Cambridge International Examinations

Cambridge International Advanced Subsidiary and Advanced Level

* 9 4 3 0 5 6 8 8 8 1 *

PHYSICS 9702/21
Paper 2 AS Structured Questions October/November 2014
1 hour
Candidates answer on the Question Paper.
No Additional Materials are required.

READ THESE INSTRUCTIONS FIRST

Write your Centre number, candidate number and name on all the work you hand in.
Write in dark blue or black pen.
You may use an HB pencil for any diagrams or graphs.
Do not use staples, paper clips, glue or correction fluid.
DO NOT WRITE IN ANY BARCODES.

Answer all questions.

Electronic calculators may be used.

You may lose marks if you do not show your working or if you do not use appropriate units.

At the end of the examination, fasten all your work securely together.
The number of marks is given in brackets [ ] at the end of each question or part question.

This document consists of 15 printed pages and 1 blank page.

DC (NF/CGW) 77818/2
© UCLES 2014 [Turn over
www.egyptigstudentroom.com
 2

Data

speed of light in free space, c = 3.00 × 10 8 m s –1

permeability of free space, μ0 = 4π × 10 –7 H m–1

permittivity of free space, ε0 = 8.85 × 10 –12 F m–1

1
( = 8.99 × 10 9 m F–1 )
4πε0
elementary charge, e = 1.60 × 10 –19 C

the Planck constant, h = 6.63 × 10 –34 J s

unified atomic mass constant, u = 1.66 × 10 –27 kg

rest mass of electron, me = 9.11 × 10 –31 kg

rest mass of proton, mp = 1.67 × 10 –27 kg

molar gas constant, R = 8.31 J K –1 mol –1

the Avogadro constant, NA = 6.02 × 10 23 mol –1

the Boltzmann constant, k = 1.38 × 10 –23 J K–1

gravitational constant, G = 6.67 × 10 –11 N m 2 kg –2

acceleration of free fall, g = 9.81 m s –2

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 3

Formulae

uniformly accelerated motion, s = ut + 12 at 2

v 2 = u 2 + 2as

work done on/by a gas, W = pV

gravitational potential, φ = – Gm
r
hydrostatic pressure, p = ρgh

1 Nm 2
pressure of an ideal gas, p= 3 <c >
V
simple harmonic motion, a = – ω 2x

velocity of particle in s.h.m., v = v0 cos ωt

v = ± ω (x02 – x 2)

Q
electric potential, V=
4πε0r

capacitors in series, 1/C = 1/C1 + 1/C2 + . . .

capacitors in parallel, C = C1 + C2 + . . .

energy of charged capacitor, W = 12 QV

resistors in series, R = R1 + R2 + . . .

resistors in parallel, 1/R = 1/R1 + 1/R2 + . . .

alternating current/voltage, x = x0 sin ωt

radioactive decay, x = x0 exp(– λt)

decay constant, λ = 0.693

t 1
2

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 4

Answer all the questions in the spaces provided.

1 (a) Mass, length and time are SІ base quantities.

State two other base quantities.

1. ..............................................................................................................................................

2. ..............................................................................................................................................
[2]

(b) A mass m is placed on the end of a spring that is hanging vertically, as shown in Fig. 1.1.

spring

mass m

Fig. 1.1

The mass is made to oscillate vertically. The time period of the oscillations of the mass is T.

The period T is given by

m
T=C
k

where C is a constant and k is the spring constant.

Show that C has no units.

[3]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 5

2 (a) Define pressure.

.............................................................................................................................................. [1]

(b) A cylinder is placed on a horizontal surface, as shown in Fig. 2.1.

diameter

cylinder

Fig. 2.1

The following measurements were made on the cylinder:

mass = 5.09 ± 0.01 kg

diameter = 9.4 ± 0.1 cm.

(i) Calculate the pressure produced by the cylinder on the surface.

pressure = .................................................... Pa [3]

(ii) Calculate the actual uncertainty in the pressure.

actual uncertainty = .................................................... Pa [3]

(iii) State the pressure, with its actual uncertainty.

pressure = ........................................... ± ........................................... Pa [1]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 6

3 The resistance R of a uniform metal wire is measured for different lengths l of the wire.
The variation with l of R is shown in Fig. 3.1.

4.0

3.0

R/1

2.0

1.0

0
0 0.20 0.40 0.60 0.80 1.00
l/m

Fig. 3.1

(a) The points shown in Fig. 3.1 do not lie on the best-fit line. Suggest a reason for this.

...................................................................................................................................................

.............................................................................................................................................. [1]

(b) Determine the gradient of the line shown in Fig. 3.1.

gradient = .......................................................... [2]

(c) The cross-sectional area of the wire is 0.12 mm2.

Use your answer in (b) to determine the resistivity of the metal of the wire.

www.egyptigstudentroom.com
resistivity = .................................................. Ω m [3]
© UCLES 2014 9702/21/O/N/14
 7

(d) The resistance R of different wires is measured. The wires are of the same metal and same
length but have different cross-sectional areas A.

On Fig. 3.2, sketch a graph to show the variation with A of R.

