 2 E2
n =1
Similarly,
∞
1 1
h E2 i = ∑ Pn En2 = 2 E12 + 2 E22 .
n =1
As a result,
1
q
∆E = h E2 i − (h Ei)2 = ( E2 − E1 )
2
12. Determine h Ei for a particle in a box with wave function
(q
30
L5
x( L − x) 0 < x < L
ψ( x ) =
0 elsewhere
Answer:
Z ∞
h Ei = ψ∗ Ĥψ dx
−∞
Z ∞
!
−h̄2 ∂2 ψ30 −h̄2 L ∂2
Z
∗
= ψ dx =
x ( L − x ) ( x ( L − x )) dx
−∞ 2m ∂x2 L5 2m 0 ∂x2
30 h̄2 L 30 h̄2 3 1 1 5h̄2
Z
= 5 x ( L − x ) dx = 5 L − =
L m 0 L m 2 3 mL2