Bac06 Series (BAC06A/BAC06V) Switch-Type Battery Charger: User Manual
Bac06 Series (BAC06A/BAC06V) Switch-Type Battery Charger: User Manual
(BAC06A/BAC06V)
USER MANUAL
CONTENTS
1 OVERVIEW ................................................................................................ 4
2 PERFORMANCE AND CHARACTERISTICS ............................................. 4
3 CHARGING PRINCIPLE ............................................................................ 4
4 SPECIFICATION ........................................................................................ 5
5 SETTING .................................................................................................... 5
5.1 VOLTAGE ADJUSTMENT ......................................................................... 5
5.2 CURRENT ADJUSTMENT........................................................................ 5
6 OPERATION ................................................................................................... 5
7 CASE DIMENSIONS .................................................................................. 7
8 ORDER INFORMATION ............................................................................. 8
According to charging property of the lead-acid battery, BAC06V battery charger uses 2-stage
charging method and charge mode is “constant-current”. When battery voltage is under the
threshold, it is charging in constant-current mode; when the battery voltage is higher than the
threshold,the charging current is decreasing as the battery voltage is rising until it reaches the
set voltage, and then charge mode is turned into “floating charge”. Charge current is gradually
reducing and battery voltage is rising up to the set value. When charging current is lower than
0.3A, the battery is basically fully charged (charging indicator eliminates). Afterwards, charging
current will offset self-discharge of the battery. Thus the charger can maintain a full charged
condition and extend the battery life.
5 SETTING
5.1 VOLTAGE ADJUSTMENT
When adjusting the voltage on the spot, disconnect the battery from the charger, and then
measure the output voltage of the charger while adjusting voltage potentiometer (VOLT) to a
proper value.
5.2 CURRENT ADJUSTMENT
Connect battery output firstly. When battery voltage is under 25.0V (12.5V), adjust the
current potentiometer (AMP) and set proper charge current. Output current can also be
estimated according to the current potentiometer, which is recommended.
6 OPERATION
Chart 2. BAC06A
Chart 3. BAC06V
Note:
1) Because there is diode and current-limiting circuit inner the charger, it can be used together
with charging generator, and there is no need to disconnect the charger when cranking.
2) During genset is running, high current will cause voltage drop in charging line, so
recommend separately connecting to battery terminal to avoid disturbance on sampling
precision.