Overveiw and Operation Process
Overveiw and Operation Process
Overveiw and Operation Process
8310-01/8310-10/8310-13/8320-01/8320-12/8320-16/
8320-19/8610-01
LAMP
LAMP
ACTYON 2008.07
8310-01 06-3
LAMP 8310-01
Headlamp
Push
Push
LAMP
ACTYON 2008.07
06-4 8310-01
LAMP
ACTYON 2008.07
8310-01 06-5
2. INTERIOR LAMPS
Front Room Lamp: 12V/10W - (2 EA) Center Room Lamp: 12V/10W - (1 EA)
Center room
Center room lamp lamp
(coupled operation (Lamp: ON)
with door)
The driver's room lamp and the passenger's Center Room Lamp
room lamp are separately turned on when When this switch is pushed towards the rear of
pressing the switch (1, 2). the vehicle, the lamp comes on when opening
However, the front lamps are turned on when a door and goes off in 30 seconds. If the
opening a door and turned off when closing it. switch is pushed to the opposite direction, the
The front room lamps and center lamp are lamp stays on.
turned on when pressing the room lamp main
switch (3).
LAMP
ACTYON 2008.07
06-6 8310-01
LAMP
ACTYON 2008.07
8310-01 06-7
Headlamp
Headlamp
LAMP
ACTYON 2008.07
06-8 8310-01
High/Low beam
Connector
Connector
Lamp and
housing
LAMP
ACTYON 2008.07
8310-01 06-9
Adjustment Direction
Up Down
Left Right
Vertical hole
Vertical adjustment Transverse
adjustment hole adjustment hole
LAMP
ACTYON 2008.07
06-10 8310-01
Up Up
Down Down
Down Up
The lamp aiming moves The lamp aiming moves up
down and the light faces and the light faces upward
downward when the knob is when the knob is turned
turned counterclockwise. clockwise.
LAMP
ACTYON 2008.07
8320-01 06-11
Backup lamp
Turn signal lamp (bulb)
Combination lamp
assembly
Connector
Lamp
LAMP
ACTYON 2008.07
06-12 8610-01
Bulb
LAMP
ACTYON 2008.07
8610-01 06-13
Bulb Connector
Lens
Bulb
Bulb
LAMP
ACTYON 2008.07
06-14 8310-01
1) Headlamp Assembly
Turn off the lamp switch.
1. Open the engine hood and unscrew two mounting screws on the headlamp lower cover to
remove the lower cover.
LAMP
ACTYON 2008.07
8310-01 06-15
3. Pull the headlamp assembly forward and disconnect two headlamp connectors to remove
the headlamp.
Components
Side lamp/Turn
signal lamp bulb
Headlamp bulb
Headlamp
LAMP
ACTYON 2008.07
06-16 8310-01
Dust cover
2. Unlock the bulb mounting clamp by pushing its upper side and remove the bulb from the
headlamp.
LAMP
ACTYON 2008.07
8310-01 06-17
3. To replace bulbs of side lamp and turn signal lamp, remove the headlamp assembly first.
LAMP
ACTYON 2008.07
06-18 8310-10
LAMP
ACTYON 2008.07
8310-13 06-19
1. Release the side repeater by pushing it rearward and disconnect the side repeater
connector.
2. Disconnect the connector and remove the lamp.
Front Rear
Connector
Lamp
Components
Bulb
Bulb connector
LAMP
ACTYON 2008.07
06-20 8320-01
Mounting screw
2. Disconnect the connector and remove the rear combination lamp assembly.
LAMP
ACTYON 2008.07
8320-01 06-21
3. Open The Bulb Holders/Connectors By Turning Them Counterclockwise And Remove The
Bulbs.
LAMP
ACTYON 2008.07
06-22 8320-12
· The replacement procedure for the license plate lamp and bulb is the same.
1. UNSCREW TWO MOUNTING SCREWS FROM THE LICENSE PLATE LAMP ON THE
REAR BUMPER AND REMOVE THE LAMP.
Removal of bulb
LAMP
ACTYON 2008.07
8320-16 06-23
1. Open the tailgate and remove the cover from the high mounted stop lamp.
Lamp
Bulb assembly
LAMP
ACTYON 2008.07
06-24 8320-19
1. Open the tailgate and remove the rear fog light cover.
LAMP
ACTYON 2008.07
8320-16 06-25
2. Unscrew the mounting screw and remove the rear fog light assembly.
LAMP
ACTYON 2008.07
06-26 8610-01
1. Open the sunglasses box and remove two overhead console assembly mounting screws.
2. Remove the overhead console assembly starting from the front side and disconnect the
connector to remove the overhead console assembly.
Disconnection of connector
LAMP
ACTYON 2008.07
8610-01 06-27
Bulb
LAMP
ACTYON 2008.07
06-28 8610-01
Slot Slot
2. Unscrew the mounting screw on the lamp and remove the lamp assembly. Disconnect the
connector to remove the lamp assembly.
LAMP
ACTYON 2008.07
8610-01 06-29
4) Replacement of Bulb
1. Turn the lamp switch OFF.
2. Remove the lamp cover and replace the
bulb with new one.
Configuration
Lamp bracket
Bulb
Lamp cover
LAMP
ACTYON 2008.07
06-30 8610-01
1. Open the tailgate and remove the luggage room lamp assembly by prying off the cover using
a screwdriver.
Lamp cover
LAMP
ACTYON 2008.07
8610-01 06-31
6) Replacement of Bulb
1. Turn the luggage room lamp switch OFF.
2. Rreplace the bulb with new one.
LAMP
ACTYON 2008.07
06-32 8610-01
LAMP
ACTYON 2008.07
8610-01 06-33
1. Open the glove box and remove the lamp by pushing both sides (arrows).
Connector
Lamp Bulb
▶ Description
1. The tail lamp switch signal is sent to STICS which then outputs the tail lamp relay ground so
that the lamp comes on if the glove box is open.
2. The tail lamp comes on as above if the auto light tail lamp signal is sent to STICS while the
auto light operates.
3. The tail lamp goes off when opening and closing the driver's door after removing the ignition
key even though the operating conditions are met (battery saver function).
LAMP
ACTYON 2008.07