Power Electronics Lab Assignment-XII: Objective
Power Electronics Lab Assignment-XII: Objective
Power Electronics Lab Assignment-XII: Objective
OBJECTIVE:
Simulation and Analysis of Three Phase Half Wave Fully Controlled AC-DC Converter.
COMPONENTS REQUIRED:
MATLAB Simulink.
SETTING UP SIMULATION:
SIMULINK MODEL:
SCOPE OUTPUT:
Fig: 3.8: Scope Output for 3 Ф Half Wave Rectifier Simulation (α = 0).
Power Electronics Lab Assignment-XII
Fig: 3.9: Scope Output for 3 Ф Half Wave Rectifier Simulation (α = 30).
Fig: 3.10: Scope Output for 3 Ф Half Wave Rectifier Simulation (α = 60).
Power Electronics Lab Assignment-XII
Student Task:
1. Simulate the configuration for all angles (0, 30, 60, and 90) and plot source signal, output
voltage and output current for load R and RL. Set R=20Ω and L=50mH.
2. Figure below shows a battery charging circuit using SCRs. The input voltage from neutral
to any line is 230V V(rms) and firing angle for thyristor is 30 0 . Find the average current
flowing through the battery. (Iavg= 19.95A).