Ch8Problems

Topic 8 – Energy production Formative Assessment
PROBLEM SET NAME: ________________________________ TEAM:__

THIS IS A PRACTICE ASSESSMENT. Show formulas, substitutions, answers, and units!
Topic 8.1 – Energy sources
The following questions are about the Sankey diagram shown below.
1. What is the efficiency in going from chemical to potential energy?
2. What is the efficiency in going from chemical to kinetic energy?
3. What is the overall efficiency of the process?
The following questions are about Sankey diagrams and power generating schemes.
4. Draw a Sankey diagram for a coal-fired plant. Begin with coal, and end with electricity at the home.
5. Draw a Sankey diagram for a hydroelectric dam, from reservoir to home.
6. Draw a Sankey diagram for a wind turbine, from blades to home.
The following questions are about energy sources.

7. List the sun-derived energy sources. Circle the ones that produce CO2 during usage.
8. List the non-sun-derived energy sources. Circle the ones that produce CO2 during usage.
9. Outline and distinguish between renewable and non-renewable energy sources.
10. Make a key, and

shade in the energy
sources according to
their world usage.
11. Define the specific

energy and the
energy density of a
fuel.
12. Why is petroleum better than coal for powering a car?

13. Why is gas preferable a nuclear reactor for use in a locomotive?
14. Why is a nuclear reactor preferable to oil for use in a submarine?
The following questions are about fossil fuel energy production.

15. Suppose a steam locomotive is rated at 5000 horsepower. If its efficiency is 8%, how much wood
must be burned in a 2 hour trip? 1 hp = 750 W. Wood has an energy density of 17.0 MJ kg-1.
16. For the same problem find out how much coal having an energy density of 34.0 MJ kg-1 must be
burned?
A 50.0 MW coal-fired power station is proposed for a city. It is expected to have

an efficiency of about 17.5%, and use a coal with an energy density of 32.5 MJ
kg-1.
17. Calculate the mass of coal that must be burned per day to provide the
desired output power.
18. How many train cars per day are needed to keep this plant supplied with coal if each car holds 1.5
metric tons of coal?
19. If a nuclear power plant powered by uranium-235 has the same output and the same efficiency as
the coal-fired plant of the previous example, how many kg of nuclear fuel will it burn per year?
20. Describe the environmental problems associated with the recovery of fossil fuels and their use in
power stations.
The following questions are about nuclear power generation.

21. Distinguish between controlled nuclear and uncontrolled nuclear fission.
22. Describe what is meant by fuel enrichment and why it is necessary.
23. List two processes for enriching uranium.
24. Discuss the role of the moderator and the control rods in the production of controlled fission in a
thermal fission reactor.
25. Discuss the role of the heat exchanger in a fission reactor.
26. Discuss safety issues and risks associated with the production of nuclear power.
27. What type of nuclear reaction is this?
28. Describe how the neutrons in the reaction may initiate a chain reaction?
The following questions are about

hydroelectric power systems.
29. Why is a dam a good component in a
power grid?
30. Calculate the potential energy yield of this

hydroelectric scheme.
31. If the water flow rate is 25 m3 per second, what is the power provided by the moving water?
32. If the water is not replenished, how long can this reservoir produce power at this rate?
The following questions are about wind generators.

33. Outline the basic features of a wind generator.
34. Explain why it would be unwise to make a power grid having all wind generators.
A wind turbine has a blade length of 12.0 m. Before the air strikes the blades it has a
speed of 15.0 ms-1 and a density of 1.20 kg m-3. After passing through the blades, the
air has a speed of 5.75 ms-1 and a density of 1.35 kg m-3. The efficiency of the turbine is
18.5%.
35. Find the power carried by the air before striking the blades.
36. Find the power carried by the air after passing through the blades.
37. Find the power output generated by the wind turbine.
The following questions are about solar energy.

38. Outline reasons for seasonal and regional variations in the solar power incident per unit area of the
Earth’s surface.
39. The sun radiates energy at a rate of 3.901026 W. What is the rate at which energy from the sun
reaches Earth if our orbital radius is 1.501011 m?
A photovoltaic cell on a calculator has an area of 2.00 cm2 and an efficiency of 8.75%. The cell is placed in
a position where the sun's intensity is I = 850. W m-2.
40. What is the power output of the cell?
41. If the cell is rated at 0.500 V, what is its current output?
42. How many of the cells would you need to supply a current of 10.0 A? How would you connect the
cells?
The following questions are about solar heating panels.