0
0 A

Fig. 3.2
[2]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 8

4 A trolley moves down a slope, as shown in Fig. 4.1.

trolley

25° horizontal

Fig. 4.1

The slope makes an angle of 25° with the horizontal. A constant resistive force FR acts up the
slope on the trolley.
At time t = 0, the trolley has velocity v = 0.50 m s−1 down the slope.
At time t = 4.0 s, v = 12 m s−1 down the slope.

(a) (i) Show that the acceleration of the trolley down the slope is approximately 3 m s−2.

[2]

(ii) Calculate the distance x moved by the trolley down the slope from time t = 0 to t = 4.0 s.

x = ..................................................... m [2]

(iii) On Fig. 4.2, sketch the variation with time t of distance x moved by the trolley.

0
0 4.0 t/s

Fig. 4.2
www.egyptigstudentroom.com [2]
© UCLES 2014 9702/21/O/N/14
 9

(b) The mass of the trolley is 2.0 kg.

(i) Show that the component of the weight of the trolley down the slope is 8.3 N.

[1]

(ii) Calculate the resistive force FR.

FR = ...................................................... N [2]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 10

5 A motor is used to move bricks vertically upwards, as shown in Fig. 5.1.

motor

bricks
container

Fig. 5.1

The bricks start from rest and accelerate for 2.0 s. The bricks then travel at a constant speed of
0.64 m s−1 for 25 s. Finally the bricks are brought to rest in a further 3.0 s.

The total mass of the bricks is 25 kg.

(a) Determine the change in kinetic energy of the bricks

(i) in the first 2.0 s,

change in kinetic energy = ...................................................... J [2]

(ii) in the next 25 s,

change in kinetic energy = ...................................................... J [1]

(iii) in the final 3.0 s.

change in kinetic energy = ...................................................... J [1]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 11

(b) The bricks are in a container. The weight of the container and bricks is 350 N.

Calculate, for the lifting of the bricks and container when travelling at constant speed,

(i) the gain in potential energy,

energy gain = ...................................................... J [3]

(ii) the power required.

power = ..................................................... W [2]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 12

6 Distinguish between melting and evaporation.

melting: .............................................................................................................................................

..........................................................................................................................................................

..........................................................................................................................................................

evaporation: ......................................................................................................................................

..........................................................................................................................................................

..........................................................................................................................................................
[4]

7 (a) A cell with internal resistance supplies a current. Explain why the terminal potential difference
(p.d.) is less than the electromotive force (e.m.f.) of the cell.

...................................................................................................................................................

...................................................................................................................................................

.............................................................................................................................................. [1]

(b) A battery of e.m.f. 12 V and internal resistance 0.50 Ω is connected to a variable resistor X
and a resistor Y of constant resistance, as shown in Fig. 7.1.

12 V 0.50 1

X Y

Fig. 7.1

The resistance R of X is increased from 2.0 Ω to 16 Ω. The variation with R of the current І in
the circuit is shown in Fig. 7.2.

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 13

3.0

I/A

2.0

1.0

0
0 2.0 4.0 6.0 8.0 10.0 12.0 14.0 16.0
R/1

Fig. 7.2

Calculate, for І = 1.2 A,

(i) the p.d. across X,

p.d. = ...................................................... V [2]

(ii) the resistance of Y,

resistance = ..................................................... Ω [3]

(iii) the power dissipated in the battery.

power = ..................................................... W [2]

(c) Use Fig. 7.2 to explain the variation in the terminal p.d. of the battery as the resistance R of X
is increased.

...................................................................................................................................................

.............................................................................................................................................. [1]
www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14 [Turn over
 14

8 (a) Explain how stationary waves are formed.

...................................................................................................................................................

...................................................................................................................................................

.............................................................................................................................................. [2]

(b) The arrangement of apparatus used to determine the wavelength of a sound wave is shown
in Fig. 8.1.

microphone
loudspeaker

metal plate

signal
generator c.r.o.

Fig. 8.1

The loudspeaker emits sound of one frequency. The microphone is connected to a cathode-ray
oscilloscope (c.r.o.).
The waveform obtained on the c.r.o. for one position of the microphone is shown in Fig. 8.2.

1.0 cm

1.0 cm

Fig. 8.2

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 15

The time-base setting of the c.r.o. is 0.20 ms cm−1.

(i) Use Fig. 8.2 to show that the frequency of the sound is approximately 1300 Hz.

[2]

(ii) Explain how the apparatus is used to determine the wavelength of the sound.

...........................................................................................................................................

...........................................................................................................................................

...........................................................................................................................................

...................................................................................................................................... [2]

(iii) The wavelength of the sound wave is 0.26 m. Calculate the speed of sound in this
experiment.

speed = ................................................ m s−1 [2]

www.egyptigstudentroom.com
© UCLES 2014 9702/21/O/N/14
 16

BLANK PAGE

Permission to reproduce items where third-party owned material protected by copyright is included has been sought and cleared where possible. Every
reasonable effort has been made by the publisher (UCLES) to trace copyright holders, but if any items requiring clearance have unwittingly been included, the
publisher will be pleased to make amends at the earliest possible opportunity.

Cambridge International Examinations is part of the Cambridge Assessment Group. Cambridge Assessment is the brand name of University of Cambridge Local

www.egyptigstudentroom.com
Examinations Syndicate (UCLES), which is itself a department of the University of Cambridge.

© UCLES 2014 9702/21/O/N/14