WWW.AliFixit.

COM
7. Level 2 Repair

7-1. Components on the Rear Case

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

7-2. Pre-requisite

Tweezers / Disass'y Stick / Screw Driver Anti-static Gloves

Anti-static Mat Hot Plate

A OCTA Disassembly Holder OCTA Disassembly Upper

Ethyl Alcohol Cotton Swab

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

7-3. Parts which must be changed after repair

BOM description & part code KIT CODE Image Remarks

A/S-SVC BACKGLASS
OUTSIDE TAPE

[GH81-16446A]

A/S-SVC CAM SEALING

TAPE (Common) Replace for
[GH82-18800A]]
[GH02-17475A] Back Glass

Mic sealing tape

[GH02-07406A]

※ 3 Screws on the PBA

3 screws for PBA cannot be reused, replace

[6001-003360] the new 3 screws after

removing the 3 screws.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

7-4. Disassembly

1 Put the device in the chamber as following 2 Detach the Back Glass.
below heating condition
Detach the left side of Back glass
- SOC 68%↓: 70℃/10~20 minute
- SOC 68%↑: 60℃/10~20 minute
※ Please confirm the heating condition
released lastly, and follow it.

※ Caution ※ Caution
Be care of scratch. Be care of scratch.

3 Unscrew 15 Point and disassemble SIM Tray

from device. 4 Disassemble Upper Rear.
(Use disassemble hole left/right side of Rear to
detach it)

Rear Top disassemble hole.

※ Caution
※ Caution 1) Be care of scratch.
Be care of Rear damage. 2) Be care of Rear and connector damage.
3) Be care of NFC ANT damage.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

Finally Disassemble Rear of bottom side. 6 Unscrew PBA 3points.

5
(Use disassemble hole right side of Rear to
detach it)

※ Caution ※ Caution
1) Be care of scratch. 1) Be careful not to damage the PBA.
2) Be care of Rear and connector damage. 2) 3 Screws on the PBA cannot be reused, replace the new 3
3) Be careful not to damage the PBA. screws after removing the 3 screws.

7 Detach Battery connect and the other 8 Disassemble the PBA.

connectors. (4 Point) 1) Lift the PBA using the right disassembly hole.
2) Separate the PBA from the top.

※ Caution
※ Caution
1) Be care of scratch.
Be care of several kinds of damage
2) Be care of connector damage.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

10 Disassemble the Ear jack

9 Disassemble SUB Camera.
Separate the Ear jack using the Ear jack
Disassemble Main Camera.
disassembly hole.

※ Caution ※ Caution
Be careful not to damage the CAM. Be care of Ear jack connector FPCB damage.

11 Detach other components.

Put the device in the chamber as following
below heating condition.
- 70℃±5℃, 10 minutes

※ Caution
Be care of scratch.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

7-5. Assembly
1 Assemble the Main Cam. 2 Attach components on Front.
Assemble each of Main Camera Connector (RCV, Motor)
2 Points based on the PBA Connector.

※ Caution
※ Caution
1) Assemble it without Connector mold crushed
Be care of chip damage nearby screw point.
2) Check MAIN CAMERA connector (insertion/no insertion)

3 Assemble the PBA into the front. 4 Assemble the Earjack.

1) Temporarily place PB’s USB/bottom, right 1) Insert the Earjack diagonally.
C-CILP by putting them diagonally into the 2) Insert so that there is a clap.
Front, and place them by pressing the back 3) Connect the Earjack connector.
of USB terminal.
2) Check USB’s left/right Holes match Boss
Tap Hole
3) Connect the battery connector and the UB
connector.

※ Caution
1) When assembling the PBA to the front, Be careful not to ※ Caution
touch IF bottom chip. Be careful of damage of Connector.
2) Be careful that C-CLIP located on the top is not damaged.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

5 Connect the SUB camera. Use a manual assembler to assemble the

6
1) place the body tube and then assemble screw at the PBA 3 point.
Connector to PBA. ※ Torque Value : 1.3kgf±7%
2) When Connector is assembled without PBA (1.2~1.4, 3M Patch)
fixed to Front Assy, Connector could be
crushed/damaged

※ Caution ※ Caution
When assembling Connector, be careful of cracks of chip 1) Be care of scratch and REAR damage
around. 2) Check for contact damage.(red area)
`
7 Assemble REAR BTM(SPEAKER)’s bottom 8 Assemble REAR Top. Place(at an angle) and
1) Place REAR BTM’s bottom at an angle to assemble REAR TOP’s top Hook (Gently)
assemble HOOK 1) Assemble REAR TOP’s left Hook.
2) Assemble left HOOK(SPK SUS’s left) 2) Assemble REAR TOP’s right Hook.
3) Assemble right Hook.

※ Caution
1) When placing SPK, be careful of Hook’s falling out. Check if ※ Caution
Hook comes off after assembling Hook. 1) Don’t assemble HOOK forcefully with HOOK not inserted!
2) Don’t forcefully assemble Hook when it came off (could HOOK break, crush can happen)
damage Hook). 2) When assembling REAR ASSY, no crush, dent, scratches
3) During SPEAKER’s assembly, no Battery crush, dent, on Battery.
scratches.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM
 WWW.AliFixit.COM
7. Level 2 Repair

9 Screw 15 Point and disassemble SIM Tray 10 Remove B/G Mega, B/G Tape’s release paper
from device. from the back of Backglass
※Torque Value : 1.3kgf±7%

※ Caution ※ Caution
Be care of Rear damage. After removing release paper, no defect like Tape tilt/jamming

11 Attach the backglass. 12 Press Back Glass.

Pressing force : 1N
Pressing time : 60 seconds

※ Caution ※ Caution
Be care of scratch and tilt. Be care of scratch.

Confidential and proprietary-the contents in this service guide subject to change without prior notice
Distribution, transmission, or infringement of any content or data from this document without Samsung’s written authorization is strictly prohibited.

WWW.ALISALER.COM