43. Distinguish between a photovoltaic cell and a heating panel.
44. A solar heating panel has an efficiency of 40.0%. If the panel is placed in a position where the sun's
intensity is I = 850. W m-2over a 6.00-hour period of the day, and is required to raise the
temperature of 25.0 kg of water by 10.0° during that time, what must its area be? Recall the c =
4186 J kg-1 K-1.
Topic 8.2 - Thermal energy transfer

45. Describe the three mechanisms of thermal energy transfer.
46. The sun radiates energy at a rate of 3.901026 W. What is the rate at which
energy from the sun reaches Venus if its orbital radius is 108,000,000 km?
47. Define albedo and the factors that determine it. What is Earth’s overall albedo?
48. Describe the greenhouse effect.
The following questions are about the greenhouse gases.

49. Explain the molecular mechanisms by which greenhouse gases
absorb infrared radiation.
50. Rank (from highest to lowest in importance) the main five greenhouse gases which absorb thermal
(IR) radiation.
The following questions are about black-body radiation and the

Wien displacement law.
51. Sketch and label two black-body curves on the graph: One
for red light and one for blue light.
52. What is the wavelength of the maximum intensity radiation

emitted by a black-body that is at a temperature of 4750 K?
A sphere of radius 1.50 m is heated up to a temperature of 450. K.
53. Find the rate at which it should be emitting black-body radiation.
54. If the emissivity of the sphere is 0.500, what is the actual power being radiated by it?
An object is absorbing heat at a rate of 2.500 kW and radiating it at a rate of 2.200 kW.
55. What is its emissivity?
The following two questions refer to this energy model .
56. In this energy model show that the total energy

being absorbed by the greenhouse gases is equal
to the total energy being radiated by them.
57. This model shows a stable temperature for Earth

as a whole, the atmosphere, and the ground.
What evidence is there to justify this statement?
The following question refers to this energy model.
58. This model shows an unstable temperature.

What evidence is there to justify this statement.
An empty aquarium has 3 kg of water added each second, and 5%

of the total water removed each second.
59. Create a spreadsheet (or do calculations by hand) to determine

what the mass will be when the aquarium reaches equilibrium.

Ch8Problems

Uploaded by

Copyright:

Available Formats

Ch8Problems

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Ch8Problems

Uploaded by

Copyright:

Available Formats

Topic 8 – Energy production Formative Assessment

PROBLEM SET NAME: ________________________________ TEAM:__

1. What is the efficiency in going from chemical to potential energy?

2. What is the efficiency in going from chemical to kinetic energy?

3. What is the overall efficiency of the process?

5. Draw a Sankey diagram for a hydroelectric dam, from reservoir to home.

6. Draw a Sankey diagram for a wind turbine, from blades to home.

The following questions are about energy sources.

9. Outline and distinguish between renewable and non-renewable energy sources.

10. Make a key, and

11. Define the specific

12. Why is petroleum better than coal for powering a car?

14. Why is a nuclear reactor preferable to oil for use in a submarine?

The following questions are about fossil fuel energy production.

A 50.0 MW coal-fired power station is proposed for a city. It is expected to have

The following questions are about nuclear power generation.

22. Describe what is meant by fuel enrichment and why it is necessary.

23. List two processes for enriching uranium.

25. Discuss the role of the heat exchanger in a fission reactor.

The following questions are about

30. Calculate the potential energy yield of this

The following questions are about wind generators.

37. Find the power output generated by the wind turbine.

The following questions are about solar energy.

41. If the cell is rated at 0.500 V, what is its current output?

The following questions are about solar heating panels.

Topic 8.2 - Thermal energy transfer

48. Describe the greenhouse effect.

The following questions are about the greenhouse gases.

The following questions are about black-body radiation and the

52. What is the wavelength of the maximum intensity radiation

The following two questions refer to this energy model .

56. In this energy model show that the total energy

57. This model shows a stable temperature for Earth

The following question refers to this energy model.

58. This model shows an unstable temperature.

An empty aquarium has 3 kg of water added each second, and 5%

59. Create a spreadsheet (or do calculations by hand) to determine

You might also like

PROBLEM SET NAME: ______________________________ TEAM: